2011 HONDA CR-Z ignition

241
Maintenance
Maintenance Minder™
If the engine oil life is less than 15%, you will see the maintenance minder messages appear on the multi-information display every time you turn the ignition switch to ON
II. The messages notify you when to change the engine oil, or when to bring
your vehicle to a dealer for indicated maintenance services.
Displaying the Engine Oil Life

■
Turn the ignition switch to ON
1. II.
Press the
2.
button repeatedly until the engine oil life appears on the
multi-information display.
The system message indicator (
) comes on along with the maintenance minder
message.
Displaying the Engine Oil Life
Based on the engine operating conditions, the remaining engine oil life is calculated and displayed as a percentage.
Displayed Engine Oil
Life (%) Calculated Engine
Oil Life (%)
100 100 to 91 90 90 to 81
80 80 to 71
70 70 to 61
60 60 to 51
50 50 to 41
40 40 to 31
30 30 to 21
20 20 to 16
15 15 to 11
10 10 to 65 5 to 1
0 0
Maintenance Service Items
Remaining Engine Oil Life
(Information) Buttons
Main MenuTable of Contents

244
Maintenance
Maintenance Minder™
Resetting the Display
■
Reset the engine oil life display if you have performed the maintenance service.
Turn the ignition switch to ON
1.
II.
Display the engine oil life by repeatedly pressing the
2.
button.
Press and hold the SEL/RESET button for 10 seconds or more.
3.
The oil life reset mode is displayed on the multi-information display.
Select “RESET” with the
4.
button, then press the SEL/RESET button.
The service code will disappear and the engine oil life display will return to
100 %.
To cancel the oil life reset mode, select “CANCEL”, then press the SEL/RESET button.
Resetting the Display
NOTICE Failure to reset the engine oil life after a maintenance service results in the system showing incorrect maintenance intervals, which can lead to serious mechanical problems. The dealer will reset the engine oil life display after completing the required maintenance service.If someone other than a dealer performs
maintenance service, reset the engine oil life disp lay
yourself.
Maintenance Item Codes
Engine Oil Life
SEL/RESET Button
(Information) Button
Main MenuTable of Contents

278
Maintenance
12 Volt Battery
Checking the 12 Volt Battery
Check the battery condition monthly. Look at the test indicator window and check the terminals for corrosion.
If your vehicle’s battery is disconnected or goes dead: The audio system is disabled.
•
Entering the Security Code P.140
The clock resets.
•
Setting the Clock P.98
The navigation system is disabled. A PIN code will be required.
•
Refer to the navigation system manual.
Charging the 12 Volt Battery Disconnect both battery cables to prevent damaging your vehicle’s electrical system. Always disconnect the negative (–) cable first, and reconnect it last.
Test Indicator Window 12 Volt Battery
WARNING: Battery posts, terminals, and
related accessories contain lead and lead compounds.Wash your hands after handling. The test indicator's color information is on the battery. When you ind corrosion, clean the battery terminals by applying a baking powder and water solution. Rinse the terminals with water. Cloth/towel dry the battery. Coat the terminals with grease to help prevent future corrosion. If the 12 volt battery is disconnected or goes dead, the IMA battery level gauge reading may show less than the actual level the next time you turn the ignition switch to ON
. It will show the correct
level after you drive for about 30 minutes.
WARNING
The battery gives off explosive hydrogen gas during normal operation. A spark or flame can cause the battery to explode with enough force to kill or seriously hurt you. Wear protective clothing and a face shield, or have a skilled technician do any battery maintenance.
Main MenuTable of Contents

287
Handling the Unexpected
If a Tire Goes Flat
Changing a Flat Tire
Changing a Flat Tire
Periodically check the tire pressure of the compact spare. It should be set to the speciied pressure.Speciied Pressure: 60 psi (420 kPa, 4.2 kgf/cm 2
)
When driving with the compact spare tire, keep the vehicle speed under 50 mph (80 km/h).Replace with a full size tire as soon as possible. The compact spare tire and wheel in your vehicle are speciically for this model.Do not use them with another vehicle.Do not use another type of compact spare tire or wheel with your vehicle. Do not mount tire chains on a compact spare tire. If a chain-mounted front tire goes lat, remove one of the full-size rear tires and replace it with the compact spare tire. Remove the lat front tire and replace it will the full size tire that was removed from the rear. Mount the tire chains on the front tire.
If a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually to reduce speed. Then, stop in a safe place. Replace the flat tire with the compact spare tire. Go to a dealer as soon as possible to have the full size tire repaired or replaced.
Park the vehicle on firm, level, and non-slippery ground.
1.
Put the shift lever in
2.
P (CVT).
Put the shift lever in
R (manual transmission).
Set the parking brake.
3.
Turn on the hazard warning lights and turn the ignition switch to LOCK
4.
0.
Main MenuTable of Contents

