2010 TOYOTA PRIUS light

5
When trouble arises
517
5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
Have the malfunction repaired immediately.
After taking the specified steps to correct the suspected problem,
check that the warning message and light turn off.
Interior buzzerExterior buzzerWarning messageDetailsCorrection procedure
Once 
(Comes on for 10 seconds.)
(Flashing) The electronic
key is not
detected when
attempting to
start the hybrid
system.
Confirm
the loca-
tion of the
electronic
key.
Once 3 times (Flashing)An open door
other than the
driver’s door is
closed while the
electronic key is
outside the
detection range
and the
“POWER”
switch is in
ACCESSORY
or ON mode.
Confirm
the loca-
tion of the
electronic
key.

522 5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
InteriorbuzzerExterior buzzerWarning messageDetailsCorrection procedure
Once 
(Flashing)The elec-
tronic key
does not
operate
properly.
P. 542
 Power
was
turned off
due to
the auto-
matic
power off
function.Next time when
starting the
hybrid system,
increase the
engine speed
slightly and
maintain that
level for approxi-
mately 5 min-
utes to recharge
the battery.
■ Changing the engine oil
Make sure to reset oil change system.

5
When trouble arises
525
5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
■
Compact spare tire
The compact spare tire saves space in your luggage compart-
ment, and its lighter weight helps to enhance fuel economy and
permits easier installation in case of a flat tire.
The compact spare tire is
designed for temporary emer-
gency use only.

528 5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.Vehicles with a 15 inch wheel,
remove the wheel ornament
using the wrench.
To protect the wheel ornament,
place a rag between the wrench
and the wheel ornament, as
shown in the illustration.
Slightly loosen the wheel nuts
(one turn).
Turn the tire jack portion “A” by
hand until the notch of the jack is
in contact with the jack point.
Raise the vehicle until the tire is
slightly raised off the ground.
ITO52P167
STEP2
ITO52P108
STEP3
ITO52P110
STEP4
ITO52P112
STEP5

5
When trouble arises
533
5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
■
When using the compact spare tire
As the compact spare tire is not equipped with the tire pressure warning
valve and transmitter, low inflation pressure of the spare tire will not be
warned. Also, if you replace the compac t spare tire after the tire pressure
warning light comes on, the light remains on.
■ If you have a flat front tire on a road covered with snow or ice
Install the compact spare tire on the rear of the vehicle. Perform the fol-
lowing steps and fit tire chains to the front tires.
Replace a rear tire with the compact spare tire.
Replace the flat front tire with t he tire removed from the rear of
the vehicle.
Fit tire chains to the front tires.
■After completing the tire change
The tire pressure warning system must be reset. (P. 442)
■Jack point guide
STEP1
STEP2
STEP3
The jack point guides are located under
the rocker panel. They indicate the jack
point positions.

538
5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
If the hybrid system will not start
If the hybrid system still does not start after following the correct
starting procedure (
P. 164), confirm the following points.
■ The hybrid system will not start even if you are carrying the
correct key.
One of the following may be the cause of the problem.
●There may not be sufficient fuel in the vehicle’s tank. 
Refuel the vehicle.
● The electronic key battery may be discharged. ( P. 541)
● The hybrid system may be malfunct ioning due to an electrical
problem such as an open circuit or a blown fuse. However,
depending on the type of malfunc tion, an interim measure is
available to start the hybrid system. ( P. 539)
● There may be a malfunction in the immobilizer system. 
( P. 108)
■ The interior lights and headlight s are dim, or the horn does
not sound or sounds at a low volume.
One of the following may be the cause of the problem.
● The 12 volt battery may be discharged. ( P. 543)
● The 12 volt battery terminal c onnections may be loose or cor-
roded.

5
When trouble arises
539
5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
Emergency start function
When the hybrid system does not start, the following steps can be
used as an interim measure to st art the hybrid system if the
“POWER” switch is functioning normally.
Set the parking brake.
Set the “POWER” switch to the ACCESSORY mode.
Push and hold the “POWER” switch for about 15 seconds
while depressing the brake pedal firmly.
Even if the hybrid system can be started using the above steps, the
system may be malfunctioning. Ha ve the vehicle checked by your
Toyota dealer.
■ The interior lights and headlights do not turn on, or the horn
does not sound.
One of the following may be the cause of the problem.
●One or both of the 12 volt ba ttery terminals may be discon-
nected.
● The 12 volt battery may be discharged. ( P. 543)
Contact your Toyota dealer if the problem cannot be repaired, or if
repair procedures are unknown.
STEP1
STEP2
STEP3

5
When trouble arises
545
5-2. Steps to take in an emergency
PRIUS_U (OM47668U) U.S.A.
■
Starting the hybrid system when the 12 volt battery is discharged
The hybrid system cannot be started by push-starting. In addition, the shift
position may not changed from “P”.
■ Avoiding a discharged 12 volt battery
● Turn off the headlights and the audio system while the hybrid system is
turned off.
● Turn off any unnecessary electrical components when the vehicle is run-
ning at a low speed for an extended period, such as in heavy traffic, etc.
■ When the 12 volt battery is removed or discharged
The hybrid system may not start. (
P. 438)
Start the engine of the second vehicle. Increase the engine
speed slightly and maintain at that level for approximately 5
minutes to recharge the 12 volt battery of your vehicle.
Turn the “POWER” switch to ACCESSORY mode.
Maintain the engine speed on the second vehicle and turn
the “POWER” switch to ON mode, then start your vehicle’s
hybrid system.
Make sure the “READY” indicator comes on. If the indicator
does not come on, contact your Toyota dealer.
Once the vehicle’s hybrid syst em has started, remove the
jumper cables in the exact reverse order in which they were
connected.
Once the hybrid system starts, ha ve the vehicle checked at your
Toyota dealer as soon as possible.STEP4
STEP5
STEP6
STEP7
STEP8