2010 Peugeot 206 P Dag ABS

19
Warning lamps
When the engine is running or the vehicle is being driven, the switching on of one of the following warning lamps indicates a
fault which requires action on the part of the driver.
Any fault resulting in the switching on of a warning lamp must be investigated further by reading the associated message on
the multifunction screen.
If you encounter any problems, do not hesitate to contact a PEUGEOT dealer.

Warning lamp is on Cause Action/Observations

STOP fi xed,
associated
with another
warning lamp. It is associated with the
braking, the engine oil pressure
or the coolant temperature.
Stop as soon as it is safe to do so.
Park, switch off the ignition and call a
PEUGEOT dealer.


Braking fi xed.
The braking system fl uid level
has dropped signifi cantly. Top up with brake fl uid recommended by
PEUGEOT.
If the problem persists, have the system
checked by a PEUGEOT dealer.
+
fi xed, associated with the ABS
warning lamp. The electronic brake force
distribution (EBFD) system has
a fault. Have it checked by a PEUGEOT dealer.

Anti-lock
Braking
System (ABS) fi xed. The anti-lock braking system
has a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact
a PEUGEOT dealer without delay.


Dynamic
stability control
(ESP/ASR) fl ashing.
The ESP/ASR regulation is
active. The system optimises traction and improves
the directional stability of the vehicle.
fi xed. Unless it has been deactivated
with the indicator lamp on
the button on, the ESP/ASR
system is faulty. Have it checked by a PEUGEOT dealer.

!
i
58
When braking in an emergency,
press very fi rmly without releasing
the pressure. When replacing wheels (tyres and
rims), ensure that they conform to the
manufacturer's recommendations.
BRAKING ASSISTANCE
SYSTEMS
Anti-lock braking system and
electronic brake force distribution
Linked systems which improve the sta-
bility and manoeuvrability of your vehicle
when braking, in particular on poor or
slippery surfaces.
Activation
The anti-lock braking system comes
into operation automatically when there
is a risk of wheel lock.
Normal operation of the ABS may make
itself felt by slight vibration of the brake
pedal. Operating fault
Emergency braking assistance
System which, in an emergency, en-
ables you to obtain the optimum braking
pressure more quickly, thus reducing
the stopping distance.
Activation
It is triggered by the speed at which the
brake pedal is pressed.
The effect of this is a reduction in the
resistance of the pedal and an increase
in braking effi ciency.
When braking in an emergency, press
fi rmly without releasing the pressure.
Group of supplementary sys-
tems which help you to obtain
optimum braking in complete
safety in emergency situations:
- anti-lock braking system (ABS),
- electronic brake force distribution (EBFD),
- emergency braking assistance (EBA). If this warning lamp comes on,
accompanied by an audible sig-
nal and a message on the mul-
tifunction screen, it indicates a
malfunction of the anti-lock braking sys-
tem which could result in loss of control
of the vehicle when braking.
If this warning lamp comes on, togeth-
er with the STOP and ABS warning
lamps, accompanied by an audible sig-
nal and a message on the multifunction
screen, it indicates a malfunction of the
electronic brake force distribution which
could result in loss of control of the ve-
hicle when braking.

You
must
stop as soon as it is safe
to do so.
In either case, contact a PEUGEOT
dealer.

!
67
The incorrect installation of a child
seat in a vehicle compromises the
child's protection in the event of an
accident.
Remember to fasten the seat belts
or the child seat harnesses keep-
ing the slack in relation to the
child's body to a minimum , even
for short journeys.
For optimum installation of the "for-
ward facing" child seat, ensure that
the back of the child seat is in con-
tact with the back of the vehicle's
seat and that the head restraint
does not cause any discomfort.
If the head restraint has to be re-
moved, ensure that it is stored or
attached securely to prevent it from
being thrown around the vehicle in
the event of sharp braking.
Children under the age of 10 must
not travel in the "forward facing"
position on the front passenger
seat, unless the rear seats are al-
ready occupied by other children,
cannot be used or are absent. Installing a booster seat
The chest part of the seat belt must
be positioned on the child's shoulder
without touching the neck.
Ensure that the lap part of the seat
belt passes correctly over the child's
thighs.
PEUGEOT recommends the use of
a booster seat which has a back, fi t-
ted with a seat belt guide at shoulder
level.
As a safety precaution, do not leave:
- one or more children alone and
unsupervised in a vehicle,
- a child or an animal in a vehicle which is exposed to the sun, with
the windows closed,
- the keys within reach of children inside the vehicle.
To prevent accidental opening of the
doors, use the "Child lock".
Take care not to open the rear win-
dows by more than one third.
To protect young children from the
rays of the sun, fi t side blinds on the
rear windows.
CHILD LOCK
On each rear door, this prevents open-
ing of the door from the inside.
Turn control 1 an eighth turn (45 degrees)
towards the inside of the vehicle using the
ignition key.
Check that the safety lock is engaged
correctly. The control 1 should no longer
be in the vertical position.

