2011 HONDA CR-Z air condition

214
Driving
When Driving VSA®
(Vehicle Stability Assist), aka ESC (Electronic Stability Control), System
VSA ®
(Vehicle Stability Assist), aka ESC (Electronic
Stability Control), System VSA ®
helps to stabilize the vehicle during cornering if the vehicle turns more or less
than what was intended. It also assists in maintaining traction on slippery surfaces. It does so by regulating engine output and selectively applying the brakes.
VSA

■®
Operation
When VSA®
activates, you may notice that the
engine does not respond to the accelerator. You may also notice some noise from the hydraulic system. You will also see the indicator blink.
VSA ®
(Vehicle Stability Assist), aka ESC (Electronic
Stability Control), System
The VSA ®
may not function properly if tire type and
size are mixed. Make sure to use the same size and type of tire, and the air pressures as speciied. When the VSA ®
indicator comes on and stays on
while driving, there may be a problem with the system. While this may not interfere with normal driving, have your vehicle checked by a dealer immediately. VSA ®
cannot enhance stability in all driving
situations and does not control the entire braking system. You still need to drive and corner at speeds appropriate for the conditions and always leave a suficient margin of safety. The main function of the VSA ®
system is generally
known as Electronic Stability Control (ESC). The system also includes a traction control function.
VSA ®
System
Indicator
Main MenuTable of Contents

235
Driving
Accessories and Modiications
Accessories
When installing accessories, check the following:Do not install accessories on the windshield. They can obstruct your view and

•
delay your reaction to driving conditions. Do not install accessories on the side pillars or across the side windows.

•
Accessories installed in these areas may interfere with proper operation of the side curtain airbags. Be sure electronic accessories do not overload electrical circuits or interfere with

•
proper operation of your vehicle.
Fuse P.304
Before installing any electronic accessory, have the installer contact a dealer for

•
assistance. If possible, have a dealer inspect the final installation.
Modiications Do not modify your vehicle or use non-Honda components that can affect its handling, stability, and reliability.Overall vehicle performance can be affected. Always make sure all equipment is properly installed and maintained, and that it meets federal, state, province, territory, and local regulations.
Accessories and Modiications
Use Honda Genuine accessories to ensure proper operation on your vehicle.
Contact your dealer when purchasing and installing parts and accessories.
WARNING
Improper accessories or modifications can affect your vehicle’s handling, stability, and performance, and cause a crash in which you can be hurt or killed. Follow all instructions in this owner’s manual regarding accessories and modifications.
Main MenuTable of Contents

238
Maintenance
Before Performing Maintenance
Inspection and Maintenance
For your safety, perform all listed inspections and maintenance to keep your vehicle
in good condition. If you become aware of any abnormality (noise, smell, insufficient brake fluid, oil residue on the ground, etc.), have your vehicle inspected by a dealer. (Note, however, that service at a dealer is not mandatory to keep your warranties in effect.) Refer to the separate maintenance booklet for detailed maintenance and inspection information.Types of Inspection and Maintenance

■
Daily Inspections
■
Perform inspections before long distance trips, when washing the vehicle, or when refueling.
Periodic Inspections
■
Check the automatic transmission fluid level monthly.
•
Automatic Transmission Fluid P.254
Check the brake fluid level monthly.
•
Brake/Clutch Fluid P.256
Check the tire pressure monthly. Examine the tread for wear and foreign objects.
•
Checking and Maintaining Tires P.269
Check the operation of the headlights, parking lights, taillights, high-mount
•
brake light, and license plate lights monthly.
Replacing Light Bulbs P.258
Check the condition of the wiper blades at least every six months.
•
Checking and Maintaining Wiper Blades P.266
Inspection and Maintenance
U.S. models only Maintenance, replacement, or repair of emissions control devices and systems may be done by any automotive repair establishment or individual using parts that are "certiied" to EPA standards. According to state and federal regulations, failure to perform maintenance on the items marked with # will not void your emissions warranties. However, all maintenance services should be performed in accordance with the intervals indicated by the multi-information display.
Maintenance Service Items P. 2 4 3
If you want to perform complex maintenance tasks that require more skills and tools, purchase the service manual.
Authorized Manuals P. 3 1 9
If you want to perform maintenance yourself, make sure that you have the necessary tools and skills irst.After performing maintenance, complete the records in the separate maintenance booklet.
Main MenuTable of Contents

239
Maintenance
Before Performing Maintenance Safety When Performing Maintenance
Safety When Performing Maintenance
Some of the most important safety precautions are given here. However, we cannot warn you of every conceivable hazard that can arise in performing maintenance. Only you can decide whether or not you should perform a given task.Maintenance Safety

