2010 Peugeot 206 P Dag service
[x] Cancel search: servicePage 1 of 107
15
PETROL - DIESEL MANUAL GEARBOX INSTRUMENT PANELS
Panel which groups together the vehicle operation dials and indicator lamps.
4. Speedometer.
Indicates the current speed of the moving vehicle (km/h).
5. Screen
.
6. Screen display
zero reset button.
Resets the selected function to zero (trip distance recorder or service in-
dicator).
7. Instrument panel lighting button.
Adjusts the brightness of the lighting of the instrument panel.
DIALS
1. Rev counter.
Indicates the speed of rotation of the engine (x 1 000 rpm).
2. Fuel gauge.
Indicates the quantity of fuel remain- ing in the tank.
3. Coolant
temperature.
Indicates the temperature of the en- gine coolant (° Celsius).
A. Cruise control.
Speed limiter.
(km/h)
B. Trip distance recorder.
(km)
C. Service indicator.
(km) then,
Distance recorder.
(km)
These three functions are displayed in succession when the ignition is
switched on.
For more information, refer to the sec-
tion which corresponds to the function
and to the display associated with it.
Display
Page 4 of 107
INSTRUMENTS and CONTROLS
18
Deactivation indicator lamps
I f o n e o f t h e f o l l o w i n g i n d i c a t o r l a m p s c o m e s o n , t h i s c o n fi r m s t h a t t h e c o r r e s p o n d i n g s y s t e m h a s b e e n s w i t c h e d o f f i n t e n t i o n a l l y .
This is accompanied by an audible signal and a message on the multifunction screen.
Warning lamp is on Cause Action/Observations
Passenger's
airbag
system fi x e d . The control, located on the
passenger's side of the
dashboard, is set to the
OFF
position.
The passenger's front airbag is
deactivated.
In this case you can install a
"rear facing" child seat. Set the control to the
ON position to activate
the passenger's front airbag. In this case, do
n o t fi t a c h i l d s e a t i n t h e r e a r - f a c i n g p o s i t i o n .
The passenger's airbag system is put into
service automatically when the vehicle is
started.
fl a s h i n g . The airbags system is faulty. Consult a PEUGEOT dealer.
ESP/ASR fi x e d . The button, located at the
bottom left of the dashboard,
is pressed. Its indicator lamp
is on.
The ESP/ASR is deactivated.
ESP: electronic stability
programme.
ASR: anti-skid regulation. Press the button to activate the ESP/ASR. Its
indicator lamp switches off.
From approximately 30 mph (50 km/h), the
system is reactivated automatically.
The ESP/ASR system is activated
automatically when the vehicle is started.
Page 9 of 107
23
SERVICE INDICATOR
System which informs the driver when
the next service is due, in accordance
with the manufacturer's servicing
schedule.
The point at which the service is due is
calculated from the last indicator zero
reset. It is determined by two param-
eters:
- the distance travelled,
-
the time elapsed since the last service.
More than 620 miles (1 000 km)
remain before the next service is due
For 5 seconds after the ignition is
switched on, the spanner symbolising
the service operations comes on. The
distance recorder display line indicates
the distance remaining before the next
service is due.
Example: 4 800 miles/km remain be-
fore the next service is due.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition is switched
on, the spanner is switched off ; the
distance recorder resumes its normal
operation. The display then indicates
the total and trip distances. Less than 620 miles (1 000 km)
remain before the next service is due
Examples: 500 miles (900 km) remain
before the next service is due.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition is switched
on, the distance recorder resumes
its normal operation. The spanner
remains on to indicate that a service
must be carried out soon.
Page 10 of 107
ii
ii
INSTRUMENTS and CONTROLS
24
Following this operation, if you
wish to disconnect the battery,
lock the vehicle and wait at least
fi v e m i n u t e s f o r t h e z e r o r e s e t t o b e
taken into account.
Service indicator zero reset
After each service, the service indicator
must be reset to zero.
The procedure for resetting to zero is as
follows:
switch off the ignition,
press and hold the trip distance re-
corder zero reset button,
switch on the ignition; the distance
recorder display begins a count-
down,
when the display indicates "=0" ,
release the button; the spanner
disappears.
The distance remaining may be
weighted by the time factor, depend-
ing on the driver's driving habits.
Therefore, the spanner may also
come on if you have exceeded the
two year service interval.
