2010 DODGE VIPER coolant

FLUIDS, LUBRICANTS, AND GENUINE PARTS
Engine
ComponentFluid, Lubricant, or Genuine Part
Engine Coolant MOPARAntifreeze/Coolant 5 Year/100,000 Mile Formula HOAT (Hy-
brid Organic Additive Technology) or equivalent.
Engine Oil For best performance and maximum protection under all types of operat-
ing conditions, the manufacturer only recommends full synthetic engine
oils that meet the requirements of Chrysler Material Standard MS-10725
and are approved to MB 229.3 or MB 229.5. The manufacturer recom-
mends the use of a full synthetic 5W-40 or equivalent engine oil.
Engine Oil Filter MOPAREngine Oil Filter or equivalent.
Spark Plugs RE10PMC5 (Gap 0.050 in [1.27 mm])
Fuel Selection Premium Unleaded 91 Octane Only or Higher
7
MAINTAINING YOUR VEHICLE 261

NOTE:
•IfANY of these apply to you then change your engine
oil every 3,000 miles (5000 km) or three months,
whichever comes first, and follow the maintenance
recommendations in “Maintenance Schedule B” in this
section.
•If ANY of these apply to you, then flush and replace
the engine coolant every 102,000 miles (170 000 km) or
60 months, whichever comes first, and follow the
maintenance recommendations in “Maintenance
Schedule B” in this section.
•Most vehicles are operated under the conditions listed
for “Maintenance Schedule B. Second is “Maintenance Schedule A.” It is for vehicles
that are not operated under any of the conditions listed
under “Maintenance Schedule B.
Use the schedule that best describes your driving condi-
tions. Where time and mileage are listed, follow the
interval that occurs first.
NOTE: Under no circumstances should oil change
intervals exceed 6,000 miles (10 000 km) or six months,
whichever comes first.
CAUTION!
Failure to perform the required maintenance items
may result in damage to the vehicle.
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 265

At Each Stop for Fuel
•Check the engine oil level about five minutes after a
fully warmed engine is shut off. Checking the oil level
while the vehicle is on level ground will improve the
accuracy of the oil level reading. Add oil only when
the level is at or below the ADD or MIN mark.
•Check the windshield washer solvent and add if
required.
Once a Month
•Check tire pressure and look for unusual wear or
damage.
•Inspect the battery, and clean and tighten the terminals
as required.
•Check the fluid levels of the coolant reservoir, brake
master cylinder, power steering, and transmission,
and add as needed.
•Check all lights and all other electrical items for correct
operation.
At Each Oil Change
•Change the engine oil filter.
•Inspect the exhaust system.
NOTE: Also, inspect the exhaust system if you notice a
change in the sound of the exhaust system, or if the
exhaust fumes can be detected inside the vehicle.
•Inspect the brake hoses.
•Inspect the suspension components.
•Lubricate door hinges and check springs.
•Check the engine coolant level, hoses, and clamps.
•Check power steering fluid level.
8
M A I
N T
E
N A
N CE
S
C
H E
D
U L
E
S266 MAINTENANCE SCHEDULES

MAINTENANCE SCHEDULE B
Follow “Maintenance Schedule B” if you usually operate
your vehicle under one or more of the following condi-
tions.
•Day or night temperatures are below 32°F (0°C).
•Stop and go driving.
•Extensive engine idling.
•Driving in dusty conditions.
•Short trips of less than 10 miles (16 km).
•More than 50% of your driving is at sustained high
speeds during hot weather, above 90°F (32°C).NOTE:
•If
ANY of these apply to you, then change your engine
oil every 3,000 miles (5000 km) or three months,
whichever comes first, and follow the maintenance
recommendations in “Maintenance Schedule “B” in
this section.
•If ANY of these apply to you, then flush and replace
the engine coolant every 102,000 miles (170 000 km) or
60 months, whichever comes first, and follow the
maintenance recommendations in “Maintenance
Schedule B” in this section.
8
M A I
N T
E
N A
N CE
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 267

Miles57,000 60,000 63,000 66,000 69,000 72,000
(Kilometers) (95 000) (100 000) (105 000) (110 000) (115 000) (120 000)
Change engine oil and engine oil filter, if not
replaced at 3 months. XXXXX X
Rotate the tires.\b\b XX X
Inspect and replace the air cleaner filter, if
necessary. X
Inspect and replace the PCV valve, if neces-
sary. X
Flush and replace engine coolant at
60 months, if not done at 102,000 miles. X
Inspect and replace the auto tension drive
belt, if necessary.‡ X
Inspect the transmission fluid. X
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 271

Miles93,000 96,000 99,000 102,000 105,000 108,000
(Kilometers) (155 000) (160 000) (165 000) (170 000) (175 000) (180 000)
Change engine oil and engine oil filter, if not
replaced at 3 months. XXXXXX
Rotate the tires.\b\b XXX
Inspect and replace the engine air cleaner fil-
ter, if necessary. X
Replace the spark plugs. X
Replace the ignition cables. X
Flush and replace the engine coolant, if not
replaced at 60 months. X
Inspect and replace the auto tension drive
belt, if necessary.‡ X
Change the transmission fluid. X
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
S274 MAINTENANCE SCHEDULES

Miles111,000 114,000 117,000 120,000
(Kilometers) (185 000) (190 000) (195 000) (200 000)
Change engine oil and engine oil filter, if not replaced at
3 months. XXXX
Rotate the tires.\b\b XX
Inspect and replace the engine air cleaner filter, if necessary. X
Inspect and replace the PCV valve, if necessary. X
Flush and replace the engine coolant, if not replaced at
102,000 months. X
Inspect and replace the auto tension drive belt, if necessary.‡ X
Change the transmission fluid. X
Inspect the brake linings. X
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
S276 MAINTENANCE SCHEDULES

Miles36,000 42,000 48,000 54,000 60,000
(Kilometers) (60 000) (70 000) (80 000) (90 000) (100 000)
[Months] [36] [42] [48] [54] [60]
Change engine oil and engine oil filter. X X X X X
Rotate the tires.\b\b XXXX X
Inspect and replace the engine air cleaner filter, if necessary. X
Inspect and replace the PCV valve, if necessary. X
Flush and replace the engine coolant at 60 months, if not
done at 102,000 miles. X
Inspect and replace the auto tension drive belt, if necessary. X
Change the transmission fluid. X
Inspect the transmission fluid. XX
Inspect the brake linings. XX
Change the rear axle fluid. XX
Change the brake and clutch fluid. X
Change the brake fluid. X
Lubricate the front and rear suspension ball joints. X
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 279