2011 Acura TSX wheel

Checking and Maintaining Tires
Tire and Wheel Replacement
265
Maintenance
Tire and Wheel Replacement
Tire and Wheel Replacement
Replace your tires with radials of the same size, load range, speed rating, and
maximum cold tire pressure rating (as shown on the tire’s sidewall). Using tires of a
different size or construction can cause the ABS and VSA
® (vehicle stability assist)
system to work incorrectly.
It is best to replace all four tires at the same time. If that isn’t possible, replace the
front or rear tires in pairs.
If you replace a wheel, only use TPMS specified wheels approved for your vehicle.
Make sure that the wheel’s specifications match those of the original wheels.
WARNING
Installing improper tires on your vehicle
can affect handling and stability. This can
cause a crash in which you can be seriously
hurt or killed.
Always use the size and type of tires
recommended in this owner’s manual.

Checking and Maintaining Tires
Winter Tires
267
Maintenance
Winter TiresIf driving on snowy or frozen roads, mount all season marked ”M+S” tires, snow
tires, or tire chains; reduce speed; and maintain sufficient distance between
vehicles when driving.
Be particularly careful when operating the steering wheel or brakes to prevent
skidding.
Use tire chains, snow tires, or all season tires when necessary or according to the
law.
When mounting, refer to the following points.
For winter tires:
Select the size and load ranges that are the same as the original tires. t
Mount the tires to all four wheels. t
For tire chains:
Install them on the front tires only. Because your vehicle has limited tire t
clearance, Acura strongly recommends using the chains listed below:
4-cylinder models Cable-type: SCC Radial Chain SC1034 6-cylinder models Cable-type: SCC Radial Chain SC1038 Follow the chain manufacturer’s instruction when installing. Mount them as t
tightly as you can.
Check that the chains do not touch the brake lines or suspension. t
Drive slowly. t
Winter Tires NOTICE Traction devices that are the wrong size or
improperly installed can damage your vehicle's
brake lines, suspension, body, and wheels. Stop
driving if they are hitting any part of the vehicle.
When tire chains are mounted, follow the chain
manufacturer's instructions regarding vehicle
operational limits.
WARNING
Using the wrong chains, or not properly
installing chains, can damage the brake
lines and cause a crash in which you can
be seriously injured or killed.
Follow all instructions in this owner's
manual regarding the selection and use of
tire chains.

Cleaning
Exterior Care
274Maintenance
Applying Wax
A good coat of automotive body wax helps protect your vehicle’s paint from the
elements. Wax will wear off over time and expose your vehicle’s paint to the
elements, so reapply as necessary.
Maintaining the Bumpers and Other Resin Coated Parts
If you get gasoline, oil, engine coolant, or battery fluid on resin coated parts, they
may be stained or the coating may peel. Promptly wipe it away using a soft cloth
and clean water.
Cleaning the Window
Wipe using a glass cleaner.
Maintaining Aluminum Wheels
Aluminum is susceptible to deterioration caused by salt and other road
contaminants. Use a sponge and mild detergent to wipe away promptly.
Be careful not to use harsh chemicals (including some commercial wheel cleaners)
or a stiff brush. They can damage the clear coat of the aluminum alloy wheels that
helps keep the aluminum from corroding and tarnishing.
Applying Wax NOTICE Chemical solvents and strong cleaners can damage
the paint, metal, and plastic on your vehicle. Wipe
up spills immediately. Maintaining the Bumpers and Other Resin Coated Parts
Ask a dealer about the correct coating material
when you want to repair the painted surface of the
parts made of resin. Cleaning the Window
Wires are mounted to the inside of the rear window.
Wipe along the same direction as the wires with a
soft cloth so as not to damage them.

To o l s
276Handling the Unexpected
Types of Tools
Using a Jack


P. 2 8 0
Types of Tools
Wheel Nut Wrench/
Jack Handle
Jack Handle BarJack

277
If a Tire Goes Flat
Continued
Handling the Unexpected
If a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually
to reduce speed. Then, stop in a safe place. Replace the flat tire with the compact
spare tire. Go to a dealer as soon as possible to have the full size tire repaired or
replaced.
1. Park the vehicle on firm, level, and non-slippery ground. Automatic transmission models 2. Put the shift lever in P
.
Manual transmission models 2. Put the shift lever in R
.
All models 3. Set the parking brake.
4. Turn on the hazard warning lights and turn the ignition switch to LOCK 0
.
Changing a Flat Tire
Periodically check the tire pressure of the compact
spare. It should be set to the specified pressure.
Specified Pressure: 60 psi (420 kPa, 4.2 kgf/cm
2)
When driving with the compact spare tire, keep
the vehicle speed under 50 mph (80 km/h). Replace
with a full size tire as soon as possible.
The compact spare tire and wheel in your vehicle
are specifically for this model.
Do not use them with another vehicle.
Do not use another type of compact spare tire or
wheel with your vehicle.
Do not mount tire chains on a compact spare tire.
If a chain-mounted front tire goes flat, remove one
of the full-size rear tires and replace it with the
compact spare tire. Remove the flat front tire and
replace it will the full size tire that was removed
from the rear. Mount the tire chains on the front
tire.
Do not use a puncture-repairing agent on a flat tire,
as it can damage the tire pressure sensor.
Changing a Flat Tire

If a Tire Goes Flat
Changing a Flat Tire
278Handling the Unexpected
2. Take the tool case out of the trunk. Take
the jack and wheel nut wrench out of the
tool case.
3. Unscrew the wing bolt, and remove the
spacer cone. Then, remove the spare tire. 1. Pull the handle on the trunk floor lid and
open the lid. Hook the handle to the edge
of the trunk opening.
Getting Ready to Replace the Flat Tire
4. Place a wheel block or rock in front and
rear of the wheel diagonal to the flat tire.
The tire to be replaced.
Wheel
Blocks
Tool Case
Spare Tire

If a Tire Goes Flat
Changing a Flat Tire
279
Continued
Handling the Unexpected
6. Loosen each wheel nut about one turn
using the wheel nut wrench. 5. Place the compact spare tire (wheel side
up) under the vehicle body, near the tire
that needs to be replaced.

If a Tire Goes Flat
Changing a Flat Tire
280Handling the Unexpected
WARNING
The vehicle can easily roll off the jack,
seriously injuring anyone underneath.
Follow the directions for changing a tire
exactly, and never get under the vehicle
when it is supported only by the jack.
How to Set Up the Jack
How to Set Up the Jack
Do not use the jack with people or luggage in the
vehicle.
Use the jack provided in your vehicle.
Other jacks may not support the weight
("load") or
their shape may not match.
The following instructions must be followed to use
the jack safely.
Do not use while the engine is running. tUse only where the ground is firm and level. tUse only at the jacking points. tDo not get in the vehicle while using the jack. tDo not put anything on top of or underneath the tjack.
1. Place the jack under the jacking point
closest to the tire to be changed.
2. Turn the end bracket (as shown in the
image) clockwise until the top of the jack
contacts the jacking point.
Make sure that the jacking point tab is
resting in the jack notch.
3. Raise the vehicle, using the extension bar
and the jack handle, until the tire is off the
ground.
Extension Bar
Wheel Nut
Wrench as Jack
Handle