85
Third brake lamp 5 bulbs W5W
Unclip the boot side trim.
Remove the wing nut.
Release the lamp unit from the outside.
Press the lug A and disconnect the
connector.
Remove the sealing foam.
Move aside the tabs B and remove the
bulb holder.
Turn the faulty bulb a quarter turn and
change it.
To refi t, carry out these operations in
reverse order and ensure that the bulb
holder, the lamp unit and the foam cover
are repositioned correctly. Using a 10 mm spanner, unscrew the
2 nuts
A .
Release the lamp unit.
Squeeze the two tabs B to release the
bulb holder.
Change the faulty bulb.

1. Direction indicators
(P21W amber).

2. Reversing lamps P21W.

3. Brake lamps/sidelamps (P21/5W).

4. Foglamp (P21W).
Rear lam
ps

89

or
Fuse N° Rating Functions
1 10 A Pre-heater unit (diesel) - Water in diesel sensor -
Reversing lamp switch - Speed sensor - Air fl ow
sensor (diesel)
2 15 A Canister electrovalve - Fuel pump
3 10 A ABS control unit
4 10 A Engine management unit
5 - Not used
6 15 A Front foglamps
7 - Not used
8 20 A Fan assembly relay - Engine management unit -
Diesel injection pump - Diesel high pressure
regulator - Engine management electrovalve
9 15 A Left-hand dipped beam
10 15 A Right-hand dipped beam 11 10 A Left-hand main beam
12 10 A Right-hand main beam
13 15 A Horn
14 10 A Front and rear windscreen wash pumps
15 30 A Butterfl y housing heater - Diesel injection pump -
Oxygen sensor - Engine management unit - Air
fl ow sensor - Ignition coil - Engine management
electrovalve - Diesel heater - Injectors
16 30 A Air pump relay
17 30 A High and low speed windscreen wiper
18 40 A Air conditioning fan
Engine compartment fuse box
To gain access to the box in the engine
compartment (next to the battery), un-
clip the cover.
After carrying out work, take care to refi t
the cover correctly.

!
90
The electrical circuit of your ve-
hicle is designed to operate with
standard or optional equipment.
Before installing other electrical
equipment or accessories in your ve-
hicle, consult a PEUGEOT dealer.
Some electrical accessories or the
way in which they are fi tted may
have an adverse effect on the op-
eration of your vehicle (its elec-
tronic control circuits, the audio
circuit and the electrical charging
circuit).
PEUGEOT declines any respon-
sibility for expenses incurred
through the repair of your vehicle
or for any malfunctions resulting
from the installation of auxiliary
accessories, not supplied and not
recommended by PEUGEOT and
not installed in accordance with
PEUGEOT’s instructions, in par-
ticular when the combined con-
sumption of all of the additional
equipment connected exceeds
10 milliamps.
The maxi fuses present provide
additional protection for the elec-
trical systems. Any work on these
fuses must be carried out by a
PEUGEOT dealer.

Fuse N° Rating Functions
MF1 20 A/50 A Fan unit without/with air conditio ning
MF2 20 A/30 A ABS/ESP
MF3 20 A/30 A ABS/ESP
MF4 70 A Built-in systems interface (BSI) supply
MF5 70 A Built-in systems interface (BSI) supply
MF6 - Not used
MF7 30 A Ignition switch supply
MF8 - Not used

!i
92
ECONOMY MODE FUNCTION
After the engine has stopped, with the
key in the accessories position, certain
functions (windscreen wiper, courtesy
lamps, audio equipment, dipped beam
headlamps, etc.) can only be used for
a maximum cumulative duration of ap-
proximately fi fteen minutes, to prevent
discharging of the battery.
Once the fi fteen minutes are over, the
message "Economy mode active" ap-
pears on the multifunction screen and
the active functions are put on standby.
These functions will be reactivated au-
tomatically the next time the vehicle is
used.
To resume the use of these functions
immediately, start the engine and let it
run for a few minutes.
The time available will then be double
the time for which the engine is left run-
ning. However, this time will always be
between fi ve and fi fteen minutes.
A fl at battery will prevent the en-
gine from starting.
TOWING THE VEHICLE
Procedure for having your vehicle towed.
Towing your vehicle

 On the front bumper, unclip the cover
to gain access to the towing eye.

 Switch on the hazard warning lamps
on the towed vehicle.

 Place the gear lever in neutral. Towing another vehicle
Failure to comply with this special
requirement may result in damage
to certain braking components
and the absence of braking assis-
tance the next time the engine is
started.