2011.5 Citroen C4 PICASSO seat adjustment

III
69
COMFORT











Storing driving positions

System which registers the electrical
settings of the driver's seat and door
mirrors. It enables you to store and
recall two positions using the but-
tons on the side of the driver's seat.
Storing a position

Using buttons M/1/2


)
Switch on the ignition.

)
Adjust your seat and the door
mirrors.

)
Press button M
, then press but-
ton 1
or 2
within four seconds.
An audible signal indicates that
the position has been stored.
Storing a new position cancels the
previous position.
Recalling a stored position

Ignition on or engine running


)
Press button 1
or 2
to recall the
corresponding position.
An audible signal indicates the end
of the adjustment.
You can interrupt the current move-
ment by pressing button M
, 1
or 2
or
by using one of the seat controls.
A stored position cannot be recalled
while driving.
Recalling stored positions is deacti-
vated 45 seconds after switching off
the ignition.

III
70
COMFORT
REAR HEAD RESTRAINTS
The rear head restraints can be
removed and have two positions:


- high, position for use,

- low, storage position.
To raise a head restraint, pull it up-
wards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high posi-
tion, push the lug and pull it upwards.
To r efi t it, engage the head restraint
rods in the holes taking care to re-
main in line with the seat back.
SECOND ROW SEATS

Forwards-backwards adjustment

Lift the control A
, located at the front
of the seat, then move the seat to
the desired position.

"Comfort" position

The 3 second-row seats are inde-
pendent of each other and all the
same width. They all can have a
"comfort" position.

Placing a seat in the "comfort"
position


)
Pull on the control B
and guide
the seat rearwards.
The backrest reclines and the seat
base pivots slightly.


Returning the seat to the initial
position


)
Pull on the control B
and allow
the seat to come forwards.


Always supervise any movements
of seats by children. Never drive with the head restraints
removed, they must be in place
and correctly adjusted.

III
71
COMFORT
SECOND ROW SEATS(C4 PICASSO)


Folding a seat

Each seat can be folded onto the
fl oor to enable you to modify your
vehicle’s interior space.


)
Pull fi rmly upwards on strap C
,
as indicated by the red arrow, to
unlock the seat; keep pulling until
the seat is fully folded.
Push the seat backrest gently
forwards so that the backrest
folds onto the seat cushion. The
assembly lowers onto the fl oor.


Repositioning a seat



)
Raise the backrest and push it
rearwards until it locks in position

Always supervise any movements
of seats by children.


Panels behind the second
row seats

Panels below the second row seats
provide the bottom of the boot space
with rigidity. They automatically follow
the seat movements (e.g. forwards-
backwards adjustment, folding).
A storage area is available under-
neath the panels.

III
77
COMFORT





Rear view mirror

Adjustable mirror providing a central
rearward view.
Equipped with an anti-dazzle sys-
tem, which darkens the mirror glass:
this reduces the nuisance to the
driver caused by the headlamps
from following vehicles, low sun...


Manual day/night model

Adjustment


)
Adjust the mirror so that the
glass is directed correctly in the
"day" position.


Day/night position


)
Pull the lever to change to the
"night" anti-dazzle position.

)
Push the lever to change to the
normal "day" position.

By means of a sensor, which mea-
sures the light from the rear of the
vehicle, this system automatically
and progressively changes between
the day and night uses.
STEERING WHEEL ADJUSTMENT
The height and reach of the steer-
ing wheel can be adjusted to adapt
the driving position to the size of the
driver.

Adjustment



)
First, adjust the driver's seat to
the most suitable position.

)


When stationary
, pull the control
lever to unlock the steering wheel
adjustment.

)
Adjust for height and reach.

)
Push the control lever to lock the
steering wheel adjustment.
After locking, if you press fi rmly on
the steering wheel, a slight click may
be heard.

As a safety measure, the mirrors
should be adjusted to reduce the
"blind spot".







Automatic day/night model
As a safety precaution, these
operations must only be carried out
while the vehicle is stationary.
In order to ensure optimum visibility
during your manoeuvres, the mirror
lightens automatically when reverse
gear is engaged.

V
98
VISIBILITY
OF XENON HEADLAMPS
This system adjusts the height of the
xenon headlamp beams automati-
cally and when stationary, according
to the load in the vehicle, so as to
avoid causing a nuisance to other
road user.
If a malfunction occurs,
this warning lamp is dis-
played in the instrument
panel, accompanied by
an audible signal and a message in
the screen.
The system then places your head-
lamps in the lowest position.
Do not touch the xenon bulbs.
Contact a CITROËN dealer or a
qualifi ed workshop.
MANUAL HEADLAMP ADJUSTMENT

To avoid dazzling other road users,
the height of the halogen bulb head-
lamps must be adjusted according
to the load in the vehicle. To do this,
turn the control, located below the
dashboard to the right of the driver,
to the appropriate position:

0.
1 or 2 people in the front seats.

-.
3 people.

1.
4 to 7 people.

-.
Intermediate setting.

2.

4 to 7 people + maximum authorised
loads.

-.
Intermediate setting.

3.
Driver + maximum authorised
loads.

The initial setting is position "0".
EXTERIOR SIDE SPOTLAMPS

Switching on

The side spotlamps come on tempo-
rarily:


- when you unlock the vehicle,

- when you press the lighting button
on the remote control,

-
with the automatic guide-me-home
lighting, on switching off the ignition,

- when you remove the key from
the ignition,

- when you open a door,

- when you use the remote control
to locate the vehicle.

