2010 SKODA OCTAVIA TOUR technical data

Fuses and light bulbs175
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Low beam lightFig. 149 Replacing the cover for the lamps of th e parking- and low-beam light / removing the
bulb for the low-beam lightRemoving the light bulb for the low beam light– Switch the ignition and all lights off.
– Remove the headlight page 174.
– Press the wire clamps in the direction of arrow to the side and remove the cover
 fig. 149 - left.
– Unplug plug .
– Press the wire clamps in the directio n of the headlight and then unhook them
to the side.
– Remove the light bulb and insert the new light bulb in such a way that the fixing
lugs of the light bulb socket fit into the recesses at the reflector.
Installation takes place in the reverse order.
Note
After installing the headlight, the headligh t setting must be checked by a specialist
garage.
Main beam lightFig. 150 Protective cover for the bulb for the main beam light / removing the bulb for the
main beam lightRemoving the light bulb for the main beam light– Switch the ignition and all lights off.
– Remove the headlight page 174.
– Remove the protective cover from the rear par of the headlight fig. 150 - left.
– Unplug plug .
– Press the wire clamps in the directio n of the headlight and then unhook them
to the side.
– Remove the light bulb and insert the new light bulb in such a way that the fixing lugs of the light bulb socket fit into the recesses at the reflector.
Installation takes place in the reverse order.
Note
After installing the headlight, the headligh t setting must be checked by a specialist
garage.
AA
ABAC
AA
ABAC
s2bs.2.book Page 175 Monday, September 27, 2010 9:53 AM

Fuses and light bulbs177
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Rear light unit (Combi)Fig. 153 Luggage compartment: Cover for th e lamp holder / removing lamp holdersChanging light bulbs in the lamp holder– Switch the ignition and all lights off.
– Open the lamp holder cover fig. 153 - left.
– Take out the light bulbs from the parking light (arrow and ).
– Press the catches in the direction of arrow and take out the lamp holder fig. 153
- right.
– Press the defective light bulb into th e socket, turn to the left and remove.
– Press a new light bulb into the socket and turn the light bulb to the right as far as
the stop.
– Insert the lamp holder in such a way that the catches lock in place in the housing.
– Put the light bulbs from the park ing light (arrow and ) back in.
– Close the cover of the lamp holder.Change the light bulb for the parking light– Switch the ignition and all lights off.
– Open the lamp holder cover fig. 153 - left.
– Take the defective light bulb (arrow or ) out of the light housing and replace
it with a new one of the same type.
– Close the cover of the lamp holder.
A1
A2
A1
A2
A1
A2
s2bs.2.book Page 177 Monday, September 27, 2010 9:53 AM

Technical Data179
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Te c h n i c a l D a t aTechnical DataGeneral informationThe details given in the official vehicle regi stration documents always take precedence
over the details in the Owner's Manual. Please refer to the official vehicle registration
documents or consult an authorised Škoda Service Partner concerning the engine with
which your vehicle is equipped.Used abbreviationsPerformancesThe listed performance values were determined without performance-reducing
equipment, e.g. air conditioning system.
WeightThe loading capacity is reduced in line with the range of the special equipment. The
unloaden weight contains a fuel tank topped up to 90 %. A driver with a weight of 75
kg is also includ ed in the value.Identification detailsVehicle data sticker
The vehicle data sticker fig. 154 is located on the floor of the luggage compartment
and is also stated in the Service schedule.
The vehicle data sticker co ntains the following data:
Vehicle identification number (VIN)
Vehicle type
Gearbox code, paint number, interior eq uipment number, engine output, engine
code
Partial description of the vehicle
Abbreviation
Importance
kW
Kilowatt, measuring unit for the engine output
rpm
Engine revolutions per minute
Nm
Newton meter, measuring unit for the engine torque
g/km
discharged quantity of carbon dioxide in grams per driven
kilometre
TDI CR
Diesel engine with turbocharger and injection system Com-
mon Rail
Fig. 154 Vehicle data sticker
A1A2A3A4
s2bs.2.book Page 179 Monday, September 27, 2010 9:53 AM

Technical Data
180
Vehicle identification number (VIN)
The vehicle identification num ber - VIN (chassis number) is stamped into the engine
compartment on the right hand shock absorb er dome. This number is also located on
a sign on the lower left hand edge below the windscreen.
Engine number
The engine number is stam ped into the engine block.
Type plate (production plate)
The type plate is located in the lowe r area of the left centre column.
Sticker on inside of fuel filler flap
The stickers are affixed to the inside of the fuel filler flap and contain the following
information:
The prescribed types of fuel,

