Page 229 of 333
228
Driving
Parking Your Vehicle Auto Idle Stop (Manual Transmission)
Auto Idle Stop Activates When:
■
Stopping with the brake, the clutch pedal is fully depressed, and the shift lever is in
N.
To restart the engine automatically, depress the clutch pedal.
Auto Idle Stop Does Not Activate When:
■
The low temperature indicator is on.
•
The IMA battery charge is low.
•
The bars of the ASST/CHRG indicators do not move when accelerating or
•
decelerating. The vehicle comes to a stop again before the vehicle speed reaches 9 mph
•
(15km/h) after the engine starts.The shift lever is in
•
R.
Airflow from the climate control system increases.
•
If you have selected the fan speed manually:
The display shows more than five vertical bars.
• is on (the indicator is on).
Auto Idle Stop May Not Activate When:
■
The climate control system is in use, and there is a significant difference between
•
the set temperature and the actual interior temperature. (Except when in ECON mode).When humidity in the interior is high.
•
The vehicle is stopped by braking suddenly
•
Auto Idle Stop Activates When:
The brake pedal is depressed, the vehicle slows down to a speed below 19 mph (30 km/h), and the clutch pedal is fully pressed. The engine may not stop or restart automatically if you fail to fully depress the clutch pedal.
Keeping the proper driving positions makes it easie r
for you to depress the clutch pedal fully.
Adjusting the Seats P.11 9
Main MenuTable of Contents
Page 230 of 333
229
Driving
Parking Your Vehicle Auto Idle Stop (Manual Transmission)
The Engine Automatically Restarts When:
■
The clutch pedal is fully depressed, and the shift lever is moved to a position other than
N.
The Engine Automatically Restarts When the Clutch Pedal is Fully
■
Depressed Even If the Shift Lever is in
N When:
The low temperature indicator comes on.
•
The accelerator pedal is pressed.
•
The IMA battery charge becomes low.
•
The climate control system is in use, and the difference between the set
•
temperature and actual interior temperature becomes significant. The climate control system is being used to dehumidify the interior.
• The engine automatically restarts when the pressure on the brake pedal is repeatedly applied and released slightly during a stop. This applies even if the clutch pedal is not fully depressed.
When the Auto Idle Stop Indicator Starts Blinking Rapidly
■
Fully depress the clutch pedal.
The engine automatically restarts
When the Auto Idle Stop Indicator Starts Blinking
Rapidly
The indicator starts blinking rapidly under the following conditions: The
•
(windshield defogger) button is pressed.
When the climate control system is in use and
•
moisture builds up inside the vehicle. When the climate control system is in use and
•
the difference between the set temperature and the actual temperature inside the vehicle becomes signiicant.
Main MenuTable of Contents
Page 239 of 333
238
Maintenance
Before Performing Maintenance
Inspection and Maintenance
For your safety, perform all listed inspections and maintenance to keep your vehicle
in good condition. If you become aware of any abnormality (noise, smell, insufficient brake fluid, oil residue on the ground, etc.), have your vehicle inspected by a dealer. (Note, however, that service at a dealer is not mandatory to keep your warranties in effect.) Refer to the separate maintenance booklet for detailed maintenance and inspection information.Types of Inspection and Maintenance
■
Daily Inspections
■
Perform inspections before long distance trips, when washing the vehicle, or when refueling.
Periodic Inspections
■
Check the automatic transmission fluid level monthly.
•
Automatic Transmission Fluid P.254
Check the brake fluid level monthly.
•
Brake/Clutch Fluid P.256
Check the tire pressure monthly. Examine the tread for wear and foreign objects.
•
Checking and Maintaining Tires P.269
Check the operation of the headlights, parking lights, taillights, high-mount
•
brake light, and license plate lights monthly.
Replacing Light Bulbs P.258
Check the condition of the wiper blades at least every six months.
•
Checking and Maintaining Wiper Blades P.266
Inspection and Maintenance
U.S. models only Maintenance, replacement, or repair of emissions control devices and systems may be done by any automotive repair establishment or individual using parts that are "certiied" to EPA standards. According to state and federal regulations, failure to perform maintenance on the items marked with # will not void your emissions warranties. However, all maintenance services should be performed in accordance with the intervals indicated by the multi-information display.
Maintenance Service Items P. 2 4 3
If you want to perform complex maintenance tasks that require more skills and tools, purchase the service manual.
Authorized Manuals P. 3 1 9
If you want to perform maintenance yourself, make sure that you have the necessary tools and skills irst.After performing maintenance, complete the records in the separate maintenance booklet.
