Page 57 of 97
5
55
VISIBILITY
LIGHTING STALK
1. Lamps off
2. Sidelamps
3. Dipped headlamps/
Main beam
headlamps Dipped/Main beam headlamps
Dipped beam headlamps: pull the
stalk.
Main beam headlamps: push the
stalk.
Lighting on audible warning
When the driver's door is opened with
the ignition off, a continuous audible
signal is heard if you have left your
lighting on. Rear foglamp
With the dipped head-
lamps on, selection is
by rotation of ring B for-
wards to switch on and
rearwards to switch off.
The status is displayed by the indicator
lamp in the instrument panel.
In clear weather or in rain,
both day and night, the rear
foglamp is dazzling and its
use is prohibited.
Direction indicators (flashers)
Left: stalk downwards.
Right: stalk upwards.
Headlamp flash
Pull the stalk fully towards you.
Front and rear lamps
Selection is by rotation of ring
A .
Switching to sidelamps does
not switch off the rear foglamp
if it is on.
Do not forget to switch them off when
they are no longer needed.
Page 58 of 97
5
56
VISIBILITY
WINDSCREEN WIPER STALK
When using a car wash,
switch off the ignition and
ensure that the wiper blade
is in the low position. Windscreen wash
Pull the wipers stalk towards you.
Rear wiper and wash-wipe
Turn ring
A to "ON" for a steady
wipe.
Turn it forwards to trigger
the wash during wiping. Rear wash
Ring
A at "OFF" (wiper off).
Turn it towards you to trigger
a wash operation.
Windscreen wiper
MIST Single wipe.
For a single wipe of the windscreen, push the control
upwards then release it.
OFF Off.
INT Intermittent wipe.
LO Normal wipe (moderate rain).
HI Fast wipe (heavy rain).
In winter, you are advised to wait until
the windscreen has been defrosted
fully before operating the windscreen
wiper stalk.
Page 59 of 97
5
57
VISIBILITY
HEADLAMP ADJUSTMENT
To avoid causing a nuisance to
other road users, the height of the
headlamps should be adjusted in
relation to the load in the vehicle.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 4 people.
2. 4 people + maximum authorised
load.
3. Driver + maximum authorised
load.
The initial setting is position "0" . In this position, it comes
on on opening the driver's
door.
The courtesy lamp is deac-
tivated and is permanently
off.
COURTESY LAMP
Permanently on.
Page 60 of 97
6
58
SAFETY
HORN
Press one of the spokes of the steering
wheel.
HAZARD WARNING LAMPS
Press the button, the direction
i n d i c a t o r s fl a s h .
They can operate with the ignition off.
ANTI-LOCK BRAKING SYSTEM (ABS) AND BRAKING SYSTEMS(EBFD AND CSC * )
When the vehicle is being
driven, illumination of this
warning lamp indicates that the
parking brake is still on or has
not been properly released.
When parking on a slope,
direct your wheels towards
the pavement and pull the
parking brake
on
.
PARKING BRAKE
Applying
Pull the parking brake to immobilise
your vehicle.
When changing wheels
(tyres), make sure that these
are approved.
The anti-lock braking system comes
into operation automatically when
there is a risk of wheel lock.
Releasing
Pull on the handle and press the
button to release the parking brake.
* The CSC system is linked with the EBFD on vehicles which are not
fi t t e d w i t h A S R / E S P s y s t e m s .
EMERGENCY BRAKING ASSISTANCE
T h e A B S , i n c o n j u n c t i o n w i t h t h e E B F D
and CSC * braking systems, increases
the stability and manoeuvrability of
your vehicle on braking and provides
improved control, in particular on
poor or slippery road surfaces.
T h e A B S p r e v e n t s w h e e l l o c k i n t h e
event of emergency braking.
The EBFD and CSC * systems provide
full control of the braking pressure wheel
b y w h e e l . A d i s t r i b u t i o n b e t w e e n :
- the front and the rear in the case of the EBFD (Electronic Brake
Force Distribution),
- the left and the right in the case of the CSC * (Cornering Stability
Control).
In an emergency, this system enables
you to reach the optimum braking
pressure more quickly and therefore
reduce the stopping distance.
It is triggered by the speed at which
the brake pedal is pressed. This is
felt by a reduction in the resistance
of the pedal and an increase in the
effectiveness of the braking.
Page 61 of 97
6
58
SAFETY
HORN
Press one of the spokes of the steering
wheel.
HAZARD WARNING LAMPS
Press the button, the direction
i n d i c a t o r s fl a s h .
They can operate with the ignition off.
ANTI-LOCK BRAKING SYSTEM (ABS) AND BRAKING SYSTEMS(EBFD AND CSC * )
When the vehicle is being
driven, illumination of this
warning lamp indicates that the
parking brake is still on or has
not been properly released.
When parking on a slope,
direct your wheels towards
the pavement and pull the
parking brake
on
.
PARKING BRAKE
Applying
Pull the parking brake to immobilise
your vehicle.
When changing wheels
(tyres), make sure that these
are approved.
The anti-lock braking system comes
into operation automatically when
there is a risk of wheel lock.
Releasing
Pull on the handle and press the
button to release the parking brake.
* The CSC system is linked with the EBFD on vehicles which are not
fi t t e d w i t h A S R / E S P s y s t e m s .
