2011 LEXUS RX350 lock

139
1-7. Safety information
1

Before driving
Replace the head restraint and lift
it up to the uppermost lock posi-
tion.
STEP3
nLaws and regulations pertaining to anchors
The LATCH system conforms to FMVSS225 or CMVSS210.2.
Child restraint systems conforming to FMVSS213 or CMVSS213 specifications
can be used.
This vehicle is designed to conform to the SAE J1819.
CAUTION
nWhen installing a booster seat
To prevent the belt from going into ALR lock mode, do not fully extend the shoulder
belt. ALR mode causes the belt to tighten only. This could cause injury or discom-
fort to the child. (→P. 7 8 )

141
1-7. Safety information
1

Before driving
CAUTION
nWhen installing a child restraint system
lEnsure that the belt and tab are securely locked and the seat belt is not twisted.
lPush and pull the child restraint system from side to side and forward to be sure it
is secure.
lAfter securing a child restraint system, never adjust the seat.
lFollow all installation instructions provided by the child restraint system manufac-
turer.
nDo not use a seat belt extender
If a seat belt extender is used when installing a child restraint system, the seat belt
will not securely hold the child restraint system, which could cause death or serious
injury to the child or other passengers in the event of sudden braking, sudden
swerving or an accident.
nTo correctly attach a child restraint system to the anchors
When using the LATCH anchors, be sure that there are no foreign objects around
the anchors and that the seat belt is not caught behind the child restraint system.
Make sure the child restraint system is securely attached, or it may cause death or
serious injury to the child or other passengers in the event of a sudden stop, sudden
swerve or accident.

144
2-1. Driving procedures
Driving the vehicle
Starting off on a steep uphill
Make sure that the parking brake is set and shift the shift lever to
D.
Gently depress the accelerator pedal.
Release the parking brake.
The following procedures should be observed to ensure safe driving.
nStarting the engine
→P. 1 5 3
nDriving
With the brake pedal depressed, shift the shift lever to D.
(→P. 1 5 9 )
Release the parking brake. (→P. 164)
Gradually release the brake pedal and gently depress the
accelerator pedal to accelerate the vehicle.
nStopping
With the shift lever in D, depress the brake pedal.
If necessary, set the parking brake.
If the vehicle is to be stopped for an extended period of time, shift the
shift lever to P or N. (→P. 1 5 9 )
n Parking the vehicle
With the shift lever in D, depress the brake pedal.
Set the parking brake. (→P. 1 6 4 )
Shift the shift lever to P. (→P. 1 5 9 )
If parking on a hill, block the wheels as needed.
Press the “ENGINE START STOP” switch to stop the engine.
Lock the door, making sure that you have the electronic key on
your person.
STEP1
STEP2
STEP3
STEP1
STEP2
STEP1
STEP2
STEP3
STEP4
STEP5
STEP1
STEP2
STEP3

156
2-1. Driving procedures
nIf the engine does not start
The engine immobilizer system may not have been deactivated. (→P. 1 0 1 )
nSteering lock
After turning the “ENGINE START STOP” switch off and opening and closing the
doors, the steering wheel will be locked due to the steering lock function. Operat-
ing the “ENGINE START STOP” switch again automatically cancels the steering
lock.
nWhen the steering lock cannot be released
nSteering lock motor overheating prevention
To prevent the steering lock motor from overheating, the motor may be suspended
if the engine is turned on and off repeatedly in a short period of time. In this case,
refrain from operating the engine. After about 2 seconds, the steering lock motor
will resume functioning.
nWhen the “ENGINE START STOP” switch indicator flashes in amber
The system may be malfunctioning. Have the vehicle inspected by your Lexus
dealer immediately.
nIf the electronic key battery is depleted
→P. 4 9 6
The green indicator light on the “ENGINE
START STOP” switch will flash and a mes-
sage will be shown on the multi-information
display. Press the “ENGINE START STOP”
switch again while turning the steering wheel
left and right.

157
2-1. Driving procedures
2

When driving
CAUTION
nWhen starting the engine
Always start the engine while sitting in the driver’s seat. Do not depress the acceler-
ator pedal while starting the engine under any circumstances.
Doing so may cause an accident resulting in death or serious injury.
nCaution while driving
If the vehicle begins to slide due to engine failure or other circumstances, do not
lock or open the doors until the vehicle reaches a safe and complete stop. Activa-
tion of the steering lock in this circumstance may lead to an accident, resulting in
death or serious injury.
nStopping the engine in an emergency
If you want to stop the engine in an emergency while driving the vehicle, press and
hold the “ENGINE START STOP” switch for more than 3 seconds.
However, do not touch the “ENGINE START STOP” switch while driving unless in
an emergency. If the engine stops while driving, this could lead to an accident.

170
2-2. Instrument cluster
nIndicators
The indicators inform the driver of the operating state of the vehi-
cle’s various systems.
Turn signal indicator
(→P. 1 6 3 )
(if equipped)
Intuitive parking assist
indicator (→P. 2 2 0 )
Headlight high beam indi-
cator (→P. 1 8 6 )

(if equipped)
“AFS OFF” indicator
(→P. 1 8 6 )

(if equipped)
Automatic High Beam
indicator (→P. 1 8 9 )
Slip indicator
(→P. 232)

(U.S.A.)
Headlight indicator
(→P. 1 8 4 )
VSC off indicator
(→P. 2 3 3 )

(Canada)
Tail light indicator
(→P. 1 8 4 )
(AWD models
only)
All-wheel drive lock indi-
cator (→P. 2 3 7 )
Front fog light indicator
(→P. 1 9 5 )
“ECT SNOW” indicator
(→P. 1 6 0 )
Cruise control indicator
(→P. 204, 208)

(if equipped)
Radar cruise control indi-
cator (→P. 2 0 8 )
*1
*1*1, 2
*1
*1

175
2-2. Instrument cluster
2

When driving
Electronic features control contentsSetting electronic features controls
Intuitive parking assist
(if equipped)→P. 220
Snow mode→P. 1 6 0
AFS (if equipped)→P. 1 8 6
Other contentsDetails
Outside temperature Displays the outside temperature
Dynamic radar cruise control display
(if equipped) (→P. 2 0 8 )
Automatically displayed when using
dynamic radar cruise control
Customization (→P. 6 2 1 )
Settings of functions such as the
door lock and light illumination time
can be changed
Wa r n i n g m e s s a g e (→P. 545)
Automatically displayed when a mal-
function occurs in one of the vehi-
cle's systems

187
2-3. Operating the lights and windshield wipers
2

When driving
Press the “ENTER” switch to
change to “OFF”.
The “AFS OFF” indicator will be
displayed.
Each pressing of the switch turns
“A F S ” o n a n d o f f .
Press the menu switch to change to
the normal display.
STEP2
nDaytime running light system
lTo make your vehicle more visible to other drivers, the daytime running lights
turn on automatically whenever the engine is started and the parking brake is
released. Daytime running lights are not designed for use at night.
For the U.S.A.: Daytime running lights can be turned off by operating the switch.
lCompared to turning on the headlights, the daytime running light system offers
greater durability and consumes less electricity, so it can help improve fuel
economy.
nHeadlight control sensor
The sensor may not function properly if an
object is placed on the sensor, or anything
that blocks the sensor is affixed to the wind-
shield.
Doing so interferes with the sensor detecting
the level of ambient light and may cause the
automatic headlight system to malfunction.