2011.5 Citroen C4 AIRCROSS RHD ignition

74
Access
Locking the vehicle with
perimeter monitoring only
Deactivate the interior volumetric and tiltmonitoring to avoid unwanted triggering of thealarm in cer tain cases, such as:
- an animal left in the vehicle,
- a window left par tly open,
- washing your vehicle.


Deactivation of the interior volumetric and tilt monitoring

Raise and hold the wiper control stalk in the
" MIST " position for about three seconds to
activate them again, the audible signal sounds
twice.
) Switch off the ignition and remove thekey from the ignition switch (OFF mode if your vehicle has the "Keyless Entry andStarting" system). )
Raise and hold the wiper control stalk in
the "MIST"
position for about 3 seconds. )
The audible signal sounds once
and the
interior volumetric and tilt monitoring are
deactivated.

75
2
Access

Tr iggering of the alarm


This is indicated by sounding of the siren andflashing of the direction indicators for thirtyseconds.
A message then appears in the instrument
panel screen while the siren is operating.
When the ignition is next switched on (ONmode if your vehicle has the "Keyless Entry and Starting" system), an audible signal sounds four
times to inform you that the alarm was triggeredduring your absence.
Complete deactivation of
the alarm
)
Switch off the ignition (OFF mode if your vehicle has the "Keyless Entry andStarting" system). )
Remove the key from the ignition switch,
if your vehicle does not have the "Keyless
Entry and Star ting" system.) Open the driver's door. )
Place the lighting control stalk in the "OFF"position. )
Pull the wiper control stalk towards you and
hold.
After about ten seconds there is an audible signal.) When the audible signal stops, continue to
hold the wiper stalk pulled towards you and
press the remote control locking button.
You can completely deactivate the alarm
system. To do this, proceed as follows:
) The state of the system is then signalled to you by the number of beeps:
One beep: the alarm system is completely deactivated.
Two beeps: the alarm system is activated.
Each new press of the remote control
lockin
g button changes the state of thesystem.
It is possible to adjust the sensitivity
of the alarm sensor and to deactivatethe function via the colour screen"Equipment" menu.

76
Access








Electric windows
System which opens or closes a windowmanually or automatically. It is fitted witha system which provides protection if anobstacle is detected on one-touch models and
a deactivation system to prevent misuse of therear controls.


Front and rear passengers'
electric windows
)
With the ignition on, press or pull the switch. The window stops when you
release the switch.


Safety anti-pinch (driver's side)
In automatic mode, when the window rises and meets an obstacle, it stops and lowers again.


The electric window switchesremain operational for approximately30 seconds after the ignition is switchedoff. The windows can no longer be openedor closed once a front door is opened.
The rear windows do not lower fully.
1.Driver's electric window.2.Passenger's electric window.3.Rear right electric window.4.Rear left electric window.5.Deactivating the passenger and rear
electric window switches.

Driver's one-touch electric
w
indow
With the ignition on, you have two options:

-
manual mode)
Press the switch gently to open or pull
it gently to close. The window stops assoon as the switch is released.



- automatic mode)
Press the switch fully to open or pull
it fully to close. The window opens or closes completely when the switch is
r
eleased. ) Pressing the switch again stops the
movement of the window.

77
2
Access

Deactivating the passenger
and rear electric window
switches
Reinitialisin
g the electric
w
indows
When the button is pressed down, onlythe window in the driver's door operates.


Always remove the key from the ignitionwhen leaving the vehicle, even for ashort time. In the event of contact during operation of the windows, you must reverse themovement of the window. To do this, press the switch concerned.When the driver operates the passenger electric window switches, they must ensure that no one is preventing correctclosing of the windows. The driver must ensure that passengers use the electric windows correctly.Be aware of children when operating the windows.
)
For the safety of your children, press switch5
to prevent operation of the passenger
and rear electric windows irrespective of
their position. Fr
om the switch in the driver's door:)pull the switch until the window is fully closed, then release it,)pull the switch again for at least one second after reaching the window closedposition.The safety anti-pinch function is not activeduring these operations.


