Page 94 of 212
88 Lighting
Picture no: 13721s.tif
Courtesy lamp
0
Automatic interior light
Comes on automatically when the vehicle is
unlocked with the remote control or when a
door is opened.
Goes off automatically after a delay when
the doors are closed or immediately when
the ignition is switched on or the doors are
locked.
Front courtesy lamp
Manual operation from within when doors
are closed:
Picture no: 11607s.tif
Front reading lamps 3
Operable with the button when the ignition
is on. Luggage compartment and loading area
lighting 3
The luggage compartment lighting comes
on when the luggage compartment is
opened.
Automatically regulated centre console
lighting 3
Spotlight in housing of interior mirror.
Daylight-dependent, automatically
regulated centre console lighting with
ignition switched on.
On = Press light switch 0
Off = Press light switch 0 again
Page 95 of 212
89
Lighting
Battery discharge protection
3
Some consumers such as the interior
lighting switch themselves off after approx.
30 minutes if the ignition is off in order to
protect the battery charge. Misted light covers The inside of the lamp bezels may mist
briefly when subjected to adverse wet and
cold winter conditions, strong rain or after
the vehicle is washed. The misting will clear
up on its own after a brief period. This can
be facilitated by switching on the lights.
Headlamps when driving abroad The asymmetrical dipped beam increases
the field of vision on the passenger side of
the lane.
This causes glare for oncoming traffic if the
vehicle is driven in countries where traffic
drives on the opposite side of the road.
To avoid glare, have headlamps adjusted
in a wor kshop o r have c overs fitted to both
headlamps.
Page 109 of 212

103
Driving and operation
Picture no: 12479S.tif
Winter programme T
In the event of difficulties starting off on
slippery roads, press the T b u t t o n ( " A " a n d
T appear in the transmission display). The
manual transmission automated switches
to automatic mode and the vehicle sets off
in second gear.
The Winter programme is switched off by:
zpressing the T button again,
zturning off the ignition,
zswitching to Manual mode,
zwhen clutch temperature is too high.
Picture no: 13322a.tif
Kickdown
If the accelerator pedal is pressed past the
pressure point, the transmission shifts to a
lower gear depending on engine speed.
During kickdown no manual gear shifting is
possible.
When the engine speed approaches its
upper limit, the transmission shifts to a
higher gear during kickdown even in
Manual mode.
Without kickdown this automatic shift is
not effected in Manual mode. Engine braking
Automatic mode
When driving downhill, the manual
transmission automated does not shift into
higher gears until a fairly high engine
speed has been reached. When braking,
the transmission shifts down in good time.
Manual modeTo utilise the engine braking effect, select a
lower gear in good time when driving
downhill.
"Rocking the car"
T o r o c k a v e h i c l e t h a t i s s t u c k i n s a n d , m u d ,
snow or a rut only, alternate the selector
lever between o (centre position) and R
positions and depress the accelerator
pedal slightly. Keep the engine speed as
low as possible and avoid rapid
acceleration.
Page 110 of 212

104 Driving and operation
Picture no: 14083j.tif
Manoeuvring the vehicle
To manoeuvre the vehicle back and forth
during attempts to park or in garage
entrances the creeping movement can be
utilised by releasing the foot brake.
Never actuate accelerator and brake
pedals simultaneously.
To prevent damage, the manual
transmission automated disengages the
"creep function" at extremely high
automatic clutch temperatures. Vehicle storage
Apply the handbrake and remove the key
from the ignition. The previously selected
gear (shown on the transmission display)
remains selected. No gear is selected in
selector lever position N.
When the ignition is switched off, the
manual transmission automated no longer
responds to movement of the selector
lever.
If the ignition key is not removed, the
battery may be discharged if the vehicle is
then left to stand for a lengthy period of
time.
If the hand brake has not been applied, the
control indicator R flashes for a few
seconds after the ignition is switched off.
Picture no: 12480s.tif
Fault
To prevent damage to the automated
manual transmission, the clutch is closed
automatically at high clutch temperatures.
Control indicator A illuminates in the
event of a fault. Continued driving is
possible. Manual mode cannot be used for
shifting.
If an "F" is also shown in the transmission
display, it is not possible to continue
driving.
Have cause of fault remedied by a
workshop. The system’s integrated self
diagnostics allow faults to be quickly
remedied.
Page 111 of 212

