2010 JEEP COMMANDER hood release

TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released.
1. Pull the release lever inside your vehicle located below
the instrument panel and in front of the driver’s door.
2. Reach under the hood, move safety latch to the left
and lift the hood.
CAUTION!
To prevent possible damage, do not slam the hood to
close it. Use a firm downward push at the center of
the hood to ensure that both latches engage.
Hood Release Handle
Underhood Safety Latch
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 103

NOTE:Use only manufacturer approved A/C System
Sealers, Stop Leak Products, Seal Conditioners, Compres-
sor Oil, and Refrigerants.
Refrigerant Recovery and Recycling
R-134a Air Conditioning Refrigerant is a hydrofluoro-
carbon (HFC) that is endorsed by the Environmental
Protection Agency (EPA) and is an ozone-saving product.
However, the manufacturer recommends that air condi-
tioning service be performed by authorized dealers or
other service facilities using recovery and recycling
equipment.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, sliding doors and hood hinges, should be lubri-
cated periodically with a lithium based grease, such as
MOPAR Spray White Lube or equivalent to assure
quiet, easy operation and to protect against rust and wear. Prior to the application of any lubricant, the parts
concerned should be wiped clean to remove dust and
grit; after lubricating excess oil and grease should be
removed. Particular attention should also be given to
hood latching components to insure proper function.
When performing other underhood services, the hood
latch, release mechanism and safety catch should be
cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant, such as MOPAR
Lock Cylinder Lubricant or equivalent directly into the
lock cylinder.
Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild nonabrasive cleaner to remove accumulations of salt
or road film.
7
MAINTAINING YOUR VEHICLE 369

Heated Seats.......................... 90,91
Heater, Engine Block ..................... 245
High Beam Indicator ..................... 161
High Beam/Low Beam Select (Dimmer) Switch . . 111
Hill Descent Control ..................... 283
Hill Start Assist ......................... 280
Hitches Trailer Towing ........................ 327
Holder, Cup ........................... 145
HomeLink (Garage Door Opener) Transmitter . . . 130
Hood Release .......................... 103
Ignition ............................... 15
Key ............................... 14,15
Ignition Key Removal ..................... 15
Illuminated Entry ........................ 20
Immobilizer (Sentry Key) ................... 17
Infant Restraint ........................ 63,64
Inflation Pressure Tires .................... 295
Information Center, Vehicle ................. 170 Inside Rearview Mirror
.................... 82
Instrument Cluster .................... 159,160
Instrument Panel and Controls .............. 158
Instrument Panel Lens Cleaning ............. 391
Integrated Power Module (Fuses) ............ 398
Interior Appearance Care .................. 390
Interior Fuses .......................... 392
Interior Lighting ........................ 111
Interior Lights ....................... 109,111
Intermittent Wipers (Delay Wipers) ........... 114
Introduction ............................. 4
Inverter, Power ......................... 143
Jack Location ........................... 344
Jack Operation ....................... 343,346
Jacking Instructions ...................... 346
Jump Starting .......................... 351
Key, Programming ........................ 18
Key, Replacement ........................ 18
10
INDEX 449