When the button is pressed down, the switchesare deactivated.
When the button is up, the switches are activated.
Should there be no automatic movement of a window when rising or after the safety anti-pinch has been triggered three times in succession, the electric windows must be reinitialised.

78
Access








Panoramic sunroof It has a motorised blind.
Motorised blind
With the ignition on, there are two ways of
opening or closing the blind:
)Briefly pull or push the control in direction 1or 2 , the blind stops when you release thecontrol.)Maintain pressure on the control in direction 1or 2until movement starts, the
blind then opens or closes fully.


Stopping temporarily
)
To stop the opening or closing of the blind,
press par
t 3 of the control or reverse themovement of the control.



Safety anti-pinch

At the end of its travel, if the blind encounters
an obstacle to closing, it stops and moves back
slightly.

Remember to always switch off theignition when leaving the vehicle, even for a short time. When operating the control, the driver should ensure that there is nothing preventing movement of the blind.
The driver must ensure that passengersuse the blind correctly.
Be aware of children when operating the blind.

85
3
Comfort





Mirrors
Adjustment is possible when the ignition switch
is in the "ON" or "ACC" position.) Move control Ato the right or to the left toselect the corresponding mirror.)
Move control Bin all four directions toadjust.
)
Return control A
to the central position. Each
fitted with an adjustable mirror glass permitting the lateral rearward vision necessary for overtaking or parking. They can also be folded for parking in confined spaces.
Demisting - Defrosting


Door mirrors

If your vehicle is fitted with heated
mirrors, the demisting-defrosting operates with the engine running, byswitching on the heated rear screen
(see "Rear screen demist-defrost").
The objects observed are, in reality,closer than they appear. Ta k e this into account in order tocorrectly judge the distance of vehiclesapproaching from behind.

86
Comfort
From the outside:) by locking or unlocking the vehicle,using the remote control or the locking / unlocking buttons (for vehicles fitted with
the "Keyless Entry and Starting" system).



If you have folded the mirrors using thecontrol C
, you must use this control tounfold them, other wise the mirrors will not be lock in place correctly.
Some mirror functions (in particular the automatic folding and unfolding of the door mirrors) can be configured via thecolour screen "Equipment" menu.
The mirrors can also be foldedmanually. From inside:
- with the i
gnition switch in the "ON" or "ACC" position, by pressing the control C,
- with the ignition switch in the "LOCK"
position, by pressing control C, within30 seconds.

94
Comfort

Personalisation of theExterior air intake / Interior air recirculation function

This function is controlled automatically.However, you can deactivate its automatic control if you wish to change the air intake
mode at any time.

Changing the status

Press the Air intake / Interior air recirculation button for at least 10 seconds.
When the status chan
ges from active to
inactive, three bleeps are heard and the
indicator lamp
flashes three times.
When the status changes from inactive to
active, two bleeps are heard and the indicator lamp flashes three times.
Automatic control active

If the air distribution adjustment dial and the air flow adjustment dial are placed in the "AUTO" position, the Air intake / Interior air recirculation
function is also controlled automatically.

Automatic control inactive

Even if the air distribution adjustment dial and
the air flow adjustment dial are placed in the
"AUT
O" position, the Air intake / Interior air
recirculation function is no longer controlled
automatically.
The settings are retained, even after switching
off the ignition.
4. Intake of exterior air /
Recirculation of interior air
This function insulates the passenger compartment from exterior odours and smoke.
) Press button 4to select the air intake mode.
When the indicator lamp on button 4
is off, the exterior air intake function is on.
When the indicator lamp on button 4 is on, the
intake of exterior air is off and the system is in air recirculation mode.
Do not drive for long periods in interior air recirculation mode, except in truly exceptional atmospheric conditions.