Page 65 of 324
Indicators
64Instrument Panel
Indicator Name On/Blinking Explanation Message
U.S.Canada
Parking Brake
and
Brake System
Indicator t $ P N F T P O C S J F n Z X I F O Z P V U V S O
the ignition switch to ON
II
,
then goes off (comes on when
the parking brake is applied).
t $ P N F T P O X I F O U I F C S B L F n V J E
level is low.
t $ P N F T P O J G U I F S F J T B Q S P C M F N
with the brake system.
t 5 I F C F F Q F S T P V O E T B O E U I F
indicator comes on if you drive
with the parking brake not fully
released. t Comes on while driving - Make sure
the parking brake is released. Check the
C S B L F n V J E M F W F M
What to do when it comes on while
driving P. 2 9 2
t Comes on along with the ABS
indicator - Have the vehicle checked by
a dealer.
If the Brake System Indicator Comes
On P. 2 9 2
Low Oil
Pressure
Indicator t $ P N F T P O X I F O Z P V U V S O U I F
ignition switch to ON
II
, and
goes off when the engine starts.
t $ P N F T P O X I F O U I F F O H J O F P J M
pressure is low. t Comes on during driving -
Immediately stop in a safe place.
If the Low Oil Pressure Indicator
Comes On P. 2 9 0
U.S.
Canada
Page 223 of 324
Before Performing Maintenance
222Maintenance
Inspection and MaintenanceFor your safety, perform all listed inspections and maintenance to keep your
vehicle in good condition. If you become aware of any abnormality (noise, smell,
insufficient brake fluid, oil residue on the ground, etc.), have your vehicle inspected
by a dealer. (Note, however, that service at a dealer is not mandatory to keep
your warranties in effect.) Refer to the separate maintenance booklet for detailed
maintenance and inspection information.
Types of Inspection and Maintenance Daily inspections
Perform inspections before long distance trips, when washing the vehicle, or when
refueling. Periodic inspections
Check the automatic transmission fluid level monthly. t
Automatic Transmission Fluid
P. 2 4 2
Check the brake fluid level monthly. t
Brake/Clutch Fluid
P. 2 4 4
Check the tire pressure monthly. Examine the tread for wear and foreign t
objects.
Checking and Maintaining Tires
P. 2 5 9
Check the operation of the exterior lights monthly. t
Replacing Light Bulbs
P. 2 4 7
Check the condition of the wiper blades at least every six months. t
Checking and Maintaining Wiper Blades
P. 2 5 7
Inspection and Maintenance U.S. models Maintenance, replacement, or repair of
emissions control devices and systems may be
done by any automotive repair establishment
or individuals using parts that are "certified"
to EPA standards.
According to state and federal regulations, failure
to perform maintenance on the maintenance main
items marked with # will not void your emissions
warranties. However, all maintenance services
should be performed in accordance with the
intervals indicated by the multi-information display.
Maintenance Service Items
P. 2 2 7
If you want to perform complex maintenance tasks
that require more skills and tools, purchase the
service manual.
Authorized Manual
P. 3 13
If you want to perform maintenance yourself, make
sure that you have the necessary tools and skills
first.
After performing maintenance, update the records
in the separate maintenance booklet.
Page 236 of 324
Maintenance Under the Hood
Oil Check
235
Continued
Maintenance
Oil CheckWe recommend that you check the engine oil level every time you refuel.
Park the vehicle on level ground.
Wait approximately three minutes after turning the engine off before you check
the oil.
4-cylinder models 1. Remove the dipstick (orange handle). 6-cylinder models 1. Remove the dipstick (orange loop). All models 2. Wipe the dipstick with a clean cloth or
paper towel.
3. Insert the dipstick back all the way into its
hole.
Oil Check
If it is near or below the lower mark, slowly add oil
being careful not to overfill.
6-cylinder models 4-cylinder models
Page 237 of 324
Maintenance Under the Hood
Oil Check
236Maintenance
4. Remove the dipstick again, and check the
level. It should be between the upper and
lower marks. Add oil if necessary.
4-cylinder models 6-cylinder models
Upper Mark
Upper Mark Lower Mark
Lower Mark
Page 240 of 324
Maintenance Under the Hood
Changing the Engine Oil and Oil Filter
239
Maintenance
6. Check that the filter gasket is not stuck to
the engine contact surface.
If it is stuck, you must detach it.
7. Wipe away dirt and dust adhering to the
contact surface of the engine block, and
install a new oil filter.
8. Put a new washer on the drain bolt, then
reinstall the drain bolt. Tightening torque: 29 lbf∙ft (39 N∙m, 4.0
kgf∙m)
9. Pour the recommended engine oil into the
engine. Engine oil change capacity (including
filter):
4-cylinder models 4.2 US qt (4.0 L) 6-cylinder models
4.5 US qt (4.3 L)
10. Reinstall the engine oil fill cap securely
and start the engine.
