2010 Peugeot 207 CC Owner's Manual

i
i
PRACTICAL INFORMATION
127
CHANGING A BULB
Procedure for replacing a faulty bulb
with a new bulb without the use of
tools.
1. Direction indicators
(PY21W amber).

2. Sidelamps (W5W).

3. Dipped beam headlamps
(H7-55W).

4. Main beam headlamps (H1-55W).

5. Directional headlamps (H7-55W).

6. Foglamps (H11-55W). Changing the direction indicator
bulbs

 Do not touch the bulb directly
with your fi ngers, use lint-free
cloths.
Changing a halogen bulb should
only be done after the headlamp
has been switched off for a few
minutes (risk of serious burns).
It is imperative to use only anti-ul-
traviolet (UV) type bulbs in order
not to damage the headlamp. Model with conventi
onal lamps
Amber coloured bulbs, such as
the direction indicators, must be
replaced with bulbs of identical
specifi cation and colour.

 Turn the bulb holder one quarter of
a turn and remove it.

 Pull the bulb then change it.
To refi t, carry out these operations in
reverse order.
The headlamps are fi tted with polycar-
bonate glass with a protective coating:

 do not clean them using a dry or
abrasive cloth, nor with a deter-
gent or solvent product,

 use a sponge and soapy water,

 when using a high pressure washer
on persistent marks, do not direct
at the lamps or their outlines for too
long, so as not to damage their pro-
tective coating and seals. Model with elliptical module dipped
beam headlamps and directional
headlamps
Front lamps

PRACTICAL INFORMATION
128
Changing the integrated direction
indicator side repeaters
Changing the foglamp bulbs
For replacement of these bulbs, contact
a PEUGEOT dealer.

 Insert a screwdriver towards the
centre of the repeater between the
repeater and the base of the mirror.

 Tilt the screwdriver to extract the
repeater and remove the repeater.

 Disconnect the repeater connector.
To refi t, carry out these operations in
reverse order.
To obtain a replacement repeater, contact
a PEUGEOT dealer.
Changing the sidelamp bulbs

 Disconnect the main headlamp con-
nector.

 Remove the plastic protective cover
by pulling on the tab.

 Turn the bulb holder one quarter of
a turn and remove it.

 Pull the bulb and change it.
To refi t, carry out these operations in
reverse order.
Changing the dipped, main beam or
directional headlamp bulbs

 Disconnect the main headlamp
connector.

 Remove the corresponding plastic
protective cover by pulling on the tab.

 Disconnect the connector of the
corresponding lamp.

 Move aside the spring to release the
bulb and remove the bulb.
To refi t, carry out these operations in
reverse order.

i
PRACTICAL INFORMATION
129
Rear lamps

1. Brake
lamps
(P 21 W).

2. Sidelamps
(diodes).

3. Foglamps
(P 21 W).

4. Direction indicators
(PY 21 W amber).

5. Reversing
lamps
(R 10 W). Changing bulbs
These bulbs (with the exception of the diode
lamps) are changed from outside the boot:

 fi rst open the fl ap to gain access to
the fi xing bolt,

 remove the lamp fi xing bolt,

 remove the lamp from the outside,

 disconnect the lamp connector,

 remove the lamp seal,

 press the four tabs and remove the
bulb holder,

 turn the bulb one quarter of a turn
and change it.
To refi t, carry out these operations in
reverse order.
Amber coloured bulbs, such as
the direction indicators, must be
replaced with bulbs of identical
specifi cation and colour.

!
PRACTICAL INFORMATION
130
Changing the third brake lamp
(diodes)
For the replacement of this type of di-
odes lamp, contact a PEUGEOT dealer. Changing the number plate lamp
bulbs (W 5 W)

 Insert a thin screwdriver in one of
the exterior holes of the lens.

 Push it towards the outside to unclip it.

 Remove the lens.

 Pull the bulb and change it.
High pressure washing
When using this type of washing
on stubborn dirt, do not persist on
the headlamps, the lamps and their
surrounds to avoid damaging their
protective coating and seals.

!
i
PRACTICAL INFORMATION
131
PEUGEOT does not accept any
responsibility for the costs incurred
in repairing your vehicle or for the
malfunctions resulting from the
installation of additional accessories
which are not supplied or recom-
mended by PEUGEOT and which
are not installed in accordance with
its instructions, particularly when
the combined consumption of all of
the additional equipment connect-
ed exceeds 10 milliamperes.

