2011 HONDA CR-Z engine coolant

Quick Reference Guide
22
Maintenance P. 2 3 7
Under the Hood P. 2 4 5
Check engine oil, engine coolant, and window washer fluid.

●
Add when necessary. Check transmission fluid (CVT).

●
Check brake fluid and clutch fluid.

●
Check the 12 volt battery regularly.

●
Pull the hood release handle under the corner of the
dashboard.
Locate the hood latch handle, pull the handle up, and lift up the hood.
When finished, close the hood and make sure it is
firmly locked in place.
Wiper Blades P. 2 6 6
Replace blades if they leave streaks

●
across the windshield.
Lights
P. 2 5 8
Inspect all lights regularly.

●
Tires
P. 2 6 9
Inspect tires and wheels regularly.

●
Check tire pressure regularly.

●
Install snow tires for winter driving.

●
Main Menu

73
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
High Temperature Indicator Comes on briefly when you turn

•
the ignition switch to ON
II.
Blinks when the engine coolant

•
temperature goes up, and stays on if the temperature continues to rise. Blinks while driving

• - Drive slowly to
prevent overheating.Stays on while driving

• - Immediately
stop in a safe place and allow the engine to cool.
Overheating P.297
IMA System Indicator Comes on briefly when you turn

•
the ignition switch to ON
II.
Comes on if there is a problem

•
with the IMA system. Remains on or does not come on

•
at all - Avoid high speed driving and
have the vehicle checked by a dealer as soon as possible.
If the IMA Indicator Comes ON P.303
System Message Indicator Comes on along with a beep when

•
a problem is detected. A system message on the multi-information display appears at the same time. While the indicator is on, press the

•
(information) button to see
the message again. Refer to the Indicators information in

•
this chapter when a system message appears on the multi-information display. Take the appropriate action for the message.
The multi-information display does not

•
return to the normal screen unless the warning is canceled, or the

button is pressed.
—
Main MenuTable of Contents

74
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
Low Temperature Indicator Comes on when the engine

•
coolant temperature is low. If the indicator stays on after the

•
engine has reached normal operating temperature, there may be a problem with the temperature sensors. Have the vehicle inspected by a dealer.
—
U.S.
Canada Side Airbag Off Indicator Comes on for a few seconds when

•
you turn the ignition switch to ON
II, then goes off.
Comes on when the passenger side

•
airbag system is automatically shut off. It does not mean there is a problem

•
with your side airbags. Comes on when nobody is sitting

•
in the passenger seat - Have the
vehicle checked by a dealer.Comes on when someone is sitting

•
in the seat - Have the person sit
properly. U.S.
Canada
High Beam Indicator Comes on when the high beam

•
headlights are on.Comes on with reduced brightness

•
when DRL (daytime running lights) are on. —
—
Main MenuTable of Contents

Maintenance
This chapter discusses basic maintenance.
237
Before Performing Maintenance
Inspection and Maintenance ................... 238
Safety When Performing Maintenance ... 239Parts and Fluids Used in Maintenance
Service .................................................. 240
Maintenance Minder ™
............................ 241
Maintenance Under the Hood Maintenance Items Under the Hood ....... 245
Opening the Hood ................................. 246
Recommended Engine Oil ...................... 247
Oil Check ............................................... 248
Adding Engine Oil .................................. 249
Changing the Engine Oil and Oil Filter .... 250 Engine Coolant ...................................... 252
Transmission Fluid .................................. 254
Brake/Clutch Fluid .................................. 256
Refilling Window Washer Fluid ............... 257
Replacing Light Bulbs ............................. 258
Checking and Maintaining Wiper Blades Checking Wiper Blades ........................... 266
Changing the Front Wiper Blade Rubber 266
Changing the Rear Wiper Blade Rubber .. 268
Checking and Maintaining Tires Checking Tires ........................................ 269
Tire and Loading Information Label ........ 270
Tire Labeling ........................................... 270 DOT Tire Quality Grading (U.S. Vehicles)
.272
Wear Indicators ...................................... 274
Tire Service Life ...................................... 274
Tire and Wheel Replacement .................. 275
Tire Rotation .......................................... 276
Winter Tires ............................................ 277
12 Volt Battery ........................................ 278
Remote Transmitter Care ....................... 279
Replacing the Battery ............................. 279
Climate Control System Maintenance ... 280
Cleaning ................................................... 281
Interior Care ........................................... 281
Exterior Care .......................................... 283
Main Menu

