Page 116 of 164
!
i
Checks
114
Bonnet
Protects the components in the front compar tment and provides access for checking levels, recharging the 12 V ancillaries battery, changing fuses, ...
)
Push the exterior safety catch B
to the left
and raise the bonnet.
)
Open the bonnet fully and on the right,
unclip the stay C
from its holder.
)
Fit the stay C
in one of the two notches
to hold the bonnet open.
)
Open the front right door.
)
Pull the interior release lever A
, located at
the bottom of the door aperture.
Opening
Closing
)
Take the stay out of the suppor t notch.
)
Clip the stay in its housing.
)
Lower the bonnet and release it at the end
of its travel.
)
Pull on the bonnet to check that it is fully
latched.
Do not press down on the middle of
the bonnet if it does not fully close, as
there is a risk of deforming it. Open
the bonnet fully and close it again.
The location of the interior release lever
prevents opening of the bonnet while
the front right door is closed.
Page 117 of 164
9
!
Checks
115
1.
Screenwash fluid reservoir.
2.
Heater fluid reser voir.
3.
Brake fluid reser voir.
4.
Ancillaries battery.
5.
Fusebox.
Front compartment
To avoid damaging electrical
components, the use of a high pressure
jet washer in the front compar tment is
strictly prohibited.
Page 120 of 164
!
i
Checks
118
The coolant level should be between
the MIN "L" and MA X "F" marks.
Coolant level
Avoid prolonged contact of used fluids
with the skin.
Most of these fluids are harmful to
health and some are very corrosive.
Do not discard used fluids into sewers
or onto the ground.
Take used fluids to a CITROËN dealer
or a qualified workshop (France) or to
an authorised waste disposal site.
Used products
Rear compartment
Changing the coolant
The coolant does not have to be changed.
Coolant specifi cation
The coolant must conform to the
manufacturer's recommendations.
As the cooling system is pressurised, wait at
least one hour after switching off the motor and/
or the end of the charge cycle before carrying
out any work.
To avoid any risk of scalding, unscrew the cap
by two turns to allow the pressure to drop.
When the pressure has dropped, remove
the cap and top up the level.
Ancillaries battery
electrolyte level
Remove the battery protective cover to check
this level (see § "ancillaries battery").
The electrolyte level should be between
the MIN "LOWER LEVEL" and MA X "UPPER
LEVEL".
If necessary, top up using distilled water by
removing the individual battery caps.
Check the electrolyte level at least once
per month.
Page 122 of 164
Technical data
120
MODEL:
MOTOR AND MAIN BATTERY
Model type code:
1 N ZK Z Z
Electric motor
Y4 F1
Te c h n o l o g y
Synchronous with neodymium permanent magnets
Max. power: EU standard (kW)
49
Max. power speed (rpm)
2 500 to 8 000
Max. torque: EU standard (Nm)
18 0
Max. torque speed (rpm)
0 to 2 500
Main battery
Lithium-Ion
Energy capacity (kWh)
16
Normal charge
Voltage (V)
220
Charging time
(
* )
(
** )
:
- 16 A
- 13 A
- 10 A
6 hours
7 hours
9 hours
Fast charge
Voltage (V)
330
Charging time (80% charge) **
30 minutes
*
Depending on the power supply in the country.
**
Time measured for ambient temperatures between 20 and 25 °C. Range varies according to the exterior climatic conditions, the driver's style of driving, the use of electrical equipment, the frequency of normal or fast
charges and ageing of the main battery.
Page 123 of 164
10
!
Technical data
121
WEIGHTS (
in
kg)
Electric motor
Y4 F1
Main battery
Lithium-Ion
Model type code:
1 N ZK Z Z
Unladen weight
1 120
Kerb weight
1 195
Gross vehicle weight (GV W)
1 450
Gross train weight (GTW)
1 450
Maximum load on the roof (including the roof bars)
43
Your vehicle cannot be fitted with a towbar. It cannot tow a trailer.
Page 128 of 164
126
EMERGENCY OR ASSISTANCE CALL
CITROËN LOCALISED EMERGENCY CALL
In an emergency, press this button for more than
2 seconds. Flashing of the green LED and a voice
message confi rm that the call has been made to the
CITROËN Emergency team * .
