2011 Acura TSX washer fluid

9Quick Reference Guide
Right
Low BeamHigh Beam
LeftFlashingAdjustment Ring
: Low speed: High speed
Pull toward
you to spray
washer fluid.
MIST
OFF
INT
LO
HI Turn Signal Control Lever Light Control Switches Wiper/ Washer Control Lever
Controls

P.87
Turn Signals

P.105
Lights

P.105
Wipers and Washers

P.108
* Not available on all models

15Quick Reference Guide
Wiper Blades
P.257
Replace blades if they leave
streaks across the windshield.
Lights
P.247
Inspect all lights regularly.
Tires
P.259
Inspect tires and wheels regularly. Check tire pressures regularly. Install snow tires for winter driving.
Maintenance

P.221
Under the Hood
P.229
Check engine oil, engine coolant, and windshield washer fluid.
Add when necessary. Check brake fluid and clutch fluid. Check the battery regularly.
Pull the hood release handle under the corner of the
dashboard. Locate the hood latch lever, pull the lever up, and lift up the
hood. When finished, close the hood and make sure it is firmly
locked in place.

Indicators
Multi-Information Display Warning and Information Messages
72Instrument Panel
Multi-Information Display Warning and Information Messages
Message Condition Explanation
t
"QQFBST
XIFO
UIF
FOHJOF
DPPMBOU
UFNQFSBUVSF
HFUT

abnormally high.
 Overheating P. 2 8 8
t
"QQFBST
XIFO
UIF
GVFM
mMM
DBQ
JT
MPPTF
PS
JT
OPU

installed.
 Tighten the Fuel Fill Cap P. 2 9 1
t
"QQFBST
JG
UIFSF
JT
B
QSPCMFN
XJUI
UIF
%3-
TZTUFN t
)BWF
ZPVS
WFIJDMF
DIFDLFE
CZ
B
EFBMFS
 Daytime Running Lights P.1 0 7
Canadian models
t
"QQFBST
XIFO
XBTIFS
nVJE
HFUT
MPX
t
3FmMMJOH
XBTIFS
GVJME
 Refilling Window Washer Fluid P. 2 4 6
The following messages appear only on the multi-information display. Press the
(information) button to see the message
again with the system message indicator on.

Operating the Switches Around the Steering Wheel
Wipers and Washers
108Controls
Wipers and Washers
The windshield wipers and washers can be
used when the ignition switch is in ON
II
.
MIST
The wipers run at high speed until you
release the lever. Wiper switch (OFF, INT, LO, HI)
Change the wiper switch setting according to
the amount of rain. Adjusting the delay
Turn the adjustment ring to adjust the wiper
delay.
Windshield Wipers and Washers NOTICE Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber
blades will get damaged. NOTICE In cold weather, the blades may freeze to the
windshield, becoming stuck.
Operating the wipers in this condition may
damage the wipers. Use the defroster to warm the
windshield, then turn the wipers on.
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens. When the vehicle starts moving,
the wipers make a single sweep.
The wiper operation of the shortest delay setting
(
) and the LO setting become the same when the
vehicle speeds up.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
Long delayShort delay
Washer
Sprays while you pull the lever toward you.
When you release the lever, the wipers make
two or three more sweeps before stopping.
MIST OFF INT: Low speed with
intermittent LO: Low speed wipe HI: High speed wipe Intermittent Time
Adjustment RingPull
to use
washer.

Maintenance
This chapter discusses basic maintenance.
Before Performing Maintenance
Inspection and Maintenance .............. 222
Safety When Performing
Maintenance .................................... 223
Parts and Fluids Used in
Maintenance Service ........................ 224
Maintenance Minder
™ ........................ 225
Maintenance Under the Hood
Maintenance Items Under the Hood .. 229
Opening the Hood ............................. 231
Recommended Engine Oil .................. 234
Oil Check ........................................... 235
Adding Engine Oil .............................. 237Engine Coolant .................................. 240
Transmission Fluid .............................. 242
Brake/Clutch Fluid .............................. 244
Refilling Window Washer Fluid ........... 246
Replacing Light Bulbs ......................... 247
Checking and Maintaining Wiper
Blades ................................................ 257
Checking and Maintaining Tires
Checking Tires ................................... 259
Tire and Loading Information Label .... 260
Tire Labeling ...................................... 260
DOT Tire Quality Grading
(U.S. Vehicles)
.................................... 262Wear Indicators .................................. 264
Tire Service Life .................................. 264
Tire and Wheel Replacement ............. 265
Tire Rotation ...................................... 266
Winter Tires ....................................... 267
Battery ................................................. 268
Remote Transmitter Care ................... 269
Replacing the Battery ........................ 269
Climate Control System
Maintenance ..................................... 270
Cleaning
Interior Care ........................................271
Exterior Care ...................................... 273
221

229
Maintenance Under the Hood
Maintenance
Maintenance Items Under the Hood 4-cylinder models
Brake Fluid
(Black Cap)
Engine Oil Dipstick
(Orange Handle)
Washer Fluid
(Blue Cap)
Engine Coolant
Reservoir
Radiator Cap
Manual transmission models Clutch Fluid
(Light Gray Cap)
Engine Oil Fill Cap Automatic transmission models Automatic Transmission Fluid
Dipstick (Yellow Loop)

Maintenance Under the Hood
Maintenance Items Under the Hood
230Maintenance
6-cylinder models
Engine Oil Dipstick
(Orange Loop)
Washer Fluid
(Blue Cap)
Engine Coolant
Reservoir*
Radiator Cap*
* : Located under the coverBrake Fluid
(Black Cap)
Engine Oil Fill Cap
Automatic
Transmission
Fluid Dipstick
(Yellow Loop)

Maintenance Under the Hood
Transmission Fluid
243
Maintenance
1. Park the vehicle on level ground.
2. Remove the bolts with a wrench, then
carefully remove the under cover.
3. Remove the transmission filler bolt and
washer. Carefully feel inside the bolt hole
with your fingers.
Check if the fluid level is up to the edge
of the bolt hole.
4. If the fluid level is not up to the edge
of the bolt hole, add Acura Manual
Transmission Fluid (MTF) until it runs out of
the hole.
5. Put a new washer on the filler bolt, then
reinstall the filler bolt. Tightening torque: 33 lbf∙ft (44 N∙m,
4.5 kgf∙m)
6. Reinstall the under cover with the bolts.
Manual Transmission Fluid
Check the fluid level when the engine is at normal operating temperature.Specified fluid: Acura Manual Transmission Fluid (MTF)
Manual Transmission Fluid
If Acura MTF is not available, you may use the API
certificated SAE 0W-20 or 5W-20 viscosity motor oil
as a temporary measure.
Replace with MTF as soon as possible. Motor
oil does not contain the proper additives for the
transmission and continued use can cause decreased
shifting performance and lead to transmission
damage. Under Cover
Bolt