243
Maintenance
Maintenance Minder™
Maintenance Service Items
■
System Message Indicator Maintenance Minder Message
Sub Items
Main Item
Maintenance Service Items
Independent of the maintenance minder
•
messages, replace the brake luid every 3 years. Inspect idle speed every 160,000 miles (256,000
•
km).Adjust the valves during services A, B, 1, 2, or 3
•
only if they are noisy.
*1: Change the engine oil according to the maintenance minder messages, or annually, whichever comes irst.
*2: If you drive in dusty conditions, replace the air cleaner element every 15,000 miles (24,000 km).
*3: If you drive primarily in urban areas that have high concentrations of soot in the air from industry and from diesel-powered vehicles, replace the dust and pollen ilter every 15,000 miles (24,000 km).
#: See information on maintenance and emissions warranty.
Code Maintenance Main Items
A Replace engine oil*
• 1
B Replace engine oil*
• 1
and oil filter
Inspect front and rear brakes
•
Check parking brake adjustment
•
Inspect tie rod ends, steering gear
•
box, and boots
Inspect suspension components
•
Inspect driveshaft boots
•
Inspect brake hoses and lines
•
(including ABS/VSA ®
)
Inspect all fluid levels and
•
condition of fluids
Inspect exhaust system
• #
Inspect fuel lines and connections
• #Code Maintenance Sub Items
1 Rotate tires •
2 Replace air cleaner element* • 2
Replace dust and pollen
•
filter* 3
Inspect drive belt
•
3 Replace transmission fluid •
4 Replace spark plugs •
Inspect valve clearance
•
5 Replace engine coolant •
Main MenuTable of Contents

245
Maintenance
Maintenance Under the Hood
Maintenance Items Under the Hood
Brake Fluid (Black cap)
Washer Fluid (Blue cap)
Engine Coolant Reservoir
Engine Oil Fill Cap
Manual
Transmission model:Clutch Fluid(Light Gray cap)
Automatic Transmission (CVT) Fluid Dipstick
(Yellow loop)
Radiator Cap
Engine Oil Dipstick (Orange handle)
Main MenuTable of Contents

252
Maintenance
Maintenance Under the Hood Engine Coolant
Engine Coolant
Specified coolant: Honda Long Life Antifreeze/Coolant Type 2
This coolant is premixed with 50% antifreeze and 50 % water. Do not add any more
antifreeze or water. We recommend you check the engine coolant level every time you refuel. Check the reserve tank first. If it is completely empty, also check the coolant level in the radiator. Add the engine coolant accordingly.
Reserve Tank

■
1. Check the amount of coolant in the reserve tank.
2. If the coolant level is below the MIN mark, add coolant until it reaches the MAX mark.Inspect the cooling system for leaks.
3.
Engine Coolant
If Honda antifreeze/coolant is not available, you may use another major brand non-silicate coolant as a temporary replacement. Check that it is a high quality coolant recommended for aluminum engines. Continued use of any non-Honda coolant can result in corrosion, causing the cooling system to malfunction or fail. Have the cooling system lushed and reilled with Honda antifreeze/coolant as soon as possible. Do not add rust inhibitors or other additives to your vehicle's cooling system. They may not be compatible with the coolant or with the engine components.
Reserve
Tank
MIN
MAX
Reserve Tank
Main MenuTable of Contents

253
Maintenance
Maintenance Under the Hood Engine Coolant
Radiator
■
1. Make sure the engine and radiator are cool.
Turn the radiator cap counterclockwise and
2.
relieve any pressure in the cooling system. Do not press the cap down when turning. Push down and turn the radiator cap
3.
counterclockwise to remove it. The coolant level should be up to the base
4.
of the filler neck. Add coolant if it is low.
Put the radiator cap back on, and tighten it
5.
fully.Pour coolant into the reserve tank until it
6.
reaches the MAX mark. Put the cap back on the reserve tank.
Pour the fluid slowly and carefully
so you do not spill any. Clean up any spills immediately; they can damage components in the engine compartment.
Radiator
WARNING
Removing the radiator cap while the engine is hot can cause the coolant to spray out, seriously scalding you.
Always let the engine and radiator cool down before removing the radiator cap.Radiator Cap
Main MenuTable of Contents