2011 JEEP GRAND CHEROKEE hood release

•The seat will move to the position located
0.3 in (8 mm) forward of the rear stop if the
starting position is between 0.9 to 2.67 in (23
to 68 mm) forward of the rear stop when the
key is removed from the ignition switch. The
seat will move forward to the memory/driving
position when the key is placed into the
ignition, and turned out of the LOCK position
toward the ACC/ON position.
The Easy Entry/Exit feature will be automatically
disabled if the seat is already positioned closer
than 0.9 in (23 mm) forward of the rear stop. At
this position, there is no benefit to the driver by
moving the seat for Easy Exit/Entry.
Each stored memory setting will have an asso-
ciated Easy Entry/Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled
when the vehicle is delivered from the fac-
tory. The Easy Entry/Exit feature is enabled
(or later disabled) through the programmable
features in the Electronic Vehicle Information
Center (EVIC). Refer to “Electronic Vehicle
Information Center (EVIC)/Customer- Pro- grammable Features” in “Understanding
Your Instrument Panel” for further informa-
tion.
TO OPEN AND CLOSE THE HOODTo open the hood, two latches must be re-
leased.
1. Pull the release lever located below the
instrument panel and in front of the driver’s
door.
2. Reach under the hood, move safety latch to
the left and lift the hood.
CAUTION!
To prevent possible damage, do not slam the
hood to close it. Use a firm downward push at
the center of the hood to ensure that both
latches engage.
Hood Release
Safety Latch Location
105

INSTRUMENT PANEL FEATURES
1 — Air Outlet 5 — Climate Controls 9 — Fuel Door Release
2 — Instrument Cluster 6 — Lower Switch Bank 10 — Headlight Switch
3 — Radio 7 — Storage Bin 11 — Hood Release
4 — Glove Compartment 8 — Ignition Switch
156

attention should also be given to hood latching
components to ensure proper function. When
performing other underhood services, the hood
latch, release mechanism and safety catch
should be cleaned and lubricated.
The external lock cylinders should be lubri-
cated twice a year, preferably in the Fall and
Spring. Apply a small amount of a high quality
lubricant, such as MOPARLock Cylinder Lu-
bricant or equivalent directly into the lock cyl-
inder.
Windshield Wiper BladesClean the rubber edges of the wiper blades
and the windshield periodically with a sponge
or soft cloth and a mild nonabrasive cleaner to
remove accumulations of salt or road film.
Operation of the wipers on dry glass for long
periods may cause deterioration of the wiper
blades. Always use washer fluid when using
the wipers to remove salt or dirt from a dry
windshield.
Avoid using the wiper blades to wipe frost or
ice from the windshield. Keep the blade rubber
out of contact with petroleum products such as
engine oil, gasoline, etc. NOTE:
Life expectancy of wiper blades varies de-
pending on geographical area and fre-
quency of use. Poor performance of blades
may be present with chattering, marks, wa-
ter lines or wet spots. If any of these condi-
tions are present, clean the wiper blades or
replace as necessary.
Adding Washer FluidThe fluid reservoir for the windshield washers
and the rear window washer is shared. The fluid
reservoir is located in the engine compartment,
be sure to check the fluid level at regular
intervals. Fill the reservoir with windshield
washer solvent only (not radiator antifreeze).
When refilling the washer fluid reservoir, take
some washer fluid and apply it to a cloth or
towel and wipe clean the wiper blades, this will
help blade performance. To prevent freeze-up
of your windshield washer system in cold
weather, select a solution or mixture that meets
or exceeds the temperature range of your cli-
mate. This rating information can be found on
most washer fluid containers.
WARNING!
Commercially available windshield washer
solvents are flammable. They could ignite and
burn you. Care must be exercised when filling
or working around the washer solution.
Exhaust SystemThe best protection against carbon monoxide
entry into the vehicle body is a properly main-
tained engine exhaust system.
If you notice a change in the sound of the
exhaust system; or if the exhaust fumes can be
detected inside the vehicle; or when the under-
side or rear of the vehicle is damaged; have an
authorized technician inspect the complete ex-
haust system and adjacent body areas for
broken, damaged, deteriorated, or misposi-
tioned parts. Open seams or loose connections
could permit exhaust fumes to seep into the
passenger compartment. In addition, inspect
the exhaust system each time the vehicle is
raised for lubrication or oil change. Replace as
required.
278

Gas Cap (Fuel Filler Cap)....242,244,273
Gasoline, Clean Air ............241
Gasoline (Fuel) ...............240
Conserving ...............171
Gauges Coolant Temperature ..........163
Fuel ....................162
Speedometer ..............162
Tachometer ...............158
Gear Ranges ................206
General Information ........15,19,239
Glass Cleaning ...............289
Gross Axle Weight Rating .........244
Gross Vehicle Weight Rating .......244
Hands-Free Phone (uconnect ) ......74
Hazard Warning Flasher .........258
Headlights .................293
Bulb Replacement ...........294
Cleaning .................289
On With Wipers .............107
Replacing ................294
Heated Mirrors ...............68
Heater ...................186
High Beam Indicator ...........159
Hill Descent Control ............228 Hill Descent Control Indicator
......159
Hill Start Assist ...............227
Holder, Cup ................146
Hood Release ...............105
Ignition ....................13
Key ................... 12,13
Ignition Key Removal ............13
Illuminated Entry ..............16
Immobilizer (Sentry Key) ..........14
Infant Restraint .............. 46,48
Inflation Pressure Tires ..........230
Information Center, Vehicle ........163
Inside Rearview Mirror ...........67
Instrument Cluster .............158
Instrument Panel and Controls ......156
Instrument Panel Lens Cleaning .....289
Integrated Power Module (Fuses) ....290
Interior Appearance Care .........288
Intermittent Wipers (Delay Wipers) ....113
Introduction ..................4
Jack Location ...............259
Jack Operation ............ 259,260
Jacking Instructions ............260
Jump Starting
...............262 Key, Programming
.............15
Key, Replacement ..............14
Key, Sentry (Immobilizer) ..........14
Key-In Reminder ..............14
Keyless Entry System ............17
Keyless Go ............... 12,174
Keys .....................12
Lap/Shoulder Belts .............29
LATCH (Lower Anchors and Tether for
CHildren) ................. 50,51
Latches ...................57
Lead Free Gasoline ............240
Leaks, Fluid .................57
Liftgate ....................26
Liftgate Flipper Glass ............26
Liftgate Window Wiper/Washer ......150
Light Bulbs ..................57
Lights .................. 57,106
Airbag ............. 41,45,56,158
Anti-Lock .................162
Automatic Headlights ..........106
Back-Up .................295
Brake Assist Warning ..........229
Brake Warning ..............161
Bulb Replacement ...........293
339