293
Handling the Unexpected
Engine Does Not Start
Checking the Engine If the engine does not start, turn the ignition switch to START
and check the
starter. Checking the Engine
If you must start the vehicle immediately, use an assisting vehicle to jump start it.
Jump Starting P.294
Starter Condition Check List
Starter will not start at all. Starter turns over very slowly.The 12 volt battery may be dead. Check each of the items on the right and respond accordingly. Check brightness of the interior light.Turn on interior lights and check brightness.
If the interior lights are dim or do not come on at all
•
12 Volt Battery Inspection and Maintenance P. 2 7 8
If the interior lights come on normally
•
Fuse Inspection and Replacement P. 3 0 4
The starter turns over normally but...There may be a problem with the fuse. Check each of the items on the right and respond accordingly. Review the engine start procedure.Follow its instructions, and try to start the engine again.
Staring the Engine
P.1 9 7
Check the immobilizer system indicator. When the immobilizer system indicator is blinking, the engine cannot be started.
Immobilizer System P.1 0 5
Check the fuel level. There should be enough fuel in the tank.
Fuel Gauge P.1 4
Check the fuse. Check all fuses, or have the vehicle checked by a dealer.
Inspecting and Changing Fuses P. 3 0 4
If the problem continues:
Emergency Towing P. 3 0 8
Main MenuTable of Contents

296
Handling the Unexpected
Shift Lever Does Not Move
Automatic transmission (CVT) model
Follow the procedure below if you cannot move the shift lever out of P position.
Releasing the Lock

■
1. Set the parking brake. Remove the key from the ignition switch.
2.
Wrap a cloth around the tip of a small flat-
3.
tip screwdriver and remove the cover of the shift lock release slot.
Put the tip of the flat-tip screwdriver into the slot and remove it as shown in the image.
4. Insert the key into the shift lock release slot.While pushing on the key, press the shift
5.
lever release button and place the shift lever into
N.
The lock is now released. Have the shift lever checked by a dealer as soon as possible.
SlotCover
Shift Lock Release Slot
Release Button
Main MenuTable of Contents

304
Handling the Unexpected
Fuses
Fuse Locations
If any electrical devices are not working, turn the ignition switch to LOCK 0 and
check to see if any applicable fuse is blown.
Engine Compartment Fuse Box

■
Located near the + terminal on the 12 volt battery.
1. Pull on the tab to release the front of the cover.Pull up the cover by pushing the two tabs
2.
as shown. Replacement of engine compartment fuses should be done by a dealer.
Circuit Protected and Amps for Each
■
Fuse
Circuit Protected Amps
1 Battery 100 A
2 EPS 70 A
3 Horn, Stop, Hazard 20 A
Fuse Locations
Fuse locations are shown on the fuse box cover.
Locate the fuse in question by the fuse number and box cover number.
Fuse Box
Main MenuTable of Contents

306
Handling the Unexpected
Fuses Fuse Locations
Circuit Protected and Amps for Each Fuse
■
Circuit Protected Amps
33 Ignition Coil 15 A 34 Left Headlight Low*
1
Left Headlight High* 210 A 10 A
35 Door Lock 7.5 A
36 Door Lock 10 A
37 ABS FSR/VSA ®
FSR 30 A
38 - -
39 IGP 15 A
40 - -
41 - -
42 IMA 1 7.5 A
43 MG Clutch 7.5 A
44 STS 7.5 A
45 Door Lock 20 A
46 - -
47 Sub Fan Motor 30 A 48 Left Headlight High*
1
Left Headlight Low (HID)* 210 A 15 A
49 Door Lock Motor 2
(UNLOCK) 7.5 A
50 - -
51 Right Headlight High 10 A
52 DBW 15 A
53 IMA 2 15 A
54 - -Circuit Protected Amps
55 Heated Mirror* 10 A
56 Front Wiper 30 A
57 Blower Motor 30 A
58 ABS/VSA ®
MTR 30 A
59 Rear Defogger 40 A*
3
30 A* 4
60 IG Main 50 A
61 - -
62 - -
*1: Vehicle with halogen bulb low beam headlights *2: Vehicle with discharge headlights*3: With heated door mirror*4: Without heated door mirror
* Not available on all models
Main MenuTable of Contents