2010 OPEL COMBO ignition

71
Instruments
Picture no: 12098s.tif.
Instrument displayTachometer
Displays the engine rpm.
Drive in a low engine speed range for each
gear as much as possible.
Speedometer
Speed display.
Picture no:
Kilometre display
With the ignition switched off, briefly press
the reset knob to display the number of
kilometres driven for approx. 15 seconds.
Top line:
Trip odometerDisplays the number of kilometres since the
gauge was reset.
To reset, press button with ignition
switched on and trip odometer activated
and hold down for approximately one
second. Caution
If the pointer is in the warning zone, the
maximum permitted engine speed is
exceeded. Engine at risk.
Vehicles with clock in odometerTo reset, press button with ignition
switched on and trip odometer activated
and hold down for approximately
2seconds.
To switch between trip odometer and clock
display 3 give reset knob a brief press – see
next page.
Bottom line:
OdometerRecords the number of kilometres
Service interval display 3173.

76 Instruments
Picture no: 17913s.tif
Information display Triple information display 3
Display of time, outside temperature and
date/infotainment system (when it is on).
When the ignition is off, the time, date and
outside temperature can be displayed by
briefly pressing one of the two buttons
adjacent to the display.
Picture no: 16711t.tif
Graphical Information Display 3
Display of time, outside temperature and
date/infotainment system (when it is on).
The type of information and how it is
displayed depend on the equipment of the
vehicle and the settings made.
Some information appears in the display in
an abbreviated form.
Picture no: 17913s.tif
Outside temperature A fall in temperature is indicated
immediately and a rise in temperature
after a time delay.
If outside temperature drops below 3 C,
the symbol : appears in the triple
information display as a warning for icy
road conditions. When temperature
increases to at least 5 C, the : symbol
goes out.
12:01 17
,0
°C
FM 3
90,6
MHz
REG AS RDS TP
FMAS[TP]REGCDinMP3

90.6
MHz
19,5° 19:36
8:56
-5
,5
°C
07.04.2004
:

82 InstrumentsSetting display mode 3
Display brightness is independent of
vehicle lighting. Settings are made as
follows:
Select menu item Day / Night from the
Settings menu.
The options are displayed.
Automatic: Adapted based on vehicle
lighting.
Always day design: Black text on light
background.
Always night design: White text on dark
background.
Selections are indicated by a o in front of
the menu item.
Ignition logic 3
Setting, see infotainment system
instructions.
Warning buzzersWhen starting the engine or while driving:
zif seat belt 3 is not fastened.
zIf the speed programmed at the
factory3 is exceeded.
zIf the car has automated manual
transmission 3 and the driver’s door is
opened when the engine is running, a
gear is engaged and the foot brake is
not depressed.
When parking the vehicle and opening
the driver’s door:
zwhen the ignition key is in the ignition
switch.
zwith parking lamps or dipped beam on.
zif the turn signal lever is engaged.
Picture no: 14055h.tif
Windscreen wipers Move lever upwards to switch on.
&=Fast
%=Slow
$= Adjustable interval switching
§=Off

83
Instruments
Adjustable wiper interval
To set the wiper interval to a value between
2 and 15 seconds:
Lever to interval operation $, lever to §,
wait for required interval delay, Level to
interval operation again $.
The selected interval will remain stored
until the next time it is changed or until the
ignition is switched off.
After switching on the ignition and moving
the lever up, $ the interval is set to
7seconds.
Picture no: 14056h.tif
Windscreen washer system
Pull the lever towards the steering wheel.
Washer fluid sprays onto the windscreen
and the windscreen wipers switch on for a
few sweep movements.
Picture no: 14057h.tif
Rear window wiper 3 and rear window
washer system 3
Push the lever forwards. The rear window
wiper swipes in timed interval mode. Switch
off by pulling the lever towards the steering
wheel.
If the stalk is held forwards, washer fluid is
sprayed on the rear window.

84 LightingLighting
Picture no: 13718s.tif
Exterior lightsTurn light switch:
In positions 8 and 9, the tail lamps and
number plate lamps are also on.
If the ignition is switched off when main
beam or dipped beam is on, the parking
lamps 3 come on. Versions with daytime running lights 3
If the light switch is set to 7, dipped beam
is activated without instrument illumination
when the ignition is switched on.
The daytime running lights switched off
when the ignition is switched off.
Follow the regulations of the country in
which you are driving when using daytime
running lights and fog lamps 3.
Driving abroad 3 89. Exterior lights ....................................... 84
Main beam, headlamp flash .............. 85
Turn signal lamps ................................ 85
Reversing lamps................................... 85
Fog lamps > 3.................................... 86
Fog tail lamp r................................... 86
Hazard warning lamps ....................... 86
Headlamp range adjustment ? 3..... 87
Instrument illumination k................... 87
Information display illumination 3..... 87
Courtesy lamp 0................................ 88
Battery discharge protection 3.......... 89
Misted light covers............................... 89
Headlamps when driving abroad ...... 89 7=Off
8= Parking lamps
9= Dipped beam or main beam

85
Lighting
Picture no: 18475s.tif
Main beam, headlamp flash Push stalk forward to switch from dipped
beam to main beam.
To switch to dipped beam, push lever down
again.
To operate the headlamp flash, pull stalk
towards steering wheel. The main beam is
switched on for as long as the the stalk is
held in this position.
Picture no: 14054h.tif
Turn signal lamps If the stalk is moved past the resistance
point, the turn signal lamp remains on.
When the steering wheel moves back
toward the straight-ahead position, the
turn signal lamp is automatically
deactivated.
Touch turn signal operation: press lever
until resistance can be felt and release
again.
The turn signal lamps are switched off
manually by moving the lever back to the
middle position.
Reversing lamps The reversing lamps come on when the
ignition is on and reverse gear is engaged.
Lever upwards = Right turn signal
Lever downwards = Left turn signal

86 Lighting
Picture no: 13720s.tif
Fog lamps
> 3

The fog lamps can only be switched on if
both the ignition and lights are on.
Operated with the > button.
Fog tail lamp
r
The fog tail lamp can only be switched on
if both the ignition and dipped beam/
parking lamps are on.
Operated with the r button.
The fog tail lamp of the vehicle is
deactivated when towing a caravan/
trailer.
Picture no: 15865s.tif
Hazard warning lamps Operated with the ¨ button.
To make the button easier to find, the red
surface is illuminated when the ignition
switched on. When the button is pressed,
its control indicator flashes in time with the
hazard warning lamps.

87
Lighting
Picture no: 13719s.tif
Headlamp range adjustment
? 3

Rotate the adjuster wheel to the required
position to adjust the dipped beam range
to vehicle loading and prevent dazzling. Combo
Combo van
Picture no: 13722s.tif
Instrument illumination
k
Illumination comes on with the exterior
lights. Brightness can be adjusted using the
adjuster wheel.
Information display illumination
3
Information display illumination comes on
when the ignition or infotainment system is
switched on. Brightness can be adjusted
using the adjuster wheel.
0 = Front seats occupied
1 = All seats occupied
2 = All seats occupied and luggage
compartment load
3 = Driver’s seat occupied and
luggage compartment load
0 = Seats occupied
1 = Seats occupied and half load in
load compartment
2 = Seats occupied and full load in
load compartment
3 = Driver’s seat occupied and full
load in load compartment