Ty re s i z e ,

Tyre pressure.
Fuel consumption based on ECE regulations and EC guidelinesDepending on the range of the special equipment, style of driving, traffic situation,
weather influences and vehicl e condition, the consumption values which in practice
result when using the vehicle can deviate from the indicated values.
Urban traffic
The consumption measurement in urban traffic begins with starting of the cold engine.
Afterwards the normal ur ban traffic is simulated.
Non-urban traffic
For the consumption measurement in non-ur ban traffic the vehicle, as in daily
motoring, is accelerated and braked severa l times in all gears. The vehicle speed
changes within the range from 0 to 120 km/h. Combined traffic
The consumption value in the combined traffic consists of 37 % from the value for the
urban traffic and of 63 % from th
e value for the non-urban traffic.
DimensionsDimensions (mm)Engine oil specificationsThe grade of engine oil should be selected in accordance with precise
specifications.The engine of your vehicle has been factory-filled with a high-grade oil which you can
use throughout the year - except in extreme climatic regions.
You can mix various oils together with each ot her when refilling with oil. This does not,
however, apply for models with flexible service intervals (QG1).
Engine oils are, of course, undergoing continuous further development. Thus the
information stated in this Owner's Manual is only correct at the time of publication.
OCTAVIA
COMBI
Length
4572
4572
Width
1769
1769
Width including exterior mirror
2018
2018
Height
1462
1485
a)
a)The value corresponds to the status with rough road package.
1468
1490
a)
Clearance
140
164a)
140
164a)
Wheel base
2578
2578
Tr a c k g a u g e f r o n t / r e a r
1541/1514
1541/1514
s2bs.2.book Page 180 Monday, September 27, 2010 9:53 AM

Technical Data181
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Authorised Škoda Service Partners are inform
ed by Škoda Auto about current changes.
This why you should always have engine oi l changed by an authorised Škoda Service
Par tner.
The specifications (VW standards) stated in the following must be indicated separately
or together with other specifications on the bottle.
Engine oil specifications for models with flexible service intervals (QG1)
Engine oil specifications for vehicles with fixed service intervals (QG2)
If the oils specified above are not available, oils according to ACEA A2 or ACEA A3 can
be used once for refilling. ACEA A3.
If the oils specified above are not available, oils according to ACEA B3 or ACEA B4 can
be used once for refilling.
Caution
Only the previously-mentioned oils may be used on vehicles with flexible service inter-
vals (QG1). We recommend always refilling with oil of the same specification since this
will maintain the properties of the oil. In ex ceptional cases, you must top up only once
engine oil complying with Specification VW 502 00 (only for petrol engines) or Specifi-
cation VW 505 01 (only for diesel engines) to maximum 0.5 litres. You must not use
other engine oils - risk of engine damage!
Note

Before a long drive we recommend that you purchase and carry with you engine
oil which complies with the specification for your vehicle. Consequently, you will
always have the correct engine oil for refilling.

We recommend using a preser vative from the Škoda original accessories offered
by your Škoda dealer.

For further information - see Service schedule.
Petrol engines
Specification
Filling level
a)
a)Oil capacity with oil filter change. Inspect oil leve l when filling; do not fill up too much. The oil
level must be between the markings page 141.1.4 ltr./59 kW - EU5
VW 503 00, VW 504 00
3,2
1.6 ltr./75 kW - EU4, EU2
VW 503 00, VW 504 00
4,5
Diesel engine
Specification
Filling level
a)
2.0 l/81 kW TDI CR EU4
VW 507 00
4,3
Petrol engines
Specification
Filling level
a)
a)Oil capacity with oil filter change. Inspect oil leve l when filling; do not fill up too much. The oil
level must be between the markings page 141.1.4 ltr./59 kW - EU5
VW 501 01, VW 502 00
3,2
1.6 ltr./75 kW - EU4, EU2
VW 501 01, VW 502 00
4,5
Diesel engine
Specification
Filling level
a)
2.0 l/81 kW TDI CR EU4
VW 507 00
4,3
s2bs.2.book Page 181 Monday, September 27, 2010 9:53 AM

Technical Data
182
1.4 ltr./59 kW - EU5Engine
Performances
Fuel consumption (in ltr./100 km) and CO
2 emission (in g/km)
Power output
kW per rpm
59/5000
Maximum torque
Nm per rpm
132/3800
Number of cylinders/Displacement (cm
3)
4/1390
OCTAVIA
CO M B I
Maximum speed
km/h
174
172
Acceleration 0 - 100 km/h
s
14,3
14,4
OCTAVIA
COMBI
Urban
8,5
8,5
Ex-urban
5,1
5,1
combined
6,4
6,4
CO2 emissions combined
149
149
s2bs.2.book Page 182 Monday, September 27, 2010 9:53 AM

Technical Data183
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Weight (in kg)
OCTAVIA
COMBI
Permissible gross weight
1740
1745
Unladen weight ready for operation
1245
1260
Loading capacity
570
560
Loading capacity when using the TLC
495
485
Max. permissible gross weight per front axle
860
860
Max. permissible gross weight per rear axle
910
920
Permissible trailer loads, trailer braked
900
a)
1100
b)
a)Uphills up to 12 %b)Uphills up to 8 %
900
a)
1100
b)
Permissible trailer loads, trailer unbraked
600
600
s2bs.2.book Page 183 Monday,
September 27, 2010 9:53 AM

Technical Data
184
1.6ltr./75kW - EU4, EU2Engine
Performances
Fuel consumption (in ltr./100 km) and CO
2 emission (in g/km)
Power output
kW per rpm
75/5600
Maximum torque
Nm per rpm
148/3800
Number of cylinders/Displacement (cm
3)
4/1595
OCTAVIA
COMBI
Maximum speed
km/h
190
189
Acceleration 0 - 100 km/h
s
12,3
12,4
OCTAVIA
COMBI
Urban
9,6/10,0
a)
a)EU4, EU2
9,7/10,0
a)
Ex-urban
5,5/5,8
a)
5,6/5,8
a)
combined
7,1/7,4
a)
7,2/7,4
a)
CO2 emissions combined
166/176
a)
168/176
a)
s2bs.2.book Page 184 Monday, September 27, 2010 9:53 AM