Page 17 of 396
15Familiarisation
Instruments and controls
1.
Steering lock and ignition.
2.
Steering mounted control paddles for the
6 -speed electronic gearbox system.
3.
Wiper/screenwash/trip computer
control stalk.
4.
Speaker (tweeter).
5.
Windscreen demisting vent.
6.
Sunshine sensor.
7.
Passenger's airbag.
8.
Glove box /Audio/video sockets/
Passenger's airbag deactivation switch.
9.
Heated seat control.
10.
Lumbar massage control.
11.
Electric parking brake.
12 .
Gear lever, 6 -speed electronic gearbox
system.
13.
Large multifunctional storage unit.
Page 25 of 396
23Familiarisation
Monitoring
A.
With the ignition on, the bars indicate the
level of fuel remaining.
B.
With the engine running, its associated low
level warning lamp should go off.
C.
With the ignition on, the oil level indicator
should show for a few seconds that the
level is OK or correct, depending on
version.
If the levels are not correct, top up the levels
which are low.
Instrument panels
38
1.
With the ignition on, the orange and red
warning lamps come on.
2.
With the engine running, these warning
lamps should go off.
If warning lamps remain on, refer to the page
concerned.
Warning lamps
41
A.
Make an emergency call.
Central switch panel
173 , 2 91
B.
Access to CITROËN ser vices.
173 , 2 91
C.
Hazard warning.
172
D.
Central locking.
107
E.
Black panel (black screen).
58
Page 29 of 396
27Familiarisation
104
1.
Stop
position.
2.
Ignition on
position.
3.
Starting
position.
Ignition switch
When switching the ignition on and off, the
speedometer needle, and the rev counter and
fuel gauge bars go to the extent of their travel
and then return to 0.
Starting
Your vehicle is fitted with a system which
holds your vehicle stationary momentarily,
the time to move your foot from the brake to
the accelerator, to help with moving off on a
gradient.
This function is only active when:
- the vehicle is completely stationary with
your foot on the brake pedal,
- certain conditions of gradient are met,
- the driver's door is closed.
211
Do not get out of the vehicle during
the hill star t assist temporary holding
phase.
Hill start assist
Page 30 of 396
Driving safely
Manual application/release
Manual application
of the parking brake is
possible by pulling
the control lever A
.
With the ignition on, manual release
of the
parking brake is possible by pressing the
brake pedal
and pulling then releasing
the
control lever A
.
Electric parking brake
Automatic application/release
Press the accelerator pedal and let the clutch
pedal up (manual gearbox), the parking brake
is released automatically and progressively as
you move off.
With the vehicle at rest, on switching off
the engine the parking brake is applied
automatically.
If this warning lamp is on in the instrument
panel, the automatic application/release
is deactivated
; apply and release the
parking brake manually.
Before leaving the
vehicle, check that the
brake warning lamp in the
instrument panel and the P
warning lamp in the
control lever A
are on fixed (not flashing)
.
192
With the engine running, on opening
the driver's door there is an audible
warning; apply the parking brake
manually.
Do not leave a child alone inside the
vehicle with the ignition on; they might
release the parking brake. If you are towing a trailer or caravan or
if the slope might vary (transport on a
ferry, lorry, towing...) make a maximum
manual application with a long pull on
the control lever A
to immobilise the
vehicle.
Page 33 of 396
31Familiarisation
Stop & Start
Engine going into STOP mode
212
The "ECO"
warning lamp comes on in
the instrument panel and the engine is
put into standby automatically:
- with a manual gearbox;
at speeds below
12 mph (20 km/h), when you put the gear
lever into neutral and release the clutch
pedal,
- with the 6-speed electronic gearbox
system;
at speeds below 5 mph (8 km/h),
when you press the brake pedal or put the
gear lever in position N
.
Engine going into START mode
Deactivation/Reactivation
You can deactivate the system at any time by
pressing the "ECO OFF"
button; the button's
warning lamp comes on.
213
213
The system is reactivated automatically
every time you start the engine with
the key.
Before refuelling or doing anything
under the bonnet, you must switch off
the ignition with the key. The "ECO"
warning lamp goes off
and the engine restar ts automatically:
- with a manual gearbox;
when you fully
depress the clutch pedal,
- with the 6-speed electronic gearbox
system;
●
with the gear lever in position A
or M
,
when you release the brake pedal,
●
or gear lever in position N
and brake
pedal released, when you change to
position A
or M
,
●
or when you engage reverse.
In certain circumstances the STOP mode may
not be available; the "ECO"
warning lamp
flashes for a few seconds then goes off. In certain condition, START mode may engage
automatically; the "ECO"
warning lamp flashes
then goes off.
Driving safely
Page 40 of 396
Customisable colour instrument panel with audio system
1.
Rev counter (x 1 000 rpm or tr/min).
2.
Gear shift indicator with manual gearbox
or gear lever position and gear for the
electronic gearbox system.
3.
Analogue speedometer (mph or km/h).
4.
Cruise control or speed limiter setting.
5.
Digital speedometer (mph or km/h).
6.
Engine oil level indicator.
Dials and screens
Control buttons
7.
Ser vice indicator
(miles or km) then,
total mileage recorder.
These two functions are displayed
successively on switching on the ignition.
Lighting dimmer setting (when making an
adjustment).
8.
Trip mileage recorder (miles or km).
9.
Fuel gauge and associated low fuel
warning lamp.
10.
Range (miles or km).
A.
Dial COLOUR: customisation of the
background colour of the dials.
B.
Screen COLOUR: customisation of the
background colour of the screens.
C.
Lighting dimmer (available in night mode).
D.
Reminder of the servicing information
Reset the service indicator or the trip
mileage recorder.
Page 42 of 396
1.
Cruise control or speed limiter settings.
2.
Engine oil level indicator.
Reminder of servicing information.
These functions are displayed successively
on switching on the ignition, after the
welcome sequence and before display of
the available active functions.
Central colour screen associated with the satellite
navigation system
Rotation of the thumb wheel, located on the left
of the steering wheel, allows the permanent
display to be selected from the available
active functions (trip computer, navigation-
guidance...). Approaching the maximum engine speed, the
bars are displayed in red and flash, to indicate
to you the need to change up a gear.
Rev counter
Aler t or information messages may appear
temporarily.
Page 43 of 396
41Monitoring
Visual indicators which inform the driver of the
occurrence of a malfunction (warning lamp)
or of the operation of a system (operation or
deactivation indicator lamp).
Warning and indicator lamps
When the ignition is switched on
Cer tain warning lamps come on for a few
seconds when the ignition is switched on.
When the engine is started, these warning
lamps should go off.
If they remain on, before moving off, refer to the
information on the warning lamp in question.
Associated warnings
The illumination, fixed or flashing, of cer tain
warning lamps may be accompanied by
an audible signal and a message in the
multifunction screen or in the central colour
screen associated with the satellite navigation
system.
