Instruments and warning lights
15
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Instruments and warning lightsOverview of the instrument cluster
Engine revolutions counter
page 15
Display with counter for distance driven
page 17
with Service Interval Display
page 17
with digital clock
page 18
with Multi-functional indicator*
page 19
with Information display*
page 22
Speedometer
page 16
Coolant temperature gauge*
page 16
Button for display mode: Set hours / minutes Activating / deactivating the second speed in mph or km/h* Service interval - Display of the remaining number of days, kilometres or miles to the next Inspection Service / Reset*
1)
Button for: Reset trip counter for distance driven Resetting Service
Interval Display
Set hours / minutes Activate / deactivate display mode Fuel gauge*
page 16
Engine revolutions counterThe red zone of the rev counter scale
fig. 15
indicates the range in which the
engine control unit begins to limit the engi
ne speed. The engine
control unit restricts
the engine speed to a steady limit value.
Fig. 15 Instrument cluster
A1A2A3A4A5
1)Valid for countries where the values ar
e indicated in British measuring units.
A6A7
A1
s3j8.a.book Page 15 Tuesday, April 20, 2010 1:10 PM
Instruments and warning lights
18On vehicles which are equipped with inform
ation display*, you ca
n call up this infor-
mation in the menu
SETUP
page 23.
The following will be displayed in the information display* for 10 seconds:
Service in ... km or ... days
Resetting Service Interval Display It is only possible to reset the Service Interval Display, if a service message or at least a pre-warning is shown on the display of the instrument cluster. We recommend having this resetting performed by a specialist garage.The specialist garage:
resets the memory of the display after the appropriate inspection;
makes an entry in the Service schedule;
affix the sticker with the entry of the following service interval to the side of the
dash panel on the driver's side. Reset the service interval displays by using the reset button
page 15 on the trip
counter. On vehicles which are equipped with inform
ation display*, you ca
n call up this infor-
mation in the menu
SETUP
page 23.
Caution
We recommend that you do not reset the Se
rvice Interval Display
yourself otherwise
this can result in the service interval display being incorrectly set, which may also result in problems with operation of your vehicle.
Note
Never reset the display between service intervals otherwise this may result in
incorrect readouts.
information is retained in the Service Interval Display also after the battery of the
vehicle is disconnected.
If the instrument cluster is exchanged af
ter a repair, the correct values must be
entered in the counter for the Service Interval Display. This work is carried out by a specialist garage.
The data displayed is the same after resetting the display with flexible service inter-
vals (QG1) using the reset button as that for a vehicle with fixed service intervals (QG2). We therefore recommend having the Service In
terval Display reset
only by an author-
ised Škoda Service Partner who is familiar with the procedure for resetting the display with a vehicle system tester.
Please refer to the brochure Service schedule for extensive information about the
service intervals.Digital clockThe time is set with the buttons and
page 15, fig. 15
.
Select the display which you wish to ch
ange with the button and carry out the
change with the button . On vehicles which are fitted out with the information display*, it is possible to set the time in the menu
Time
page 24.
WARNING
The clock should not be adjusted while driving for safety reasons but only when the vehicle is stationary!Shift recommendation for changing gears*An information for the engaged gear
fig. 17
is shown in the display of the instru-
ment cluster.
A6
A5
A6
A5
A6
Fig. 17 Shift recommendation for changing gears
AA
s3j8.a.book Page 18 Tuesday, April 20, 2010 1:10 PM
