2010 Mercury Mountaineer child lock

Installing child safety seats with combination lap and shoulder
belts
If needed, when installing some high back child restraints, the head
restraints of the second row seating positions can be removed. Insert a
thin pointed object, such as a paper clip or pushpin, into the hole of
each head restraint guide and while lifting up remove the head restraint.
Store the head restraint in a secure location in the vehicle, such as on
the floor against the rear of the front seats. To re-install the head
restraint, line the posts up in the holes on the seat back with the head
restraint strap facing the outside of the vehicle and push down until the
head restraint locks into place. Lift gently to ensure it is locked into
place.
WARNING:If the head restraint has been removed from a
seating position to accommodate a high back child restraint, the
head restraint must be re-installed prior to use of the seat by any other
occupant in order to reduce the risk of personal injury in the event of
a collision.
Check to make sure the child seat is properly secured before each use.
Children 12 and under should be properly restrained in a rear seating
position whenever possible. If all children cannot be seated and
restrained properly in a rear seating position, properly restrain the
largest child in the front seat.
When installing a child safety seat with combination lap/shoulder belts:
•Use the correct safety belt buckle for that seating position.
•Insert the belt tongue into the proper buckle until you hear a snap
and feel it latch. Make sure the tongue is securely fastened in the
buckle.
Seating and Safety Restraints
210
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)

•Keep the buckle release button pointing up and away from the safety
seat, with the tongue between the child seat and the release button,
to help prevent accidental unbuckling.
•Place vehicle seat back in upright position.
•Put the safety belt in the automatic locking mode. Refer to step 5
below. This vehicle does not require the use of a locking clip.
WARNING:Depending on where you secure a child restraint,
and depending on the child restraint design, you may block
access to certain safety belt buckle assemblies and/or LATCH lower
anchors, rendering those features potentially unusable. To avoid risk of
injury, occupants should only use seating positions where they are able
to be properly restrained.
Perform the following steps when installing the child seat with
combination lap/shoulder belts:
Note:Although the child seat illustrated is a forward facing child seat,
the steps are the same for installing a rear facing child seat.
1. Position the child safety seat in a
seat with a combination lap and
shoulder belt.
2. Pull down on the shoulder belt
and then grasp the shoulder belt
and lap belt together.
Seating and Safety Restraints
211
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)

3. While holding the shoulder and
lap belt portions together, route the
tongue through the child seat
according to the child seat
manufacturer’s instructions. Be sure
the belt webbing is not twisted.
4. Insert the belt tongue into the
proper buckle (the buckle closest to
the direction the tongue is coming
from) for that seating position until
you hear a snap and feel the latch
engage. Make sure the tongue is
latched securely by pulling on it.
5. To put the retractor in the
automatic locking mode, grasp the
shoulder portion of the belt and pull
downward until all of the belt is
pulled out.
6. Allow the belt to retract to remove slack. The belt will click as it
retracts to indicate it is in the automatic locking mode.
7. Try to pull the belt out of the retractor to make sure the retractor is
in the automatic locking mode (you should not be able to pull more belt
out). If the retractor is not locked, repeat Steps 5 and 6.
Seating and Safety Restraints
212
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)