Service overdue
For 5 seconds after the ignition is
switched on,
t h e s p a n n e r fl a s h e s to
indicate that the service must be carried
out as soon as possible.
Example: the service is overdue by
300 miles/km.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition is switched on,
the distance recorder resumes its normal
operation. The spanner remains lit .
Page 72 of 107
!
77
CHECKS
Check these components, or have them
checked by a PEUGEOT dealer, in ac-
cordance with the servicing booklet and
in relation to your engine.
Battery
Air filter and passenger compartment filter
Brake pads
Parking brake
Brake disc/drum wear Oil filter
Manual gearbox
Only use products recommended
by PEUGEOT or products of equi-
v a l e n t q u a l i t y a n d s p e c i fi c a t i o n s .
At the start of winter, have
your battery checked by a
PEUGEOT dealer.
H a v e t h e fi l t e r e l e m e n t s r e -
placed regularly.
If you drive
in dusty conditions, change
them twice as often. Brake pad wear depends on
the style of driving, in particular
for vehicles which are used in
town, over short distances.
It may be necessary to check the thickness
of the pads, even between services.
Where the parking brake trav-
el is too great or there is a re-
duction in the performance of
the system, the parking brake
should be adjusted, even be-
tween services.
Have the system checked by a PEUGEOT
dealer.
For any information relating to
checking the wear of the brake
discs and/or drums, contact a
PEUGEOT dealer. C h a n g e t h e fi l t e r r e g u l a r l y , i n
accordance with the servicing
schedule.
This does not require an oil
change. Check the level in ac-
cordance with the manufacturer's
servicing schedule.
Page 105 of 107
10
108
RDS *
Using the RDS on FM
The RDS (Radio Data System) allows
you to continue listening to the same
s t a t i o n , w h a t e v e r f r e q u e n c y i t i s u s i n g
in the region you are travelling through. Press the "RDS" button
b r i e fl y t o s w i t c h t h e f u n c -
tion on or off.
The multifunction screen will indicate:
- "RDS" if the function is selected,
- "(RDS)" if the function is selected
but not available.
RDS station following
The display indicates the name of the sta-
tion selected. When the RDS is selected,
the radio searches continuously for the
transmitter which is broadcasting the se-
lected station with the best reception.
T r a f fi c i n f o r m a t i o n p r o g r a m m e ( T A ) Regional following mode (REG)
When they are part of a network, cer-
tain stations broadcast regional pro-
grammes in the various areas they
serve. The regional following mode
allows you to continue listening to the
same programme.
To do this, press the
"RDS" button for
more than two seconds to switch the
function on or off.
A n y t r a f fi c i n f o r m a t i o n a n n o u n c e m e n t
will be given priority, whatever source
you are listening to (radio, CD).
If you wish to interrupt a message,
press the
"TA" button; this switches the
function off.
N o t e : t h e v o l u m e o f t h e t r a f fi c i n f o r -
mation is independent of the volume
of normal radio listening. You can
adjust it using the volume button.
The setting will be stored and will be
used for subsequent messages.
Search by type of programme (PTY)
This allows you to listen to stations broad-
c a s t i n g a s p e c i fi c t y p e o f p r o g r a m m e
(News, Culture, Sport, Rock...). When FM is selected,
press the "TA" button for
more than two seconds
to switch the function on
or off. To search for a
PTY programme:
- select the PTY function,
- press button J or L b r i e fl y t o s c r o l l
down the list of the different types of
programme offered,
- when the programme of your choice is displayed, press button J or L for
more than two seconds to carry out
an automatic search (following an
automatic search, the PTY function
is switched off).
In PTY mode, the types of programme
can be stored. To do this, press the pre-
selection buttons "1" to "6" for more
than two seconds. Press the corre-
s p o n d i n g b u t t o n b r i e fl y t o r e c a l l t h e t y p e
of programme stored.
EON system
This system connects stations which
are part of the same network. It permits
the broadcasting of TA t r a f fi c i n f o r m a -
tion or of a PTY programme broadcast
by a station which is part of the same
network as the station to which you are
listening.
This service is available when you have
selected the TA t r a f fi c i n f o r m a t i o n p r o -
gramme or the PTY search by type of
programme.
Press the
"TA" button to
switch the function on or
off.
The multifunction screen will indicate:
- "TA" if the function is selected,
- "(TA)" if the function is selected but
not available.
* According to country.