2010 Mercury Mountaineer jump cable

Preparing your vehicle
When the battery is disconnected or a new battery is installed, the
automatic transmission must relearn its shift strategy. As a result, the
transmission may have firm and/or soft shifts. This operation is
considered normal and will not affect function or durability of the
transmission. Over time, the adaptive learning process will fully update
transmission operation.
1.Use only a 12–volt supply to start your vehicle.
2. Do not disconnect the battery of the disabled vehicle as this could
damage the vehicle’s electrical system.
3. Park the booster vehicle close to the hood of the disabled vehicle
making sure the two vehiclesdo nottouch. Set the parking brake on
both vehicles and stay clear of the engine cooling fan and other moving
parts.
4. Check all battery terminals and remove any excessive corrosion before
you attach the battery cables. Ensure that vent caps are tight and level.
5. Turn the heater fan on in both vehicles to protect from any electrical
surges. Turn all other accessories off.
Connecting the jumper cables
1. Connect the positive (+) jumper cable to the positive (+) terminal of
the discharged battery.
Note:In the illustrations,lightning boltsare used to designate the
assisting (boosting) battery.
+–+–
Roadside Emergencies
313
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)

4. Make the final connection of the negative (-) cable to the ground stud
located toward the front of the vehicle (forward of the battery) on the
radiator support. Keep the negative (-) cable away from the battery and
the carburetor/fuel injection system.
Note:Do not attach the negative (-) cable fuel lines, engine rocker
covers, the intake manifold or electrical components asgrounding
points.
WARNING:Do not connect the end of the second cable to the
negative (-) terminal of the battery to be jumped. A spark may
cause an explosion of the gases that surround the battery.
5. Ensure that the cables are clear of fan blades, belts, moving parts of
both engines, or any fuel delivery system parts.
++-
-
Roadside Emergencies
315
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)

Jump starting
1. Start the engine of the booster vehicle and run the engine at
moderately increased speed.
2. Start the engine of the disabled vehicle.
3. Once the disabled vehicle has been started, run both engines for an
additional three minutes before disconnecting the jumper cables.
Removing the jumper cables
Remove the jumper cables in the reverse order that they were
connected.
1. Remove the jumper cable from thegroundmetal surface.
2. Remove the jumper cable on the negative (-) connection of the
booster vehicle’s battery.
+–+–
Roadside Emergencies
316
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)

3. Remove the jumper cable from the positive (+) terminal of the booster
vehicle’s battery.
4. Remove the jumper cable from the positive (+) terminal of the
disabled vehicle’s battery.
After the disabled vehicle has been started and the jumper cables
removed, allow it to idle for several minutes so the engine computer can
relearn its idle conditions.
+–+–
+–+–
Roadside Emergencies
317
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)

heated ..............................165–166
memory seat ...................148, 163
SecuriCode keyless entry
system ........................................152
SecuriLock passive anti-theft
system ........................................154
Setting the clock
AM/FM single CD .....................34
AM/FM/In-dash 6 CD ................42
Snowplowing .................................6
SOS Post Crash Alert ...............204
Spark plugs,
specifications .....................370, 376
Special notice
ambulance conversions ..............6
utility-type vehicles ....................6
Specification chart,
lubricants ...................................371
Speed control ............................118
Starting your
vehicle ........................261–262, 264
jump starting ..........................312
Steering wheel
controls ....................................121
tilting .......................................109
SYNC..........................................88
T
Third-row power fold seat .......173
Tilt steering wheel ....................109
Tire Pressure Monitoring
System (TPMS)
Roadside Emergencies ...........302Tires, Wheels and Loading ....241
Warning Displays ................12, 25
Tires ...........................226–228, 302
alignment ................................235
care ..........................................231
changing ..........................302, 307
checking the pressure ............231
inflating ...................................229
label .........................................240
replacing ..........................232, 307
rotating ....................................235
safety practices .......................234
sidewall information ...............236
snow tires and cables .............246
spare tire .................302, 305–306
terminology .............................228
tire grades ...............................227
treadwear ........................227, 231
Towing .......................................254
recreational towing .................260
trailer towing ..........................254
wrecker ....................................318
Transfer case
fluid checking .........................368
Transmission .............................277
brake-shift interlock (BSI) ....276
fluid, checking and adding
(automatic) .............................367
fluid, refill capacities ..............371
lubricant specifications ..........371
Turn signal ................................100
U
Universal garage door
opener ........................................124
USB port ......................................50
Index
389
2010 Mountaineer(mnt)
Owners Guide(own2002), 1st Printing
USA(fus)