WARNING:Depending on where you secure a child restraint,
and depending on the child restraint design, you may block
access to certain safety belt buckle assemblies and/or LATCH lower
anchors, rendering those features potentially unusable. To avoid risk of
injury, occupants should only use seating positions where they are able
to be properly restrained.
Use of inboard lower anchors from the outboard seating positions
(center seating use)
The lower anchors at the center of the second row rear seat are spaced
592 mm (23 inches) apart. The standardized spacing for LATCH lower
anchors is 280 mm (11 inches) center to center. A child seat with rigid
LATCH attachments cannot be installed at the center seating position.
LATCH compatible child seats (with attachments on belt webbing) can
only be used at this seating position provided that the child seat
manufacturer’s instructions permit use with the anchor spacing stated.
Do not attach a child seat to any lower anchor if an adjacent child seat is
attached to that anchor.
WARNING:The standardized spacing for LATCH lower anchors
is 280 mm (11 inches) center to center. Do not use LATCH
lower anchors for the center seating position unless the child seat
manufacturer’s instructions permit and specify using anchors spaced at
least as far apart as those in this vehicle.
If you install a child seat with rigid LATCH attachments, and have
attached the top tether strap to the proper top tether anchor, do not
tighten the tether strap enough to lift the child seat off the vehicle seat
cushion when the child is seated in it. Keep the tether strap just snug
without lifting the front of the child seat. Keeping the child seat just
touching the vehicle seat gives the best protection in a severe crash.
Each time you use the safety seat, check that the seat is properly
attached to the lower anchors and tether anchor, if applicable. Tug the
child seat from side to side and forward and back where it is secured to
the vehicle. The seat should move less than one inch when you do this
for a proper installation.
If the safety seat is not anchored properly, the risk of a child being
injured in a crash greatly increases.
Seating and Safety Restraints
216
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)

WARNING:Keep batteries out of reach of children. Batteries
contain sulfuric acid. Avoid contact with skin, eyes or clothing.
Shield your eyes when working near the battery to protect against
possible splashing of acid solution. In case of acid contact with skin or
eyes, flush immediately with water for a minimum of 15 minutes and
get prompt medical attention. If acid is swallowed, call a physician
immediately.
WARNING:Battery posts, terminals and related accessories
contain lead and lead compounds.Wash hands after handling.
Because your vehicle’s engine is electronically controlled by a computer,
some control conditions are maintained by power from the battery. When
the battery is disconnected or a new battery is installed, the engine must
relearn its idle and fuel trim strategy for optimum driveability and
performance. To begin this process:
1. With the vehicle at a complete stop, set the parking brake.
2. Put the gearshift in P (Park), turn off all accessories and start the
engine.
3. Run the engine until it reaches normal operating temperature.
4. Allow the engine to idle for at least one minute.
5. Turn the A/C on and allow the engine to idle for at least one minute.
6. Release the parking brake. With your foot on the brake pedal and with
the A/C on, put the vehicle in D (Drive) and allow the engine to idle for
at least one minute.
7. Drive the vehicle to complete the relearning process.
•The vehicle may need to be driven 10 miles (16 km) or more to
relearn the idle and fuel trim strategy.
•If you do not allow the engine to relearn its idle trim, the idle
quality of your vehicle may be adversely affected until the idle
trim is eventually relearned.
If the battery has been disconnected or a new battery has been installed,
the clock and radio settings must be reset once the battery is
reconnected. Additionally, the power running boards, if equipped, will
default to the off mode and must be turned on again.
Maintenance and Specifications
347
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)

A
Accessory delay ........................115
AdvanceTrac ..............................269
Air cleaner filter ...............369–370
Air conditioning ..........................91
Airbag supplemental restraint
system ........................190, 199, 201
and child safety seats ............192
description ..............190, 199, 201
disposal ....................................204
driver airbag ............192, 200, 202
indicator light .................199, 204
operation .................192, 200, 202
passenger airbag .....192, 200, 202
side airbag ...............................199
All Wheel Drive (AWD),
driving off road .........................284
Ambulance packages ....................6
Antifreeze
(see Engine coolant) ................348
Anti-lock brake system
(see Brakes) ......................266–267
Anti-theft system ......................154
Audio system
(see Radio) ......................28, 32, 40
Automatic transmission
driving an automatic
overdrive .........................277, 279
fluid, adding ............................367
fluid, checking ........................367
fluid, refill capacities ..............371
fluid, specification ..................371
Auxiliary input jack (Line in) ....48
Auxiliary power point ...............112
Axle
lubricant specifications ..........371refill capacities ........................371
B
Battery .......................................346
acid, treating emergencies .....346
jumping a disabled battery ....312
maintenance-free ....................346
replacement, specifications ...370
servicing ..................................346
Belt-Minder.............................185
Booster seats .............................220
Brakes ........................................266
anti-lock ...........................266–267
anti-lock brake system (ABS)
warning light ...........................267
fluid, checking and adding ....367
fluid, refill capacities ..............371
fluid, specifications .................371
lubricant specifications ..........371
parking ....................................267
shift interlock ..........................276
C
Calculating load ........................253
Capacities for refilling fluids ....371
Car2U garage door opener .......131
Cargo cover ...............................136
Cargo management system ......137
Cell phone use ..............................9
Changing a tire .........................302
Child safety seats ......................209
attaching with tether
straps .......................................217
in front seat ............................210
in rear seat ..............................210
LATCH .....................................213
recommendations ...................207
Index
384
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)

