2010 JEEP COMMANDER sensor

[x] Cancel search: sensor

Page 310 of 460

JEEP COMMANDER 2010 1.G Owners Manual NOTE:Your system can be set to display pressure units
in PSI, kPa, or BAR.
Should a low tire condition occur on any of the four
active road tire(s), you should stop as soon as possible,
and inflate th

Page 311 of 460

JEEP COMMANDER 2010 1.G Owners Manual If the ignition key is cycled, this sequence will repeat,
providing the system fault still exists. If the system fault
no longer exists, the Tire Pressure Monitoring Telltale
Light will no longer flas

Page 312 of 460

JEEP COMMANDER 2010 1.G Owners Manual received from the TPM Sensors. However, the system still
needs to be serviced as long as theCHECK TPM
SYSTEM message exists.
NOTE:
•If your vehicle is equipped with a matching full-size
spare whee

Page 313 of 460

JEEP COMMANDER 2010 1.G Owners Manual Tire Pressure Monitoring Telltale Light will flash on
and off for 75 seconds and then remain on solid, and
the EVIC will display aCHECK TPM SYSTEM
message for three seconds and then display dashes (

Page 336 of 460

JEEP COMMANDER 2010 1.G Owners Manual Cooling System
To reduce potential for engine and transmission over-
heating, take the following actions:
�City Driving
When stopped for short periods of time, shift the trans-
mission into NEUTRAL an

Page 370 of 460

JEEP COMMANDER 2010 1.G Owners Manual Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
Avoid usi
Page:   < prev 1-10 9-16 17-24 25-32