2011 HONDA CR-Z check transmission fluid

Quick Reference Guide
22
Maintenance P. 2 3 7
Under the Hood P. 2 4 5
Check engine oil, engine coolant, and window washer fluid.

●
Add when necessary. Check transmission fluid (CVT).

●
Check brake fluid and clutch fluid.

●
Check the 12 volt battery regularly.

●
Pull the hood release handle under the corner of the
dashboard.
Locate the hood latch handle, pull the handle up, and lift up the hood.
When finished, close the hood and make sure it is
firmly locked in place.
Wiper Blades P. 2 6 6
Replace blades if they leave streaks

●
across the windshield.
Lights
P. 2 5 8
Inspect all lights regularly.

●
Tires
P. 2 6 9
Inspect tires and wheels regularly.

●
Check tire pressure regularly.

●
Install snow tires for winter driving.

●
Main Menu

200
Driving
When Driving Precautions While Driving
Precautions While Driving
In Rain
■
Avoid driving in deep water and on flooded roads. This can damage the engine or cause electrical component failure.
Other Precautions

■
If there is a strong impact with something under the vehicle, stop in a safe location. Check the underside of the vehicle for damage and fuel or brake fluid leaks.
Precautions While Driving
NOTICE Do not operate the shift lever while pressing the accelerator pedal. You could damage the transmission. If the ignition switch is turned to ACCESSORY

or LOCK while driving, the engine will shut
down and all steering and brake power assist functions will stop, making it dificult to control the vehicle. Do not drive with the shift lever in
, as you will
lose engine braking (and acceleration) performance. During the irst 600 miles (1,000 km) of operation, avoid sudden acceleration or full throttle operation so as to not damage the engine or powertrain. Avoid hard braking for the irst 200 miles (300 km). You should also follow this when the brakes are replaced.
Main MenuTable of Contents

Maintenance
This chapter discusses basic maintenance.
237
Before Performing Maintenance
Inspection and Maintenance ................... 238
Safety When Performing Maintenance ... 239Parts and Fluids Used in Maintenance
Service .................................................. 240
Maintenance Minder ™
............................ 241
Maintenance Under the Hood Maintenance Items Under the Hood ....... 245
Opening the Hood ................................. 246
Recommended Engine Oil ...................... 247
Oil Check ............................................... 248
Adding Engine Oil .................................. 249
Changing the Engine Oil and Oil Filter .... 250 Engine Coolant ...................................... 252
Transmission Fluid .................................. 254
Brake/Clutch Fluid .................................. 256
Refilling Window Washer Fluid ............... 257
Replacing Light Bulbs ............................. 258
Checking and Maintaining Wiper Blades Checking Wiper Blades ........................... 266
Changing the Front Wiper Blade Rubber 266
Changing the Rear Wiper Blade Rubber .. 268
Checking and Maintaining Tires Checking Tires ........................................ 269
Tire and Loading Information Label ........ 270
Tire Labeling ........................................... 270 DOT Tire Quality Grading (U.S. Vehicles)
.272
Wear Indicators ...................................... 274
Tire Service Life ...................................... 274
Tire and Wheel Replacement .................. 275
Tire Rotation .......................................... 276
Winter Tires ............................................ 277
12 Volt Battery ........................................ 278
Remote Transmitter Care ....................... 279
Replacing the Battery ............................. 279
Climate Control System Maintenance ... 280
Cleaning ................................................... 281
Interior Care ........................................... 281
Exterior Care .......................................... 283
Main Menu

238
Maintenance
Before Performing Maintenance
Inspection and Maintenance
For your safety, perform all listed inspections and maintenance to keep your vehicle
in good condition. If you become aware of any abnormality (noise, smell, insufficient brake fluid, oil residue on the ground, etc.), have your vehicle inspected by a dealer. (Note, however, that service at a dealer is not mandatory to keep your warranties in effect.) Refer to the separate maintenance booklet for detailed maintenance and inspection information.Types of Inspection and Maintenance

■
Daily Inspections
■
Perform inspections before long distance trips, when washing the vehicle, or when refueling.
Periodic Inspections
■
Check the automatic transmission fluid level monthly.
•
Automatic Transmission Fluid P.254
Check the brake fluid level monthly.
•
Brake/Clutch Fluid P.256
Check the tire pressure monthly. Examine the tread for wear and foreign objects.
•
Checking and Maintaining Tires P.269
Check the operation of the headlights, parking lights, taillights, high-mount
•
brake light, and license plate lights monthly.
Replacing Light Bulbs P.258
Check the condition of the wiper blades at least every six months.
•
Checking and Maintaining Wiper Blades P.266
Inspection and Maintenance
U.S. models only Maintenance, replacement, or repair of emissions control devices and systems may be done by any automotive repair establishment or individual using parts that are "certiied" to EPA standards. According to state and federal regulations, failure to perform maintenance on the items marked with # will not void your emissions warranties. However, all maintenance services should be performed in accordance with the intervals indicated by the multi-information display.
Maintenance Service Items P. 2 4 3
If you want to perform complex maintenance tasks that require more skills and tools, purchase the service manual.
Authorized Manuals P. 3 1 9
If you want to perform maintenance yourself, make sure that you have the necessary tools and skills irst.After performing maintenance, complete the records in the separate maintenance booklet.
Main MenuTable of Contents