11. Run the engine for a few minutes, and
then check that there is no leak from the
drain bolt or oil filter.
12 . Stop the engine, wait for three minutes,
and then check the oil level on the
dipstick.
If necessary, add more engine oil.
Changing the Engine Oil and Oil Filter
You will need a special wrench to replace the oil
filter. You can buy this wrench from a dealer.
When installing the new oil filter follow the
instructions supplied with the oil filter.
Reinstall the engine oil fill cap. Start the engine.
The low oil pressure indicator should go off within
five seconds. If it does not, turn off the engine, and
check your work.
Oil Filter
4-cylinder models 6-cylinder models 6-cylinder models
Oil Filter Drain Bolt
Washer
Page 244 of 324
Maintenance Under the Hood
Transmission Fluid
243
Maintenance
1. Park the vehicle on level ground.
2. Remove the bolts with a wrench, then
carefully remove the under cover.
3. Remove the transmission filler bolt and
washer. Carefully feel inside the bolt hole
with your fingers.
Check if the fluid level is up to the edge
of the bolt hole.
4. If the fluid level is not up to the edge
of the bolt hole, add Acura Manual
Transmission Fluid (MTF) until it runs out of
the hole.
5. Put a new washer on the filler bolt, then
reinstall the filler bolt. Tightening torque: 33 lbf∙ft (44 N∙m,
4.5 kgf∙m)
6. Reinstall the under cover with the bolts.
Manual Transmission Fluid
Check the fluid level when the engine is at normal operating temperature.Specified fluid: Acura Manual Transmission Fluid (MTF)
Manual Transmission Fluid
If Acura MTF is not available, you may use the API
certificated SAE 0W-20 or 5W-20 viscosity motor oil
as a temporary measure.
Replace with MTF as soon as possible. Motor
oil does not contain the proper additives for the
transmission and continued use can cause decreased
shifting performance and lead to transmission
damage. Under Cover
Bolt
Page 291 of 324
Indicator, Coming On/Blinking
290Handling the Unexpected
If the Low Oil Pressure Indicator Comes On
Reasons for the indicator to come on
Comes on when the engine oil pressure is low. What to do as soon as the indicator comes on
1. Immediately park the vehicle in a safe place.
2. If necessary, turn the hazard warning lights on. What to do after parking the vehicle
1. Stop the engine and let it sit for about one minute.
2. Open the hood and check the oil level.
Add oil as necessary.
3. Start the engine and check the low oil pressure indicator. The light goes out: Start driving again. The light does not go out within 10 seconds: Stop the engine and
contact a dealer for repairs immediately.
If the Charging System Indicator Comes On
Reasons for the indicator to come on
Comes on when the battery is not being charged. What to do when the indicator comes on
Turn the climate control system, rear defogger, and other electrical
systems, and immediately contact a dealer for repairs.
If the Low Oil Pressure Indicator Comes On NOTICE Running the engine with low oil pressure can cause
serious mechanical damage almost immediately. If the Charging System Indicator Comes On
If you need to stop temporarily, do not turn off the
engine. Restarting the engine may rapidly discharge
the battery.
Page 295 of 324
Fuses
294Handling the Unexpected
If any electrical devices are not working, turn the ignition switch to LOCK 0
and
check to see if any applicable fuse is blown.
Engine Compartment Fuse Box
Located near the brake fluid reservoir. Push the tabs to open the box.
Fuse Locations
Fuse locations are shown on the fuse box cover.
Locate the fuse in question by the fuse number and
box cover number.
Circuit protected and fuse rating
Fuse Locations
Circuit Protected Amps
1Battery100 A
*1
120 A
*2
Passenger's Side Fuse Box 40A
2EPS 70 A
Passenger's Side Fuse Box (40 A)
ABS/ VSA FSR 30 A
−−
ABS/ VSA Motor 30 A
−−
Circuit Protected Amps
3IG 50 A
Driver's Side Fuse Box (40 A)
Passenger's Side Light Main 30 A
Driver's Side Fuse Box (60 A)
Driver's Side Light Main 30 A
Main Fan Motor 30 A
−
*1
−
Wiper Motor
*2
30 A
Wiper Motor
*1
Sub Fan Motor*2
30 A
4 Rear Defogger 40 A
5Sub Fan Motor
*1
20 A
−
*2
−
6− −
7− −
8 Heater Motor 40 A
9 Hazard 15 A
Circuit Protected Amps
10 H orn 10 A
11 − −
12 St o p 15 A
13 IG Coil 15 A
14 FI Sub 15 A
15 B a c ku p 10 A
16 Interior Lights 7.5 A
17 FI Main 15 A
18 DBW 15 A
19−
*1
−
Back Up FI ECU
*2
7. 5 A
20 MG Clutch 7.5 A
21Engine Oil Level
*1
7.5 A
Fan RLY
*2
*1: 4-cylinder models
*2: 6 -cylinder models