Main MenuTable of Contents
Page 246 of 333
245
Maintenance
Maintenance Under the Hood
Maintenance Items Under the Hood
Brake Fluid (Black cap)
Washer Fluid (Blue cap)
Engine Coolant Reservoir
Engine Oil Fill Cap
Manual
Transmission model:Clutch Fluid(Light Gray cap)
Automatic Transmission (CVT) Fluid Dipstick
(Yellow loop)
Radiator Cap
Engine Oil Dipstick (Orange handle)
Main MenuTable of Contents
Page 256 of 333
255
Maintenance
Maintenance Under the Hood Transmission Fluid
Manual Transmission Fluid
■
Specified fluid: Honda Manual Transmission Fluid (MTF)
Check the fluid level when the engine is at normal operating temperature.
1. Park the vehicle on level ground. Remove the bolts with a wrench and clips
2.
with a flat-tip screwdriver, then carefully remove the under cover.
3. Remove the transmission filler bolt and washer. Carefully feel inside the bolt hole with your fingers.
Check if the fluid level is up to the edge
of the bolt hole.
If the fluid level is not up to the edge of the
4.
bolt hole, add Honda Manual Transmission Fluid (MTF) until it runs out of the hole. Put a new washer on the filler bolt, then
5.
reinstall the filler bolt.
Tightening torque: 33 lbf∙ft (44 N∙m, 4.5 kgf∙m)
Reinstall the under cover with the bolts
6.
and clips.
Manual Transmission Fluid
If Honda MTF is not available, you may use the API certiicated SAE 10 W-30 or 10 W-40 viscosity motor oil as a temporary measure.Replace with MTF as soon as possible. Motor oil does not contain the proper additives for the transmission and continued use can cause stiffer shifting.
Under CoverBolt
Clip
Main MenuTable of Contents
Page 288 of 333
287
Handling the Unexpected
If a Tire Goes Flat
Changing a Flat Tire
Changing a Flat Tire
Periodically check the tire pressure of the compact spare. It should be set to the speciied pressure.Speciied Pressure: 60 psi (420 kPa, 4.2 kgf/cm 2
)
When driving with the compact spare tire, keep the vehicle speed under 50 mph (80 km/h).Replace with a full size tire as soon as possible. The compact spare tire and wheel in your vehicle are speciically for this model.Do not use them with another vehicle.Do not use another type of compact spare tire or wheel with your vehicle. Do not mount tire chains on a compact spare tire. If a chain-mounted front tire goes lat, remove one of the full-size rear tires and replace it with the compact spare tire. Remove the lat front tire and replace it will the full size tire that was removed from the rear. Mount the tire chains on the front tire.
If a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually to reduce speed. Then, stop in a safe place. Replace the flat tire with the compact spare tire. Go to a dealer as soon as possible to have the full size tire repaired or replaced.
Park the vehicle on firm, level, and non-slippery ground.
1.
Put the shift lever in
2.
P (CVT).
Put the shift lever in
R (manual transmission).
Set the parking brake.
3.
Turn on the hazard warning lights and turn the ignition switch to LOCK
4.
0.
Main MenuTable of Contents
Page 298 of 333
297
Handling the Unexpected
Overheating
How to Handle Overheating Overheating symptoms are as follows:The high temperature indicator comes on or the engine suddenly loses power.
•
Steam is coming out of the engine compartment.
•
First Thing to Do
■
Immediately park the vehicle in a safe place.
1.
Put the shift lever to P (CVT) or N (manual transmission) and set the
parking brake. Turn off all accessories and turn on the hazard warning lights.
No steam coming out:
2. Keep the engine running and open the hood.
Steam coming out: Turn off the engine and wait until steam goes away.
Then, open the hood.
How to Handle Overheating
NOTICE Continuing to drive with the high temperature indicator on may damage the engine.
WARNING
Steam and spray from an overheated engine can seriously scald you. Do not open the hood if steam is coming out.
continued
Main MenuTable of Contents
Page 301 of 333
300
Handling the Unexpected
Indicator, Coming On/Blinking If the Charging System Indicator Comes On
If the Charging System Indicator Comes On ■Reasons for the Indicator to Come On
Comes on when the 12 volt battery is not being charged.
What to Do When the Indicator Comes On
■
Turn off the climate control system, rear defogger, and other electrical systems, and immediately contact a dealer for repairs.
If the Charging System Indicator Comes On
If you need to stop temporarily, do not turn off the
engine. Restarting the engine may rapidly discharge the 12 volt battery.
Manual transmission model This indicator may also come on when the auto idle stop function is activated for a while. Restart the engine.
Auto Idle Stop (Manual Transmission) P. 227
Automatic transmission (CVT) model This indicator may also come on when the IMA battery charge drops below a desired level.The engine starts to recharge the battery.
Auto Idle Stop (CVT) P. 224
The indicator goes off when the battery is being charged normally. This indicator may blink after starting when the outside temperature is below -20°F (-30°C). It will stop blinking after the IMA battery warms up.
Main MenuTable of Contents