■
To reduce the possibility of fire or explosion, keep cigarettes, sparks, and flames
•
away from the battery and all fuel related parts. To clean parts, use a commercially available degreaser or parts cleaner, not
•
gasoline.Wear eye protection and protective clothing when working with the 12 volt
•
battery or compressed air.Engine exhaust gasses contain carbon monoxide, which is poisonous and can kill
•
you.
Only operate the engine if there is sufficient ventilation.
Vehicle Safety

■
The vehicle must be in a stationary condition.
•
Make sure your vehicle is parked on level ground, the parking brake is set,
and the engine is off.
Be aware that hot parts can burn you.
•
Make sure to let the engine and exhaust system cool thoroughly before
touching vehicle parts.
Be aware that moving parts can injure you.
•
Do not start the engine unless instructed, and keep your hands and limbs
away from moving parts.
Do not touch the IMA battery and wirings (orange).
•
Safety When Performing Maintenance

WARNING
Improperly maintaining this vehicle or failing to correct a problem before driving can cause a crash in which you can be seriously hurt or killed. Always follow the inspection and maintenance recommendations according to the schedules in this owner’s manual.
WARNING
Failure to properly follow maintenance instructions and precautions can cause you to be seriously hurt or killed. Always follow the procedures and precautions in this owner’s manual.
Main MenuTable of Contents

243
Maintenance
Maintenance Minder™
Maintenance Service Items
■
System Message Indicator Maintenance Minder Message
Sub Items
Main Item
Maintenance Service Items
Independent of the maintenance minder
•
messages, replace the brake luid every 3 years. Inspect idle speed every 160,000 miles (256,000
•
km).Adjust the valves during services A, B, 1, 2, or 3
•
only if they are noisy.
*1: Change the engine oil according to the maintenance minder messages, or annually, whichever comes irst.
*2: If you drive in dusty conditions, replace the air cleaner element every 15,000 miles (24,000 km).
*3: If you drive primarily in urban areas that have high concentrations of soot in the air from industry and from diesel-powered vehicles, replace the dust and pollen ilter every 15,000 miles (24,000 km).
#: See information on maintenance and emissions warranty.
Code Maintenance Main Items
A Replace engine oil*
• 1
B Replace engine oil*
• 1
and oil filter
Inspect front and rear brakes
•
Check parking brake adjustment
•
Inspect tie rod ends, steering gear
•
box, and boots
Inspect suspension components
•
Inspect driveshaft boots
•
Inspect brake hoses and lines
•
(including ABS/VSA ®
)
Inspect all fluid levels and
•
condition of fluids
Inspect exhaust system
• #
Inspect fuel lines and connections
• #Code Maintenance Sub Items
1 Rotate tires •
2 Replace air cleaner element* • 2
Replace dust and pollen
•
filter* 3
Inspect drive belt
•
3 Replace transmission fluid •
4 Replace spark plugs •
Inspect valve clearance
•
5 Replace engine coolant •
Main MenuTable of Contents

269
Maintenance
Checking and Maintaining Tires
Checking Tires To safely operate your vehicle, your tires must be of the proper type and size, in good condition with adequate tread, and properly inflated.Inflation Guidelines
■
Properly inflated tires provide the best combination of handling, tread life, and
comfort. Refer to the driver’s doorjamb label or specification’s page for the specified pressure. Underinflated tires wear unevenly, adversely affect handling and fuel economy, and are more likely to fail from overheating. Overinflated tires make your vehicle ride harshly, are more prone to road hazard, and wear unevenly. Every day before you drive, look at each of the tires. If one looks lower than the others, check the pressure with a tire gauge. At least once a month or before long trips, use a gauge to measure the pressure in all tires, including the spare. Even tires in good condition can lose 1 to 2 psi (10 to 20 kPa, 0.1 to 0.2 kgf/cm 2
) per month.
Inspection Guidelines
■
Every time you check inflation, also examine the tires and valve stems.Look for:
Bumps or bulges on the side or in the tread. Replace the tire if you find any.
•
Cuts, splits, or cracks in the side of the tire. Replace it if you see fabric or cord.Remove any foreign objects and inspect for air leaks.
•
Uneven tread wear. Have your dealer check the wheel alignment.
•
Excessive tread wear.
•
Wear Indicators P.274
Checking Tires
Measure the air pressure when tires are cold. This means the vehicle has been parked for at least three hours, or driven less than 1 mile (1.6 km). If necessary, add or release air until the speciied pressure is reached. If checked when hot, tire pressure can be as mush as 4–6 psi (30–40 kPa, 0.3–0.4 kgf/cm 2
) higher
than if checked when cold.
Have a dealer check the tires if you feel a consist ent
vibration while driving. New tires and any that have been removed and reinstalled should be properly balanced.
WARNING
Using tires that are excessively worn or improperly inflated can cause a crash in which you can be seriously hurt or killed. Follow all instructions in this owner’s manual regarding tire inflation and maintenance.
Main MenuTable of Contents