Pressing this button again immediately cancels the request. The green
LED goes off.
A press (at any time) of more than 8 seconds on this button, cancels the
request.
CITROËN LOCALISED ASSISTANCE CALL
When the ignition is switched on, the
green LED comes on for 3 seconds
indicating that the system is operating
correctly.
If the orange LED fl ashes: there is a
system fault.
If the orange LED is on continuously: the
backup battery must be replaced.
In either case, contact a CITROËN.
Pressing this button again immediately cancels the request.
The cancellation is confi rmed by a voice message.
Press this button for more than 2 seconds to request
assistance if the vehicle breaks down.
A voice message confi rms that the call has been made * .
OPERATION OF THE SYSTEM
The green LED remains on (without fl ashing) when communication is
established. It goes off at the end of communication.
This call is dealt with by the CITROËN Emergency team which receives
locating information from the vehicle and can send a detailed alert to the
appropriate emergency services. In countries in which the team is not
operational, or when the locating service has been expressly declined,
the call is dealt with directly by the emergency services (112) without the
vehicle location.
If an impact is detected by the airbag ECU, and independently
of the deployment of any airbags, an emergency call is made
automatically.
* These services are subject to conditions and availability.
Consult a CITROËN dealer.
If you purchased your vehicle outside the CITROËN dealer network,
we invite you to have a dealer check the confi guration of these services
and, if desired, modifi ed to suit your wishes. In a multi-lingual country,
confi guration is possible in the offi cial national language of your choice.
For technical reasons, particularly to improve the quality of Telematic
services to customers, the manufacturer reserves the right to carry out
updates to the vehicle's on-board telematic system.
If you benefi t from the CITROËN eTouch offer, you also have available
additional services in your MyCITROEN personal space, via the CITROËN
Internet website www.citroen.co.uk.
Page 129 of 164
127
The system is coded in such a way that it will only
operate in your vehicle. If it is to be installed in another
vehicle, contact your CITROËN dealer for confi guration
of the system.
AUDIO SYSTEM/BLUETOOTH
01 First steps
For safety reasons, the driver must only carry out
operations which require prolonged attention while the
vehicle is stationary.
When the motor is switched off and to prevent
discharging of the battery, the audio system may switch
off after a few minutes.
CONTENTS
02 Radio
03 Audio
04 Using the telephone
05 Audio settings
06 Configuration
07 Screen menu map
Frequently asked questions p.
p.
p.
p.
p.
p.
p.
p. 128
129
132
138
144
145
146
147
After a battery disconnection, a code has to be entered
for operation of the radio.
A maximum of fi ve attempts are possible. For the last
two attempts, a 15 minutes wait is imposed between
each attempt.
Refer to the end of this document to fi nd the label
indicating this code:
Page 151 of 164
149
FREQUENTLY ASKED QUESTIONS
QUESTION
ANSWER
SOLUTION
The CD is ejected
automatically or is not
played by the player. The CD is inserted upside down, is unplayable, does not contain any
audio data or contains an audio format which the player cannot play.
The CD is protected by an anti-pirating protection system which is not
recognised by the audio equipment.
- Check that the CD is inserted in the player the
right way up.
- Check the condition of the CD: the CD cannot
be played if it is too damaged.
- Check the content in the case of a recorded
CD: consult the advice in the "Audio" section.
- The audio equipment's CD player does not
play DVDs.
- Due to their quality level, certain writeable
CDs will not be played by the audio system.
The CD player sound is
poor. The CD used is scratched or of poor quality. Insert good quality CDs and store them in suitable
conditions.
The audio settings (bass, treble, ambience) are unsuitable. Set the treble or bass level to 0, without selecting
an ambience.
The Bluetooth connection
is cut. The battery of the peripheral may not be suffi ciently charged. Recharge the battery of the peripheral device.
The message "USB
device error" is displayed
on the screen. The USB memory stick is not recognised.
The memory stick may be corrupt. Reformat the memory stick.
A telephone connects
automatically,
disconnecting another
telephone. Automatic connection overrides manual connection. Modify the telephone settings to remove automatic
connection.
