66GETTING TO KNOW YOUR CAR
Deactivation
Turn the ignition key to STOP.
The next time the vehicle is started (ignition key to MAR),
the sensor is not reactivated even if the lever is still in po-
sition B-fig. 29. To activate the sensor, move the lever to
position A or C and then back to position B.
Rain sensor activation is indicated by at least one wiper
stroke even if the windscreen is dry.
Do not activate the rain sensor when wash-
ing the car in an automatic car wash.
Make sure the device is switched off if there
is ice on the windscreen.
Make sure the device is switched off whenev-
er the windscreen is being cleaned.
fig. 31L0E0022m
CRUISE CONTROL (constant speed
regulator)
(for versions/markets, where provided)
This is an electronically controlled driving aid, which al-
lows you to drive at speeds of over 30 km/h on long and
straight dry roads (e.g.: motorways), at a constant speed,
without pressing the accelerator pedal.
It is not recommended for use on extra-urban roads with
traffic. Do not use it in town.
ENGAGING THE DEVICE
Turn selector wheel A-fig. 31 to ON.
The device may only be engaged in 4th or higher speeds.
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 66
GETTING TO KNOW YOUR CAR67
1
When travelling downhill with the device engaged, the car
speed may exceed the memorised one.
The engagement of the device is signalled by the Üwarn-
ing light lighting up in the instrument panel (together with
a message shown on the display) (see “Instrument panel
warning lights” in chapter 1).
MEMORISING VEHICLE SPEED
Proceed as follows:
❍turn selector wheel A-fig. 31 to ON and press the ac-
celerator until the vehicle reaches the desired speed;
❍turn selector wheel B to (+) for at least three seconds
and then release it: the car speed will be memorised
and the accelerator pedal may be released.
If required (e.g. for overtaking), press the accelerator ped-
al to accelerate: the car will return to the previously set
speed when the pedal is released.
RESTORING MEMORISED SPEED
If the device has been disengaged, for example by press-
ing the brake or clutch pedal, the memorised speed can
be reset as follows:
❍accelerate gradually until you reach a speed ap-
proaching the one memorised;
❍engage the gear selected at the time of speed memo-
rising (4th, 5th or 6th gear);
❍press button C-fig. 31.INCREASING THE MEMORISED SPEED
This can be carried out in two ways:
❍by pressing the accelerator and then memorising the
new speed reached;
or
❍by temporarily turning selector wheel B-fig. 31 to (+).
Each movement of the selector wheel will correspond to
a slight increase in speed (about 1 km/h), while keeping
the selector wheel turned will correspond to a continuous
speed increase.
REDUCING THE MEMORISED SPEED
This can be carried out in two ways:
❍by disengaging the device and then memorising the
new speed;
or
❍by keeping selector wheel B-fig. 31 turned to (–) un-
til the new speed is reached; it will then be memorised
automatically.
Each movement of the selector wheel will correspond to
a slight reduction in speed (about 1 km/h), while keep-
ing the selector wheel turned will correspond to a contin-
uous reduction in speed.
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 67
68GETTING TO KNOW YOUR CAR
DISENGAGING THE DEVICE
Turn selector wheel A-fig. 31 to OFF or turn the ignition
key to STOP. In addition, the device is automatically dis-
engaged in any of the following cases:
❍when the brake or clutch pedal is pressed;
❍if the ASR or Advanced ESP system cuts in (for ver-
sions/markets, where provided).
When travelling with the device engaged, do
not set the gearshift lever to neutral.
In the event of a malfunction or fault, turn se-
lector wheel A-fig. 31 to OFF and contact a
Lancia Dealership after having checked the
condition of the protective fuse.
COURTESY LIGHTS
FRONT COURTESY LIGHT WITH SPOT LIGHTS
fig. 32
Switch A- turns these lights on/off.
With switch A in the central position, lights C and D will
turn on/off when the front doors are opened/closed.
With switch A switched to the left, lights C and D will re-
main off. With switch A switched to the right, lights C and
D will remain on.
The lights turn on/off gradually.
Switch B performs the spot light function; with the light
off, it will turn on:
❍light C if switched to the left;
❍light D if switched to the right.
fig. 32L0E0024m
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 68
70GETTING TO KNOW YOUR CAR
REAR COURTESY LIGHT fig. 33
Press the point indicated by the arrow to switch the lights
on/off (+ sign on the courtesy light lens cover).
The events that determine the lighting up of the front cour-
tesy light also apply to the lighting up of the rear courtesy
light.
LUGGAGE COMPARTMENT LIGHT fig. 34
This light comes on automatically when the luggage com-
partment is opened and switches off when it is closed.
fig. 34L0E0026m
CONTROLS FOR
DUALDRIVE ELECTRIC POWER STEERING
SYSTEM fig. 35
Press button A to activate the “CITY” function (see “elec-
tric power steering system”). When the function is ac-
tive, the message CITY is displayed on the instrument pan-
el. Press the button once again to deactivate the func-
tion.