302
Handling the Unexpected
Indicator, Coming On/Blinking If the Brake System Indicator Comes On If the EPS Indicator Comes On
If the Brake System Indicator Comes On
■Reasons for the Indicator to Come On
The brake fluid is low.

•
There is a malfunction in the brake system.

•
What to Do When the Indicator Comes On While Driving
■
Press the brake pedal lightly to check pedal pressure.
If normal, check the brake fluid level the next time you stop.

•
If abnormal, take immediate action. If necessary, downshift the

•
transmission to slow the vehicle using engine braking.
If the EPS Indicator Comes On
■Reasons for the Indicator to Come On
Comes on when there is a problem with EPS.

•
If you depress the accelerator pedal repeatedly to increase the

•
engine speed while the engine is idling, the indicator comes on, and sometimes the steering wheel becomes harder to operate.
What to Do When the Indicator Comes On
■
Stop the vehicle in a safe place and restart the engine.

• If the indicator comes on and stays on, immediately have your vehicle inspected by a dealer.
U.S.
Canada If the Brake System Indicator Comes On
Have your vehicle repaired immediately. It is dangerous to drive with low brake luid. If there is no resistance from the brake pedal, stop immediately in a safe place. If necessary downshift the gears. If the brake system indicator and ABS indicator come on simultaneously, the brake distribution system is not working. This can result in vehicle instability under sudden braking. Have your vehicle inspected by a dealer immediately.
If the EPS Indicator Comes On
NOTICE If the steering wheel is operated repeatedly or at an extremely low speed, or you hold the steering wheel on the full left or right position for a while, the system heats up. The system goes into a protective mode, and limits its performance. The steering wheel becomes harder and harder to operate. Once the system cools down, EPS is restored. Repeated operation under these conditions can eventually result in a damage to the system.
Main MenuTable of Contents

312
Information
Speciications
Vehicle Specifications
■
Model Honda CR-Z No. of Passengers:
Front RearTotal 2–2
Weights: Gross Vehicle Weight Rating U.S.: 3,164 lbs (1,435 kg)Canada: 1,435 kg
Gross Axle Weight Rating (Front) U.S.: 1,797 lbs (815 kg)Canada: 815 kg
Gross Axle Weight Rating (Rear) U.S.: 1,378 lbs (625 kg)Canada: 625 kg
Air Conditioning: Refrigerant TypeCharge QuantityLubricant Type HFC-134a (R-134a)15.8 – 17.6 oz (450 – 500 g)SP-10
Engine Specifications
■
Displacement 91 cu-in (1,497 cm 3
)
Spark Plugs NGK DIFR6A13G
DENSO DK20PR-D13
Fuel
■
Fuel: Type Unleaded gasoline, Pump octane number of 87 or higher
Fuel Tank Capacity 10.6 US gal (40 ℓ)
12 Volt Battery
■
Capacity/Type 32AH(5)/40AH(20) 34AH(5)/40AH(20)
Washer Fluid
■
Tank Capacity U.S.: 2.6 US qt (2.5 ℓ) Canada: 4.8 US qt (4.5 ℓ)
Light Bulbs
■
Headlights (Low Beam) 35W (D4S)*
1
55W (H11)* 2
Headlights (High Beam) 60W (HB3)
Fog Lights* 55W (H11)Front Turn Signal/Parking/ Side Marker Lights 28W/8W
Side Turn Signal Lights(on Door Mirrors) LED
Brake/Taillights LED
Rear Turn Signal Lights 21W (Amber)
Back-Up Lights 16W
Rear Side Marker Lights 3CP
High-Mount Brake Light LED
License Plate Lights 5W
Cargo Area Light 5WInterior Lights
Front
Rear 8W3.4W
Vanity Mirror Lights* 2W
Glove Box Light 1.4W
Courtesy Lights 2CP (3.8W)
*1: Vehicle with discharge headlights
*2: Vehicle with halogen bulb low beam headlights
* Not available on all models
Main MenuTable of Contents