2
Vehicle access\bEngine starting
Jaguar Smart Key
Keyless entry
Leaving the vehicle
The vehicle WILL NOT automatically lock or arm
the alarm.
To lock and alarm the vehicle with a keyless action
the Jaguar Smart Key must be outside the vehicle.
Press the door handle button once to single\block.
Alternatively, use the Jaguar Smart Key.
Entering the vehicle
With keyless entry, operation of a locked door
handle or pressing the trunk release button will
allow access if the Jaguar Smart Key is within
approximately 39
inches (\fm) of that
entry point.
The Jaguar Smart
Key buttons do not
need to be pressed and it can be concealed in
clothing or even carried in a non metallic carrier.
The Jaguar Smart Key buttons can still be used
to unlock the vehicle.
Drive away door locking
When enabled, the trunk and doors will
automatically lock when the vehicle's forward
speed exceeds 5 mph (7 km/h).
This feature can be disabled/enabled via the
touch\bscreen. From the
Homescreen, select
Vehicle, then Veh. settings, thenSecurity.
Unlocking mode alternatives
Single point entry will disarm the alarm and
unlock only the driver’s door with a single press. A
second press unlocks the passenger door and
trunk.
Multi point entry will disarm the alarm and unlock
both doors and trunk with a single press.
To change between modes, press the lock and
unlock buttons simultaneously for three seconds.
The hazard lamps will flash twice to confirm the
change.
• Press once to lock the vehicle and arm the alarm.
• Press and hold to close any open windows (Global closing if enabled).
• Press once to disarm the alarm, unlock both doors and unlock the trunk.
• Press and hold to open the windows (Global opening if enabled) .
• Press once to switch the headlamps on for 25 seconds. Press again to
switch off.
• Press to disarm the alarm and unlock the trunk.
• Press and hold or press three times in three seconds to activate/cancel the
panic alarm .
1.Emergency key blade release button.
2. Emergency key blade.
Note: See the Owner’s Handbook for use.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:23 Page 2
8
Driving
Exterior lighting\bTrip computer
1. Front screen wash/wipe.
2. AUTO/intermittent wipe.
\f. Slow speed.
4. Fast speed.
5. With position2selected, rotate the collar to
adjust speed of intermittent wipe or rotate to
AUTO to select auto wipe controlled by the
rain sensor.
Wipers and washers
Move the lever forward for high beam and back
for high beam flash. Move it up or down to
operate the direction indicators. A brief push up
or down will flash the indicators three times.
Rotate the collar to the first position to select
side lamps.
Second position is headlamps.
Next position is Autolamps. Sensor controlled
to switch side lamps and low beam
headlamps on or off as appropriate.
Autolamps combined with exit delay.
Headlamps can remain on to illuminate the
immediate vicinity for a set period after
leaving the vehicle. There are three time
setting positions. Press the button on the end of the lever to
cycle through the trip computer displays in
the message center.
Autolamps
If AUTO mode is selected and the front screen
wipers are operated for more than 20 seconds, the
exterior lamps will be switched ON automatically
for a minimum of two minutes.
Instrument pack warning lamps
Low tire pressure
Air bag fault
Rear fog lamp on
Flashing lamp \b
Dynamic Stability
Control (DSC) activeSeat belt reminder
Forward alert active
Automatic Speed Limiter
(ASL) active
ABS fault
Parking brake on or
system fault \b Canada
only
Parking brake on or
system fault \b USA only
Adaptive Cruise Control
active
Engine malfunction
The following lamps will illuminate during normal driving to indicate that a related system or feature is
operating. If any other warning lamp illuminates, refer to the Owner’s Handbook.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:23 Page 81
2
3
4
5 BRAKE
