Page 91 of 119
i
86
Turn the bulb holder a quarter turn
and remove it.
Pull the bulb and change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
Amber coloured bulbs, such as
the direction indicators, must be
replaced with bulbs of identical
s p e c i fi c a t i o n a n d c o l o u r .
Direction indicators
Disconnect the headlamp main
connector, pulling the red control.
Remove the plastic protective cover
turning it a quarter turn.
Pull the bulb out and change it. Dipped beam headlamps
Disconnect the headlamp main con-
nector, pulling the red control.
Remove the plastic protective cover
turning it a quarter turn.
Press the connector downwards to
release the bulb.
Pull the bulb out and change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
Sidelamps
Page 92 of 119
!
87
Front foglamp
Slide a hand under the bumper.
Turn the connector a quarter turn
and remove the assembly.
Remove the bulb and change it.
Main beam headlamps
Disconnect the headlamp main
connector, pulling the red control.
Remove the plastic protective cover
turning it a quarter turn.
Move aside the springs to release
the bulb and pull the bulb out.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order. Direction indicator side repeater
Push the repeater forwards and
release it.
Remove the repeater and change it.
Repeaters can be obtained from a
PEUGEOT dealer.
High pressure washing
When using a jet washer on stub-
born dirt, do not persist on the
headlamps, the other lamps and
their surround to avoid damaging
their coating and seals.
Page 101 of 119
!i
95
ECONOMY MODE FUNCTION
After the engine has stopped, with the
key in the accessories position, certain
functions (windscreen wiper, courtesy
lamps, audio equipment, dipped beam
headlamps, etc.) can only be used for
a maximum cumulative duration of ap-
p r o x i m a t e l y fi f t e e n m i n u t e s , t o p r e v e n t
discharging of the battery.
O n c e t h e fi f t e e n m i n u t e s a r e o v e r , t h e
message "Economy mode active" ap-
pears on the multifunction screen and
the active functions are put on standby.
These functions will be reactivated au-
tomatically the next time the vehicle is
used.
To resume the use of these functions
immediately, start the engine and let it
run for a few minutes.
The time available will then be double
the time for which the engine is left run-
ning. However, this time will always be
b e t w e e n fi v e a n d fi f t e e n m i n u t e s .
A fl a t b a t t e r y w i l l p r e v e n t t h e
engine from starting.
TOWING THE VEHICLE
Procedure for having your vehicle
towed.
Towing your vehicle
On the front bumper, unclip the cover
to gain access to the towing eye.
Switch on the hazard warning lamps
on the towed vehicle.
Place the gear lever in neutral. Towing another vehicle
Failure to comply with this special
requirement may result in damage
to certain braking components
and the absence of braking assis-
tance the next time the engine is
started.
