Vehicl
emodel Replacement
amou nt with oil fil-
ter E2
00 CGI 60
E2 50 CGI 60 5.5 l
E2
20 CDI 60
E2 50 CDI 60 6.5 l
E3
5061
E3 50 CGI 60
E3 50 CDI 60 8.0 l
E5
00 8.5 l
Lubricant additives
!
Do not mix any lubrican tadditives with
the engin eoil. This could damage the
engine. Damage resultin gfrom th euse of
suc hlubricant additives in the engine oil is
not covered by the Mercedes-Benz implied
warranty.
Engin eoil viscosity Viscosit
ydescribes the flow characteristics
of afluid. If an engin eoil has ahigh viscosity,
this means that it is thick; alow viscosity
means that it is thin.
Selec tthe SA Eclassification (viscosity )ofthe
engine oil accordi ngto the outside tempera-
ture. The followin gtable shows you the vis-
cosity classes to be used depending on the
average air temperature. Brake fluid
G
Risk of accident
The brak efluid constantly absorbs moisture
fro mt he air ;this lower sits boiling point.
If the boiling point of the brake fluid is too low,
vapour pockets may form in the brake system
when the brakes are applied hard (e.g. when
driving downhill). Thi swould impair braking
efficiency.
You should have the brake fluid renewed at
regular intervals. The brake fluid change inter-
val sc an be found in the Service Booklet.
Only use brake fluid approved by Mercedes-
Benz .Information abou tapproved brak eflu-
ids can be obtained from any Mercedes-Benz
Service Centre.
i There is usually anotic eint he engine
compartmen ttoremin dyou when the next
brake fluid change is due.
60 BlueEF FICIENCY
61 Only for certain countries. 316
Service products and capacitiesTechnical data
BA 20
7ECE ÄJ 2010 /1a; 1; 2, en-GB
mkalafa Version: 3.0.2.11 2010-01-26T13:03:22+01:00 -Seite 316