Installation of electrical acces-
sories
Your vehicle's electrical circuit is
designed to operate with the stan-
dard or optional equipment.
Before installing other electrical
equipment or accessories in your
vehicle, contact a PEUGEOT dealer.
CHANGING A FUSE
Procedure for the replacement of a
faulty fuse with a new fuse in order to
rectify a failure of the corresponding
function.
Access to the tools
The extraction pliers are installed on the
back of the dashbaord fusebox cover.
To gain access to them:

 unclip the cover pulling at the top,

 remove the cover completely,

 remove the pliers. Replacing a fuse
Before replacing a fuse, the cause of
the failure must be identifi ed and recti-
fi ed.

 Identify the faulty fuse by examining
the condition of its fi lament.

 Use the special pliers to extract the
fuse from its housing.

 Always replace the faulty fuse with a
fuse of the same rating.

 Check that the number engraved
on the box and the rating engraved
on the top correspond to the tables
which follow. Correct
Incorrect

PRACTICAL INFORMATION
132
Dashboard fuses
The fusebox is placed in the lower dash-
board (left-hand side).
Access to the fuses

 refer to the "Access to the tools"
paragraph. Fuse table

Fuse N° Rating Functions

G37 30 A Retractable roof unit supply.

G38 20 A Hi-Fi amplifi er.

G39 20 A Driver and passenger heated seats.

G40 40 A Trailer fusebox supply.

Fuse N° Rating Functions

F1 - Not used.

F2 - Not used.

F3 5 A Airbags and pre-tensioners control unit.

F4 10 A Clutch pedal switch, diagnostic socket,
electrochromatic rear view mirror, air conditioning,
steering wheel angle sensor, particle emission fi lter
pump (Diesel).

F5 30 A Rear electric windows, retractable roof.

F6 30 A Front electric windows, folding mirrors supply.

F7 5 A Front courtesy lamp, map reading reading lamps,
sun visor lighting, glove box lighting.

PRACTICAL INFORMATION
133

Fuse N° Rating Functions

F8 20 A Audio/telephone, multifunction screen, steering
mounted controls, tyre under-infl ation detection,
trailer fusebox, alarm (accessory).

F9 30 A Front 12 V socket, front courtesy lamp, map readin
g
lamps, sun visor lighting, glove box lighting.

F10 15 A Alarm siren, alarm control unit, directional
headlamps.

F11 15 A Diagnostic socket, low current ignition switch,
automatic gearbox control unit.

F12 15 A Sunshine sensor, trailer fusebox, retractable roof.

F13 5 A Engine fusebox, ABS relay, dual-function brake
switch.

F14 15 A
Instrument panel, seat belt warning lamps panel,
headlamp adjustment, air conditioning, audio equipm
ent,
Bluetooth system, rear parking sensors control unit .

F15 30 A Locking and deadlocking.

F17 40 A Heated rear screen and door mirrors.

SH - PARC shunt.

PRACTICAL INFORMATION
134
Engine compartment fuses
The fusebox is placed in the engine
compartment, near the battery (left-
hand side).
Access to the fuses

 Unclip the cover.

 Replace the fuse (refer to the cor-
responding paragraph).

 When you have fi nished, close the
cover carefully to ensure correct
sealing of the fuse box. Fuse table

Fuse N° Rating Functions

F1 20 A Engine control unit and fan assembly control relay
supply, timing and canister electrovalves
(1.6 l 16V THP), air fl ow sensor (Diesel), injection
pump (Diesel), water in Diesel sensor (Diesel),
EGR electrovalves, air heating (Diesel).

F2 15 A Horn.

F3 10 A Front wash-wipe.

F4 20 A Headlamp wash.

F5 15 A Fuel pump (petrol), Turbo electrovalves
(1.6 l 16V THP).

F6 10 A Vehicle speed sensor, automatic gearbox.

F7 10 A Electric power steering, directional headlamps,
directional headlamps control relay, switching and
protection unit (Diesel).

F8 20 A Starter motor control.

F9 10 A ABS/ESP control unit, brake pedal switch.

F10 30 A Engine control unit actuators (petrol: ignition coils,
electrovalves, oxygen sensors, injectors, heaters,
electronic thermostat) (Diesel: electrovalves,
heaters).

F11 40 A Air conditioning blower.

F12 30 A Windscreen wipers Low/High speed.

F13 40 A Built-in systems interface supply (ignition positive).