Operating note
To prevent automatic movement of the steering
column, turn the control to theCOLUMNposition.
4
Comfort adjustments
Steering column adjustment
Steering wheel adjustment
• Turn the control to COLUMNthen move the
control to adjust the height and reach.
Exit mode
• With the control set to AUTO, the steering column will move to provide greater clearance
for exiting when the driver's door is opened.
Entry mode
After the driver's door is closed and the START
STOP button is pressed the column will return to
its previous position.
Seat adjustment
Seat adjustment may vary dependent upon
vehicle specification.
The control panel is on the door.
1. Cushion extension. Forward and back.
2. Lumbar support. 4 way switch \b Up inflates upper lumbar, Down inflates lower lumbar,
Forward inflates both lumbars and Back
deflates both lumbars.
\f. Recline adjustment. Forward and back.
4. Side bolster adjustment. Rotate to adjust in or out.
5. Cushion height \b front of switch, cushion front tilt \b rear of switch.
Operating note
The controls for seat heating and cooling are
accessed via the touch\bscreen.
Door mirrors adjustment
Door mirror adjustment
1.Press to select a mirror.
2. Use to adjust the mirror position.
Powerfold mirrors
• Press both buttons 1simultaneously to fold the mirrors
inward. Press again to unfold.
The mirrors can be programmed to unfold/fold automatically
at vehicle unlock/lock. See your Owner’s Handbook.
Mirror dip when reversing
Reverse dip can be enabled or disabled via the touch screen.
From the Homescreen, select Vehicle, thenVeh. settings,
then Parking.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:23 Page 4 321
54 2
1
1
Manual gear changes
The steering wheel paddles allow manual gear
changing with eitherDrive orSport selected.
• To shift down, briefly pull the paddle.
• To shift up, briefly pull the +paddle.
When the paddles are used in Drive, gear
selection will revert to automatic mode if use of
the paddles is not maintained.
With Sport selected, continuous manual
operation is initiated if the paddles are used.
In both Dand Smode, automatic operation can
be reinstated by pulling the +paddle for two
seconds.
9
Electric parking brake
• Apply manually when stationary in Park,Drive
or Reverse by pulling up the parking brake
switch.
• Can be manually released when the engine is running and the foot brake is applied. Press
the parking brake switch down to release.
• If manually applied whilst in Drive orReverse,
the parking brake will automatically
release when the accelerator is applied.
• Releases automatically when the gear selector is moved from Park.
Transmission
Gearshift interlock
The ignition must be on and the footbrake
depressed before the selector can be rotated
from thePark position. Maintain brake pressure
until a gear is selected.
Instrument pack message center
The current gear selection will be displayed at
the top of the message center.
Sport mode
To move from Drive toSport, press the gear
selector down and rotate. Automatic gear
changing continues but the gearshift points are
modified for full use of the engine's power.
Do NOT use the recess in the electric parking
brake as a storage area.
If the engine is switched off with Neutral selected,
automatic selection of Pis delayed for \f0 minutes.
Do NOT use this feature during vehicle recovery.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:24 Page 9 PR NDS
START
ENGIN E
STOP