SPORT FUNCTION CONTROL fig. 35
(for versions/markets, where provided)
Press button B: to activate the sports driving setting. This
is characterised by increased acceleration response and in-
creased force required at the steering wheel to obtain a
more sporty drive.
fig. 35L0E0027m
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 70
94GETTING TO KNOW YOUR CAR
fig. 62L0E0220m
DOUBLE LOAD COMPARTMENT
(MAGIC BACK BOX)
(for versions/markets, where provided)
In addition to reclining seats the car can also be equipped
with an adjustable load platform with two different heights
in order to even the load and adjust the luggage com-
partment capacity.
Keeping the load platform in the upper position makes it
possible for the space created underneath to be used as
another compartment that can be used to store more frag-
ile or smaller objects.
To access the compartment under the load compartment,
lift up shelf A holding it with your hands and put the de-
sired objects inside.
IMPORTANT Movements of the load platform may take
place if it is in a central position in relation to the lugga-
ge compartment.To place shelf A at the level of the floor
(fully lowered) fig. 63:
❍always turn the elements C - Fig. 62 so that they are
always turn the elements C - Fig. 62 so that they are
in a vertical position against the seat backrest;
❍grip the handle B and lift up shelf A by around 45°
(point 1);
❍pull the shelf in a horizontal direction towards itself
until the end of travel position (point 2);
❍push the shelf downwards gently until point 3 is rea-
ched (fully lowered);
❍accompany the shelf to the “fully lowered” position
(point 4).
To move shelf A from the fully lowered position to
the highest position Fig. 64:
❍pull handle B from point 1 and raise shelf A by around
45°;
❍pull the shelf upwards to point 2 and leave it resting
on the side supports D;
❍pull the shelf towards itself as far as point 3 (fully
forwards);
❍let the shelf fall at point 4 in the "fully raised" position.
To extract the spare wheel:
❍pull the load shelf upwards using handle B;
❍lift up the load compartment carpet;
❍extract the tape and hook for the carpet and attach it
to the boot upper seal.
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 94
GETTING TO KNOW YOUR CAR101
1
HEADLIGHT ALIGNMENT ADJUSTMENT
ABROAD
The factory adjustment of the dipped beam headlights de-
pends on the country where the car is purchased. When
you travel in countries with a different driving direction,
it is necessary to cover certain areas of the headlight ac-
cording to the provisions of the Highway Code of the coun-
try you are travelling in to avoid blinding the drivers trav-
elling in the opposite direction.
ADAPTIVE LIGHTS (AFS - Adaptive Xenon Light)
This is a system linked to the Xenon headlights, which
continuously and automatically adjusts the main light
beam and adapts it to the driving conditions when cor-
nering. The system directs the light beam to improve the
illumination of the road, taking into account the vehicle
speed, the cornering angle and the speed at which the
steering wheel is turned.Activating/deactivating the system fig. 68
The adaptive lights are activated automatically when the
vehicle is started. In this situation the LED (amber) on
button A will remain off.
Press button A to deactivate the adaptive lights (if acti-
vated); the LED on button A will light up. To reactivate
the adaptive lights: press button A once again (LED on
button is off).
In the event of a system failure, an indication is provided
on the instrument panel by the flashing of warning light
for the symbol.
fappearing on the display along with
a dedicated message (for versions/markets, where pro-
vided).
fig. 68L0E0055m
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 101
102GETTING TO KNOW YOUR CAR
DST SYSTEM
(Dynamic Steering Torque)
This system is built into the advanced ESP control unit
and provides steering corrections via the electric power
steering during driving. The system applies torque to the
steering wheel, increasing the feeling of safety, maintain-
ing control and reducing the impact of advanced ESP sys-
tem intervention.
Fault signalling
In the event of any operating faults occurring, the sys-
tem switches off automatically and the èwarning light is
lit up on the display together with a dedicated message.
In this case contact a Lancia Dealership.
SPORT FUNCTION
(for versions/markets, where provided)
The vehicle can be equipped with a system that allows you
to choose between two driving modes: normal and sport.
Press the SPORT button fig. 69 to set the sport driving
mode. This is characterised by increased acceleration re-
sponse and increased force required at the steering wheel
to obtain a more sporty drive.
fig. 69L0E0058m
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 102
GETTING TO KNOW YOUR CAR103
1
When the function is active, “S” is displayed on the in-
strument panel. Press the button once again to deacti-
vate the function and return to the standard driving mode.
IMPORTANT The function is activated about 5 seconds
after the SPORT button is pressed.
IMPORTANT The steering may become slightly stiff fol-
lowing parking manoeuvres involving a lot of steering.
This is normal and caused by a system to prevent the mo-
tor from overheating. No servicing is required. The pow-
er steering system will return to normal operation the next
time the car is used.Under no circumstances should after-market
operations be carried out involving steering
system or steering column modifications (e.g.:
installation of anti-theft device). This could nega-
tively affect performance and safety, cause the lapse
of the warranty and also result in vehicle non-com-
pliance with type-approval requirements.
Before servicing the car, switch off the engine
and remove the key from the ignition device to
activate the steering lock. This is especially
important when the car wheels do not touch the
ground. If this is not possible (if the key must be on
MAR or the engine must be running), remove the
main fuse which protects the electric power steering.
On some versions, with the CITY function ac-
tivated, the SPORT function is not available.
To activate the SPORT function, deactivate the
CITY function and vice versa, because they are reci-
procally incompatible.
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 103