2010 FIAT PUNTO EVO engine light

222
F0U0286mfig. 208
ENGINE COOLANT fig. 208
The coolant level should be checked when the engine is
cold and should be between the MIN and MAX lines on
the reservoir.
If the level is low, slowly pour a mixture of 50% distilled
water and 50% PARAFLU
UP(made by PETRONAS
LUBRICANTS) through the filler neck A until the level ap-
proaches MAX.
A 50-50 mixture of PARAFLU
UPand distilled water gives
freeze protection up to –35°C.
When the vehicle is used in particularly harsh weather con-
ditions, we recommend using a 60-40 mixture of
PARAFLU
UPand distilled water.
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
The used engine oil and the replaced oil fil-
ter contain substances that are harmful to
the environment. It is advisable to have oil
and filters changed by a Fiat Dealership, where they
will be disposed of properly and in accordance with
the law.PARAFLUUPanti-freeze is used in the en-
gine cooling system. Use the same fluid as
in the cooling system when topping up.
PARAFLU
UPshould not be mixed with any other
type of fluid. If this accidentally occurs, do not start
the engine and contact a Fiat Dealership.
211-234 PUNTO FL EN 4ed 18-01-2010 12:27 Pagina 222

223
F0U0287mfig. 209
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
The engine cooling system is pressurized.
If the cap needs replacing, do so with an-
other original or the effectiveness of the system
may be compromised. Do not remove the cap
from the reservoir when the engine is hot: you may
get burned
WARNING
WINDSCREEN/REAR WINDOW WASHER/
HEADLIGHT WASHER FLUID fig. 209
To top up, remove the cap A.
Pour in a mixture of water and TUTELA PROFESSION-
AL SC35 liquid, in the following concentrations:
30% TUTELA PROFESSIONAL SC35 and 70% water in
summer.
50% TUTELA PROFESSIONAL SC35 and 50% water in
winter.
At temperatures below –20°C, use undiluted TUTELA
PROFESSIONAL SC35 fluid.
Check the level through the reservoir.
Do not travel if the windscreen washer
reservoir is empty: using the windscreen
washer is essential for improving visibility.
WARNING
Some commercial additives for wind-
screen washing are flammable. The en-
gine compartment contains hot parts which could
cause a fire if they come into contact with these
additives.
WARNING
211-234 PUNTO FL EN 4ed 18-01-2010 12:27 Pagina 223

REPLACING THE BATTERY
If required, replace the battery with an original spare part
with the same specifications.
If a battery with different specifications is fitted, the ser-
vice intervals given in the “Scheduled Servicing Plan” will
no longer be valid.
For battery maintenance, you should therefore refer to
the instructions provided by the battery manufacturer.
226
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
Incorrect assembly of electric and electronic
devices may cause severe damage to your
car. Go to a Fiat Dealership if you want to
install accessories (alarms, mobile phone, etc.): they
will suggest the most suitable devices and advise you
if a higher capacity battery needs to be installed.
Batteries contain substances that are very
harmful to the environment. It is advisable
to have the battery changed by a Fiat Deal-
ership, where it will be disposed of properly and in
accordance with the law.
If the vehicle must remain unused for
a long time at very low temperatures, re-
move the battery and take it to a warm place to
avoid freezing.
WARNING
If you have to perform any operation on
the battery or near it, always protect your
eyes with special goggles.
WARNING
USEFUL ADVICE FOR EXTENDING
THE LIFE OF YOUR BATTERY
To avoid draining your battery and make it last longer, fol-
low these instructions closely:
❒when you park the car, ensure that the doors, boot and
bonnet are closed properly to prevent the ceiling cour-
tesy lights from staying on;
❒turn off the ceiling lights, although the car does have
an automatic system for switching off internal lights;
❒do not leave devices (e.g. sound system, hazard lights,
etc.) switched on for a long time when the engine is not
running;
❒before performing any operation on the electrical sys-
tem, disconnect the negative battery cable;
❒ make sure battery terminals are fully tightened.
211-234 PUNTO FL EN 4ed 18-01-2010 12:28 Pagina 226

227
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
IMPORTANT If the battery remains with the charge be-
low 50% for a long time it becomes damaged through sul-
phation and its starting capacity is reduced.
The battery will also be more at risk of freezing (this can
happen as early as -10°C). Refer to “Car inactivity” in
“Starting and driving” if the car is left parked for a long
time.
If, after buying the car, you want to install electrical devices
that require a permanent electric supply (alarm, etc.) or
devices that use a lot of electricity, contact a Fiat Dealer-
ship. Their qualified personnel, in addition to suggesting
the most suitable devices from the Lineaccessori Fiat range,
will evaluate the overall electricity consumption, check-
ing whether the car’s electrical system is capable of with-
standing the load required, or whether it should be inte-
grated with a more powerful battery.
Since these devices continue to consume energy even
when the engine is switched off, they gradually run down
the battery.WHEELS AND TYRES
Check the pressure of each tyre, including the spare, every
two weeks and before long journeys. The pressure should
be checked with the tyre rested and cold.
It is normal for the pressure to increase when the car is used;
for the correct tyre inflation pressure, see “Wheels” in the
“Technical specifications” section.
Incorrect pressure causes abnormal tyre wear fig. 211:
A normal pressure: tread evenly worn.
B low pressure: tread particularly worn at the edges.
C high pressure: tread particularly worn in the centre.
The tyres must be replaced when the tread is less than
1.6 mm thick. In all cases, follow the laws in force in the coun-
try where you are driving.
IMPORTANT NOTES
❒Where possible, avoid braking suddenly, wheel-spinning
and crashing into kerbs, potholes or other obstacles. Long
distances on uneven roads can damage the tyres;
211-234 PUNTO FL EN 4ed 18-01-2010 12:28 Pagina 227

