1
33
INSTRUMENTS and CONTROLS
   
 
Warning lamp 
 
   
 
is on 
 
   
 
Cause 
 
   
 
Action/Observations 
 
 
   
 
    
 
Front 
foglamps 
 
    
fi xed.    The front foglamps are 
switched on.   Turn the ring on the stalk rearwards twice to 
switch off the front foglamps. 
   
 
    
 
Rear 
foglamps 
 
    
fi xed.    The rear foglamps are 
switched on.   Turn the ring on the stalk rearwards to switch off 
the rear foglamps. 
   
 
    
 
Diesel engine 
pre-heating 
 
    
fi xed.    The ignition switch is at the 
2nd position (ignition on).  
Wait until the warning lamp has switched off before starting. 
  The duration for which the warning lamp is on is 
determined by the climatic conditions. 
    
 
 
Stop & Start 
 
    
fi xed.    When the vehicle stops (red 
lights, traffi c jams, ...) the 
Stop & Start system has 
put the engine into STOP 
mode.   The warning lamp goes off and the engine 
restarts automatically in START mode, as soon 
as you want to move off. 
   
fl ashes for a 
few seconds, 
then goes off.    STOP mode is temporarily 
unavailable. 
  or 
  START mode is invoked 
automatically.   Refer to "Driving - § Stop & Start" for special 
cases with STOP mode and START mode.     
 
    
 
Dipped beam 
headlamps 
 
    
fi xed.    The lighting stalk is in the 
"Dipped beam headlamps" 
position or in the "AUTO" 
position in conditions of low 
light.    
   
 
    
 
Main beam 
headlamps 
 
    
fi xed.    The lighting stalk is pulled 
towards you.   Pull the stalk again to return to dipped beam 
headlamps.   
8
!
i
i
128
DRIVING
   
 
 
 
 
 
 
 
STOP & START 
 
The Stop & Start system puts the en-
gine temporarily into standby - STOP 
mode - during stops in the traffi c  (red 
lights, traffi c jams, etc...). The engine 
restarts automatically - START mode - 
as soon as you want to move off. The 
restart takes place instantly, quickly and 
silently. 
  Perfect for urban use, the Stop & Start 
system reduces fuel consumption and 
exhaust emissions as well as offering 
the comfort of silence when stationary. 
   
Operation 
 
 
Going into engine STOP mode 
  The  "ECO" 
 warning lamp comes 
on in the instrument panel and 
the engine goes into standby: 
   
 
-   with a manual gearbox 
, at speeds 
below 12 mph (20 km/h), when you 
put the gear lever into neutral, and 
you release the clutch pedal.  
  A time counter calculates 
the sum of the periods in 
STOP mode during a jour-
ney. It rests itself to zero 
every time the ignition is 
switched on with the key.   For your comfort when parking, 
STOP mode is not available for a 
few seconds after coming out of re-
verse gear. 
  STOP mode does not affect the 
functionality of the vehicle, such 
as braking, power steering, for ex-
ample. 
  Never refuel with the engine in 
STOP mode; you must switch off 
the ignition with the key.     
Special cases: STOP mode 
unavailable 
  STOP mode is not invoked when: 
   
 
-   the driver's door is open, 
   
-   the driver's seat belt is not fas-
tened, 
   
-   the vehicle has not exceeded 6 mph 
(10 km/h) since the last engine start 
using the key, 
   
-   the engine is needed to maintain a 
comfortable temperature in the pas-
senger compartment, 
   
-   demisting is active, 
   
-   some special conditions (battery 
charge, engine temperature, brak-
ing assistance, ambient tempera-
ture...) where the engine is needed 
to assure control of a system.  
  The  "ECO" 
 warning lamp fl ash-
es for a few seconds, then goes 
off. 
   
This operation is perfectly normal. 
 
     
 
In STOP mode of Stop & Start, the 
"AIRWAVE" system stops working.