105
Driving and operation
Picture no: 13739s.tif
Interruption of power supply
The clutch is not disengaged if there is an
interruption of the power supply when a
gear is engaged. The vehicle cannot move.
If the battery is discharged, start the
vehicle using jump leads 3129.
If the cause is not a flat battery, contact a
workshop for assistance. If the vehicle has
to be moved out of flowing traffic,
disengage clutch as follows:
1. Apply hand brake and switch off
ignition.
2. Open bonnet and engage support.3. Clean the transmission around the cap
(see figure) so that no dirt can get into
the opening when the cap is removed.
4. Rotate cap to slacken and remove by
lifting upwards – see figure.
5. Turn the adjusting screw clockwise using
a flat-head screwdriver (vehicle tools 3
3136) until clear resistance can be felt.
The clutch has now been disengaged.
6. Fit cleaned cap again. The cap must be
in full contact with the housing.
Contact a workshop for assistance
immediately.
Picture no: 15120s.tif
Manual transmissionTo engage reverse, with the vehicle
stationary wait 3 seconds after declutching
and then pull up the button on the selector
lever and engage the gear.
If the gear does not engage, set the lever in
neutral, release the clutch pedal and
depress again; then repeat gear selection.
Do not grind the clutch unnecessarily.
When operating, depress the clutch pedal
completely. Do not use the pedal as a foot
rest (increases clutch wear).
Caution
Do not turn beyond the resistance, since
this can damage the manual
transmission automated.
Caution
Towing the vehicle and starting the
engine is not permitted when the clutch
has been released in this way, although
the vehicle can be moved a short
distance.
Page 117 of 212

111
Driving and operation
Picture no: 15829t.tif
Fuel filler cap
Only a Opel Genuine fuel filler cap provides
full functionality. Diesel-engined vehicles
have special fuel filler caps.
Refuelling Fuel filler neck at right rear side of vehicle.
Picture no: 11628s.tif
With the central locking system3, the tank
flap is unlocked together with the doors3
324.
Open the tank flap. To prevent damage,
the right-hand sliding door cannot be fully
opened if the tank flap is open.
Unlock the fuel filler cap with the ignition
key 3, unscrew and suspend from tank
flap.
The fuel tank has a limiting system which
prevents overfilling of the tank.
6
9 Warning
Before refuelling, switch off engine and
any external heaters with combustion
chambers 3 (identified by sticker on
tank flap). Switch off any mobile
phones.
Follow the operating and safety
instructions of the filling station when
refueling.
9 Warning
Fuel is flammable and explosive. No
smoking. No naked flames or sparks.
If you can smell fuel in your vehicle, have
the cause of this rectified immediately
by a workshop.
Page 118 of 212

112 Driving and operationCorrect filling depends to a large extent on
proper operation of the fuel dispensing
pump:
1. Fully insert the pump nozzle and switch it
on.
2. After the automatic cut-off, the nominal
capacity of the fuel tank can be
obtained by topping up with two doses
of fuel. Make sure the nozzle is fully
inserted.
To close, place fuel filler cap in position and
turn, overcoming the resistance until the
ratchet on the cap engages audibly. Lock
the fuel filler cap with the ignition key 3.
Close fuel tank cover. Refuelling, natural gas 3
The fuel tank filler neck for natural gas and
petrol is located on the right rear side of the
vehicle.
Picture no: 12292t.tif
Remove the cap from the natural gas filler
neck.
The tank action must be fully completed,
e.g. bleeding the filler neck.
After refuelling, refit the cap. Caution
Wipe off any overflowing fuel
immediately.
9 Warning
Care must be taken when handling
natural gas!
Before refuelling, be sure to switch off
the engine and any auxiliary heater with
combustion chamber.
Natural gas is flammable and explosive.
Therefore, avoid naked flames and
sparks when handling or in the vicinity of
natural gas. Do not smoke! This also
applies where natural gas can only be
detected by its characteristic smell.
If there is a smell of natural gas in the
vehicle, have cause established
immediately by a workshop that is
authorised to maintain natural gas
vehicles and have the problem
remedied.
9 Warning
When refuelling vehicles with natural
gas, be sure to follow the operational
and safety regulations of the filling
station.
The gas tank must only be replenished
at filling stations that refuel with
temperature compensation with a
maximum output pressure of 250 bar.
Page 119 of 212
113 Driving and operation
Refuelling when driving abroad
When refuelling in another country, please note that country-specific expressions are used
for natural gas vehicles.
German Erdgasfahrzeuge Erdgas als Kraftstoff
English NGVs = Natural Gas Vehicles CNG = Compressed Natural Gas
French Véhicules au gaz naturel
– or –
Véhicules GNVGNV = Gaz Naturel (pour) Véhicules
– or –
CGN = carburant gaz naturel
Italian Metano auto Metano (per auto)
Picture no: 16882s.tif
Fuel selector switch, natural gas 3
Switch
Y can be used to switch between
petrol and natural gas operation. A
changeover is not possible during a high
load, such as powerful acceleration or full
throttle. The status of the LED indicates
which type of fuel is in use.
As soon as the natural gas tank is empty,
the vehicle automatically switches to petrol
operation until the ignition is switched off.
This is indicated by prolonged flashing of
the LED.
6 Natural gas
operation=LED off.
Petrol operation = LED comes on.