2011 MITSUBISHI LANCER SPORTBACK clock

Vehicle care and maintenance
7-67
7
Daytime running lights (for vehicles equipped
with high intensity discharge headlights)
N00900300086
1. When replacing the bulb on the front passenger’s side,
remove the bolt (A) holding down the washer tank spout
and move the spout toward the rear of the vehicle.2. Turn the cap (B) counterclockwise to remove it.*- Front of the vehicle
*- Front of the vehicle
BK0125300US.book 67 ページ ２０１０年５月１８日　火曜日　午後１時５３分

7-68 Vehicle care and maintenance
7
3. Turn the socket (C) counterclockwise to remove it. 4. Turn the bulb counterclockwise while pressing it and pull
it out of the socket.
5. To install a bulb, perform the removal steps in reverse.*- Front of the vehicle
BK0125300US.book 68 ページ ２０１０年５月１８日　火曜日　午後１時５３分

7-70 Vehicle care and maintenance
7
2. For vehicles equipped with turbocharger, when replacing
the bulb on the passenger’s side, lift up the engine coolant
reservoir (B).3. Turn the socket (C) counterclockwise to remove it.*- Front of the vehicle
*- Front of the vehicle
BK0125300US.book 70 ページ ２０１０年５月１８日　火曜日　午後１時５３分

7-72 Vehicle care and maintenance
7
3. Turn the socket (D) counterclockwise to remove it.
4. Pull the bulb out of the socket.
Vehicles with
turbochargerBK0125300US.book 72 ページ ２０１０年５月１８日　火曜日　午後１時５３分

7-74 Vehicle care and maintenance
7
2. Remove the entire socket and bulb assembly (E) by turn-
ing it counterclockwise.
Vehicles with turbocharger
*- Front of the vehicle
BK0125300US.book 74 ページ ２０１０年５月１８日　火曜日　午後１時５３分

Vehicle care and maintenance
7-77
7
3. Push the connector (D) to disconnect and remove the fog
light. 4. Remove the bulb assembly (E) by turning it counterclock-
wise.
5. To install the bulb, perform the removal steps in reverse.
BK0125300US.book 77 ページ ２０１０年５月１８日　火曜日　午後１時５３分

Vehicle care and maintenance
7-81
7
4. Push the connector (D) to disconnect and remove the fog
light.5. Remove the bulb assembly (E) by turning it counterclock-
wise.
BK0125300US.book 81 ページ ２０１０年５月１８日　火曜日　午後１時５３分

Vehicle care and maintenance
7-83
7
Rear combination lights
N00943700429
Tail and stop lights, rear turn signal lights and rear
side-marker lights1. Insert a screwdriver at the edge of the cover and pry gen-
tly to remove the cover. NOTE
Wrap a cloth around the tip of the screwdriver to keep
from scratching the cover.2. Remove the socket and bulb assemblies by turning them
counterclockwise.
A- Rear side-marker light
B- Rear turn signal light
C- Tail and stop light
BK0125300US.book 83 ページ ２０１０年５月１８日　火曜日　午後１時５３分