VIII
131
SAFETY
SEAT BELTS

Front seat belts

The front seat belts are fi tted with a
pretensioning system and force limiter.
This system improves safety in the front
seats in the event of a front impact.
Depending on the seriousness of the
impact, the pretensioning system in-
stantly tightens the seat belt against
the body of the occupant.
Fastening


)
Pull the belt down in front of you
in a steady movement, making
sure that it does not become
twisted.

)

Press the fastening into its buckle.

)
Check that it is properly secured
and that the automatic locking
mechanism operates correctly
by pulling sharply on the belt
strap.

)
The lap strap should be posi-
tioned as low down as possible in
the lap and as tight as possible.

)
The diagonal strap should be
positioned across the chest and
away from the neck.
Each belt has a reel that adjusts its
length automatically to the girth of
the seat occupant.

Height adjustment
The pretensioning seat belts are
active when the ignition is on.
The force limiter reduces the pres-
sure of the seat belt against the
chest of the occupant, so increasing
his protection.

When correctly adjusted, the seat
belt shoulder strap falls over the
middle of the shoulder.


)
To adjust the belt, squeeze the
control and slide it in the direc-
tion required.



Unfastening


)
To unfasten the belt, press on
the red button in the buckle.
The belt retracts automatically when
not in use.

VIII
134
SAFETY





The driver must ensure that passen-
gers use the seat belts correctly and
that they are all restrained securely
before setting off.
Wherever you are seated in the ve-
hicle, always fasten your seat belt,
even for short journeys.
Do not interchange the seat belt
buckles as they will not fulfi l their
role fully.
The seat belts are fi tted with an inertia
reel permitting automatic adjustment
of the length of the strap to your size.
The seat belt is stowed automatically
when not in use.
Before and after use, ensure that the
seat belt is reeled in correctly.
The lower part of the strap must be
positioned as low as possible on the
pelvis.
The upper part must be positioned
in the hollow of the shoulder.
The inertia reels are fi tted with an
automatic locking device which
comes into operation in the event
of a collision, emergency braking or
if the vehicle rolls over. You can re-
lease the device by pulling fi rmly on
the strap and releasing it so that it
reels in slightly. In order to be effective, a seat belt
must:


- be tightened as close to the body
as possible,

- be pulled in front of you with a
smooth movement, checking
that it does not twist,

-
be used to restrain only one person,

- not bear any trace of cuts or fraying,


- not be converted or modifi ed to
avoid affecting its performance.
Recommendations for children
Use a suitable child seat if the pas-
senger is less than 12 years old or
shorter than one and a half metres.
Never use the same seat belt to se-
cure more than one person.
Never allow a child to travel on your
lap.
In accordance with current safety
regulations, for all repairs on your
vehicle, go to a qualifi ed workshop
with the skills and equipment need-
ed, which a CITROËN dealer is able
to provide.
Have your seat belts checked regu-
larly by a CITROËN dealer or a
qualifi ed workshop, particularly if the
straps show signs of damage.
Clean the seat belt straps with soapy
water or a textile cleaning product,
sold by CITROËN dealers.
After folding or moving a seat or rear
bench seat, ensure that the seat belt
is positioned and reeled in correctly.
In the event of an impact

Depending on the nature and se-
riousness of the impact
, the pre-
tensioning device may be deployed
before and independently of the
airbags. Deployment of the preten-
sioners is accompanied by a slight
discharge of harmless smoke and
a noise, due to the activation of the
pyrotechnic cartridge incorporated
in the system.
In all cases, the airbag warning lamp
comes on.
Following an impact, have the seat
belts system checked, and if neces-
sary replaced, by a CITROËN dealer
or a qualifi ed workshop.

XI
198
PRACTICAL INFORMATION

Access to the fuses


)
Open the glove box.

)
Undo the screw by a quarter turn
and pivot the housing.

Table of fuses



Fuse N°



Rating



Functions




F1



15 A

Rear screen wipe


F2



30 A

Locking and unlocking earth


F3



5 A

Airbags and pretensioners


F4



10 A

Multimedia, photochromic rear view mirror, particle
fi lter, diagnostic socket, air conditioning, manual
headlamp height adjustment


F5



30 A

Front windows, front door electronic control panel,
panoramic sunroof


F6



30 A

Rear windows


F7



5 A

Interior lamps, cooled glove box, radio


F8



20 A

Multifunction screen, radio, steering mounted
controls, multimedia, defl ation detection, alarm,
trailer


F9



30 A

Multimedia, front 12 V sockets, torch, radio


F10



15 A

Height corrector (suspension)


F11



15 A

Brake switch, ignition switch


F12



15 A

Parking sensors, automatic screen wipe and
lighting, passenger’s electric seat, lane departure
warning system, Hi-Fi amplifi er, trailer


F13



5 A

Engine relay unit (BSM), driver’s electric seat


F14



15 A

Air conditioning, Bluetooth
®
hands-free kit,
automatic gearbox lever, airbags, instrument panel


F15



30 A

Locking and unlocking


F16



-

SHUNT


F17



40 A

Heated rear screen


Fuses under the dashboard