Child safety seats - booster
seats ...........................................220
Cleaning your vehicle
engine compartment ..............329
instrument panel ....................331
interior .....................................332
plastic parts ............................330
washing ....................................327
waxing .....................................328
wheels ......................................328
wiper blades ............................330
Climate control (see Air
conditioning or Heating) ............91
Clock adjust
6-CD in dash .............................42
AM/FM/CD .................................34
Compass, electronic
set zone adjustment .................25
Console ..............................111–112
overhead ..................................110
rear ..........................................112
Controls
power seat ...............................161
steering column ......................121
Coolant
checking and adding ..............348
refill capacities ................352, 371
specifications ..........................371
Cruise control
(see Speed control) ..................118
Customer Assistance ................292
Ford Extended Service
Plan ..........................................381
Getting assistance outside the
U.S. and Canada .....................324
Getting roadside assistance ...292
Getting the service you
need .........................................320Ordering additional owner’s
literature .................................325
Utilizing the
Mediation/Arbitration
Program ...................................324
D
Daytime running lamps
(see Lamps) ................................97
Defrost
rear window ..............................95
Dipstick
automatic transmission
fluid ..........................................367
engine oil .................................341
Driveline universal joint and
slip yoke ....................................368
Driving under special
conditions ..................282, 286, 289
sand .........................................287
snow and ice ...........................290
through water .................288, 291
Dual automatic temperature
control (DATC) ...........................91
DVD system .................................56
E
Electronic message center .........19
Emergencies, roadside
jump-starting ..........................312
running out of fuel .........312, 359
Emergency Flashers .................293
Emission control system ..........363
Engine ........................................376
cleaning ...................................329
coolant .....................................348
fail-safe cooling .......................353
Index
385
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)

How to get going ........................28
I
Ignition ...............................261, 376
Illuminated visor mirror ...........110
Infant seats
(see Safety seats) .....................209
Inspection/maintenance (I/M)
testing ........................................365
Instrument panel
cleaning ...................................331
cluster ........................................12
J
Jack ....................................302, 305
positioning .......................302, 307
storage .............................302, 305
Jump-starting your vehicle ......312
K
Keyless entry system
autolock ...........................141, 143
keypad .....................................152
locking and unlocking doors ..153
programming entry code .......152
Keys ...........................................155
positions of the ignition .........261
L
Lamps
bulb replacement
specifications chart ................101
daytime running light ...............97
fog lamps ...................................97
headlamps .................................96
interior lamps .........................100replacing bulbs .......................105
LATCH anchors .........................213
Liftgate ......................................138
remote release ........................148
Lights, warning and indicator ....12
anti-lock brakes (ABS) ..........267
Load limits .................................246
Loading instructions .................253
Locks
autolock ...........................141, 143
childproof ................................146
doors ........................................141
Lubricant specifications ...........371
Lug nuts ....................................311
Luggage rack .............................139
Lumbar support, seats .....161, 163
M
Manual transmission
lubricant specifications ..........371
Message center ...........................19
english/metric button ...............25
system check button ................25
warning messages .....................25
Mirrors ...............................115–116
automatic dimming rearview
mirror ......................................115
fold away .................................116
heated ......................................116
side view mirrors (power) .....116
Moon roof ..................................123
Motorcraft parts ........333, 354, 370
N
Navigation system .......................88
Index
387
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)