231
F0U0293mfig. 215
F0U0292mfig. 214
Rear window washer fig. 215
The rear window washer jets are fixed.
The nozzle holder is located above the rear window.KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
BODYWORK
PROTECTION FROM ATMOSPHERIC
AGENTS
The main causes of corrosion are the following:
❒atmospheric pollution;
❒salty air and humidity (coastal areas or hot and humid
climates);
❒seasonal environmental conditions.
The abrasive action of wind-borne atmospheric dust and
sand, as well as mud and gravel raised by other cars is al-
so not to be underestimated.
Fiat used the best manufacturing technologies on your car
to effectively protect the bodywork against corrosion.
These are the most important:
❒painting products and systems which give the car par-
ticular resistance to corrosion and abrasion;
❒use of galvanised (or pre-treated) steel sheets with high
resistance to corrosion;
❒spraying the underbody, engine compartment, wheel-
house internal parts and other elements with highly pro-
tective wax-based products;
❒spraying protective plastic materials in the most exposed
areas: underdoor, inner mudguard parts, edges, etc.;
❒using “open” boxed sections to prevent condensation
and pockets of moisture from triggering rust inside.
211-234 PUNTO FL EN 4ed 18-01-2010 12:28 Pagina 231

233
INTERIOR
Check regularly that water is not trapped under the mats
(due to drops from shoes, umbrellas, etc.), as this could
cause the sheet metal to rust.
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
Detergents cause water pollution. The ve-
hicle should be washed only in areas
equipped for collecting and purifying the
liquids used in the washing process.
Windows
Use specific detergents to clean the windows.
Also use clean cloths to avoid scratching the glass or al-
tering the transparency.
IMPORTANT Wipe the rear window gently with a cloth
in the direction of the filaments to avoid damaging the heat-
ing device.
Engine compartment
Wash the engine compartment thoroughly at the end of
every winter. Be careful not to direct the jet of water on-
to electronic control units. Adequately protect the up-
per air vents to prevent damage to the windscreen wiper
motor. Have this operation performed at a specialised
workshop.
IMPORTANT The washing should take place with the en-
gine cold and the ignition key in the STOP position. After
the wash, make sure that the various protective devices
(e.g. rubber caps and guards) have not been removed or
damaged.
Front headlights
IMPORTANT Never use aromatic substances (e.g. petrol)
or ketenes (e.g. acetone) for cleaning the plastic lenses of the
front headlights.
Never use flammable products, such as
petroleum ether or modified petrol, to
clean inside the car. The electrostatic charges
which are generated by rubbing during cleaning
may cause a fire.
WARNING
Do not keep aerosol cans in the vehicle:
these could explode. Aerosol cans must
not be exposed to temperatures exceeding 50°C.
When the vehicle is exposed to sunlight, the tem-
perature inside can greatly exceed this value.
WARNING
211-234 PUNTO FL EN 4ed 18-01-2010 12:28 Pagina 233

F0U0294mfig. 216
H Maximum authorised weight on rear axle.
I Engine type.
L Bodywork version code.
M Number for spare parts.
N Correct value of smoke coefficient (for diesel engines).
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
235
TECHNICAL SPECIFICATIONS
IDENTIFICATION DATA
We recommend taking note of the identification codes.
The following identification codes are printed and
shown on the plates:
❒Vehicle identification number (VIN) plate.
❒Chassis marking.
❒ Bodywork paint identification plate.
❒Engine marking.
VIN PLATE fig. 216
The plate can be found on the left side of the boot floor
and it bears the following identification data:
B Type-approval number.
C Vehicle type identification code.
D Chassis manufacturing serial number.
E Maximum authorised weight of vehicle fully laden.
F Maximum authorised weight of vehicle fully laden plus
trailer.
G Maximum authorised weight on front axle.
235-258 PUNTO FL EN 4ed 18-01-2010 12:28 Pagina 235

F0U0295mfig. 217F0U0296mfig. 218
ENGINE MARKING
This is printed onto the cylinder block and shows the type
and production serial number. BODYWORK PAINT IDENTIFICATION
PLATE fig. 217
This can be found on the external rear door pillar (left-
hand side) and it bears the following information:
A Paint manufacturer.
B Colour name.
C Fiat colour code.
D Re-spray and touch-up colour code.
CHASSIS MARKING fig. 218
This is printed on the passenger compartment floor,
near the right front seat.
❒vehicle type (ZFA 199000);
❒chassis serial number.
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
236
235-258 PUNTO FL EN 4ed 18-01-2010 12:28 Pagina 236