228CARE AND MAINTENANCE
The engine cooling system is pressurized. If
required, replace the cap with an original
spare part so as not to compromise system ef-
ficiency. Do not remove the cap from the vessel when
the engine is hot: risk of burns.
WINDSCREEN/REAR WINDOW
WASHER FLUID C-fig. 1-2-3
To add fluid, remove the cap, pressing the special tab.
Pour a mixture of water and TUTELA PROFESSIONAL
SC35, in the following concentrations:
30% TUTELA PROFESSIONAL SC35 and 70% water in
summer.
50% TUTELA PROFESSIONAL SC35 and 50% water in
winter.
At temperatures below –20°C, use undiluted TUTELA
PROFESSIONAL SC35 fluid.
Check the level through the reservoir.
Close the cap by pressing its central section.
Do not travel with the windscreen washing
reservoir empty: the windscreen washer is
fundamental to improve visibility.
Some commercial windscreen washer additives are
flammable. The engine compartment contains hot
parts which could start a fire if they come into con-
tact.
BRAKE FLUID D-fig. 1-2-3
Undo the cap and check that the liquid contained in the
tank is at the maximum level. Fluid level in the reservoir
must not exceed the MAX mark. Use the brake fluid shown
in the “Fluids and lubricants” table (see chapter “6”).
NOTE Carefully clean the reservoir cap and the sur-
rounding surface.
When opening the cap, make sure that no dirt gets into
the reservoir.
For topping up always use a funnel with built-in filter
(mesh smaller than or equal to 0.12 mm).
IMPORTANT Brake fluid is hygroscopic (i.e. it absorbs
moisture). For this reason, if the car is mainly used in ar-
eas with a high degree of atmospheric humidity, the flu-
id should be replaced at more frequent intervals than spec-
ified in the “Scheduled Service Plan”.
215-242 Delta 3ed gb 11-11-2009 12:14 Pagina 228