243
Maintenance
Maintenance Minder™
Maintenance Service Items
■
System Message Indicator Maintenance Minder Message
Sub Items
Main Item
Maintenance Service Items
Independent of the maintenance minder
•
messages, replace the brake luid every 3 years. Inspect idle speed every 160,000 miles (256,000
•
km).Adjust the valves during services A, B, 1, 2, or 3
•
only if they are noisy.
*1: Change the engine oil according to the maintenance minder messages, or annually, whichever comes irst.
*2: If you drive in dusty conditions, replace the air cleaner element every 15,000 miles (24,000 km).
*3: If you drive primarily in urban areas that have high concentrations of soot in the air from industry and from diesel-powered vehicles, replace the dust and pollen ilter every 15,000 miles (24,000 km).
#: See information on maintenance and emissions warranty.
Code Maintenance Main Items
A Replace engine oil*
• 1
B Replace engine oil*
• 1
and oil filter
Inspect front and rear brakes
•
Check parking brake adjustment
•
Inspect tie rod ends, steering gear
•
box, and boots
Inspect suspension components
•
Inspect driveshaft boots
•
Inspect brake hoses and lines
•
(including ABS/VSA ®
)
Inspect all fluid levels and
•
condition of fluids
Inspect exhaust system
• #
Inspect fuel lines and connections
• #Code Maintenance Sub Items
1 Rotate tires •
2 Replace air cleaner element* • 2
Replace dust and pollen
•
filter* 3
Inspect drive belt
•
3 Replace transmission fluid •
4 Replace spark plugs •
Inspect valve clearance
•
5 Replace engine coolant •
Main MenuTable of Contents

254
Maintenance
Maintenance Under the Hood Transmission Fluid
Transmission Fluid
Automatic Transmission Fluid
■
Continuously Variable Transmission (CVT)
■
Specified fluid: Honda CVTF (continuously variable transmission fluid)
Check the fluid level when the engine is at normal operating temperature. 1. Park on level ground, and start the engine. Wait until the radiator fan starts and then
2.
turn off the engine.
Perform step 3 after waiting for about 60 seconds (less than 90 seconds).
Remove the dipstick (yellow loop) from the
3.
transmission and wipe it with a clean cloth. Insert the dipstick all the way back into
4.
the transmission securely, as shown in the image. Remove the dipstick again and check the
5.
fluid level.
It should be between the upper and lower marks in the HOT range.
If the level is below the lower mark, add
6.
fluid into the dipstick hole to bring it to the level between the upper and lower marks, and have your vehicle checked by a dealer immediately.
Pour the fluid slowly and carefully
so you do not spill any. Clean up any spills immediately; they can damage components in the engine compartment.
Upper Mark Lower Mark
HOT Range
Main MenuTable of Contents

255
Maintenance
Maintenance Under the Hood Transmission Fluid
Manual Transmission Fluid
■
Specified fluid: Honda Manual Transmission Fluid (MTF)
Check the fluid level when the engine is at normal operating temperature.
1. Park the vehicle on level ground. Remove the bolts with a wrench and clips
2.
with a flat-tip screwdriver, then carefully remove the under cover.
3. Remove the transmission filler bolt and washer. Carefully feel inside the bolt hole with your fingers.
Check if the fluid level is up to the edge
of the bolt hole.
If the fluid level is not up to the edge of the
4.
bolt hole, add Honda Manual Transmission Fluid (MTF) until it runs out of the hole. Put a new washer on the filler bolt, then
5.
reinstall the filler bolt.
Tightening torque: 33 lbf∙ft (44 N∙m, 4.5 kgf∙m)
Reinstall the under cover with the bolts
6.
and clips.
Manual Transmission Fluid
If Honda MTF is not available, you may use the API certiicated SAE 10 W-30 or 10 W-40 viscosity motor oil as a temporary measure.Replace with MTF as soon as possible. Motor oil does not contain the proper additives for the transmission and continued use can cause stiffer shifting.
Under CoverBolt
Clip
Main MenuTable of Contents

302
Handling the Unexpected
Indicator, Coming On/Blinking If the Brake System Indicator Comes On If the EPS Indicator Comes On
If the Brake System Indicator Comes On
■Reasons for the Indicator to Come On
The brake fluid is low.

•
There is a malfunction in the brake system.

•
What to Do When the Indicator Comes On While Driving
■
Press the brake pedal lightly to check pedal pressure.
If normal, check the brake fluid level the next time you stop.

•
If abnormal, take immediate action. If necessary, downshift the

•
transmission to slow the vehicle using engine braking.
If the EPS Indicator Comes On
■Reasons for the Indicator to Come On
Comes on when there is a problem with EPS.

•
If you depress the accelerator pedal repeatedly to increase the

•
engine speed while the engine is idling, the indicator comes on, and sometimes the steering wheel becomes harder to operate.
What to Do When the Indicator Comes On
■
Stop the vehicle in a safe place and restart the engine.

• If the indicator comes on and stays on, immediately have your vehicle inspected by a dealer.
U.S.
Canada If the Brake System Indicator Comes On
Have your vehicle repaired immediately. It is dangerous to drive with low brake luid. If there is no resistance from the brake pedal, stop immediately in a safe place. If necessary downshift the gears. If the brake system indicator and ABS indicator come on simultaneously, the brake distribution system is not working. This can result in vehicle instability under sudden braking. Have your vehicle inspected by a dealer immediately.
If the EPS Indicator Comes On
NOTICE If the steering wheel is operated repeatedly or at an extremely low speed, or you hold the steering wheel on the full left or right position for a while, the system heats up. The system goes into a protective mode, and limits its performance. The steering wheel becomes harder and harder to operate. Once the system cools down, EPS is restored. Repeated operation under these conditions can eventually result in a damage to the system.
Main MenuTable of Contents