EMERGENCY BRAKING ASSISTANCE
T h e A B S , i n c o n j u n c t i o n w i t h t h e E B F D
and CSC * braking systems, increases
the stability and manoeuvrability of
your vehicle on braking and provides
improved control, in particular on
poor or slippery road surfaces.
T h e A B S p r e v e n t s w h e e l l o c k i n t h e
event of emergency braking.
The EBFD and CSC * systems provide
full control of the braking pressure wheel
b y w h e e l . A d i s t r i b u t i o n b e t w e e n :
- the front and the rear in the case of the EBFD (Electronic Brake
Force Distribution),
- the left and the right in the case of the CSC * (Cornering Stability
Control).
In an emergency, this system enables
you to reach the optimum braking
pressure more quickly and therefore
reduce the stopping distance.
It is triggered by the speed at which
the brake pedal is pressed. This is
felt by a reduction in the resistance
of the pedal and an increase in the
effectiveness of the braking.
Page 62 of 97
6
59
SAFETY
When this warning lamp
comes on, it indicates that
t h e r e i s a f a u l t w i t h t h e A B S ,
which could cause a loss of
control of the vehicle when
braking.
Contact a PEUGEOT dealer or a
q u a l i fi e d w o r k s h o p .
When these warn-
ing lamps come on
simultaneously, it in-
dicates that there is a
fault with the braking system or that the
parking brake has not been released
fully, which can cause a loss of control
of the vehicle when braking.
You must stop as soon as it is safe
to do so.
Contact a PEUGEOT dealer or a
q u a l i fi e d w o r k s h o p .
N o r m a l o p e r a t i o n o f t h e A B S
may make itself felt by slight
vibrations of the brake pedal.
In emergency braking,
p r e s s v e r y fi r m l y w i t h o u t
releasing the pressure.
ANTI-SLIP REGULATION (ASR) AND ELECTRONIC STABILITY PROGRAMME (ESP)
Operating check
Operation of the ASR and ESP
systems
When one of these two
systems is operating, this
warning lamp comes on.
If a fault occurs with the
systems, this warning lamp
comes on. T h e A S R / E S P s y s t e m s o f f e r
exceptional safety during
normal driving, but this
should not encourage the
driver to take extra risks or drive at
high speed.
Correct operation of these systems
depends on observation of the
manufacturer’s recommendations
regarding the wheels (tyres and
rims), the braking components and
the electronic components as well
as the repair procedures use by
a P E U G E O T d e a l e r o r q u a l i fi e d
workshop.
A f t e r a n i m p a c t , h a v e t h e s e s y s t e m s
checked by a PEUGEOT dealer or a
q u a l i fi e d w o r k s h o p .
Contact a PEUGEOT dealer or
a q u a l i fi e d w o r k s h o p t o h a v e t h e
systems checked.
These systems are linked and
s u p p l e m e n t t h e A B S .
T h e A S R s y s t e m o p t i m i s e s d r i v e t o
prevent the wheels skidding, by act
ing
on the brakes of the driving wheels
and on the engine. It also allows the
directional stability of the vehicle to
be improved on acceleration.
If there is a variation between the
t r a j e c t o r y f o l l o w e d b y t h e v e h i c l e a n d
that required by the driver, the ESP
system automatically acts on the
brake of one or more wheels and on
the engine to put the vehicle back on
course, within the limits of the laws
of physics.
Page 63 of 97
6
59
SAFETY
When this warning lamp
comes on, it indicates that
t h e r e i s a f a u l t w i t h t h e A B S ,
which could cause a loss of
control of the vehicle when
braking.
Contact a PEUGEOT dealer or a
q u a l i fi e d w o r k s h o p .
When these warn-
ing lamps come on
simultaneously, it in-
dicates that there is a
fault with the braking system or that the
parking brake has not been released
fully, which can cause a loss of control
of the vehicle when braking.
You must stop as soon as it is safe
to do so.
Contact a PEUGEOT dealer or a
q u a l i fi e d w o r k s h o p .
N o r m a l o p e r a t i o n o f t h e A B S
may make itself felt by slight
vibrations of the brake pedal.
In emergency braking,
p r e s s v e r y fi r m l y w i t h o u t
releasing the pressure.
ANTI-SLIP REGULATION (ASR) AND ELECTRONIC STABILITY PROGRAMME (ESP)
Operating check
Operation of the ASR and ESP
systems
When one of these two
systems is operating, this
warning lamp comes on.
If a fault occurs with the
systems, this warning lamp
comes on. T h e A S R / E S P s y s t e m s o f f e r
exceptional safety during
normal driving, but this
should not encourage the
driver to take extra risks or drive at
high speed.
Correct operation of these systems
depends on observation of the
manufacturer’s recommendations
regarding the wheels (tyres and
rims), the braking components and
the electronic components as well
as the repair procedures use by
a P E U G E O T d e a l e r o r q u a l i fi e d
workshop.
A f t e r a n i m p a c t , h a v e t h e s e s y s t e m s
checked by a PEUGEOT dealer or a
q u a l i fi e d w o r k s h o p .
Contact a PEUGEOT dealer or
a q u a l i fi e d w o r k s h o p t o h a v e t h e
systems checked.
These systems are linked and
s u p p l e m e n t t h e A B S .
T h e A S R s y s t e m o p t i m i s e s d r i v e t o
prevent the wheels skidding, by act
ing
on the brakes of the driving wheels
and on the engine. It also allows the
directional stability of the vehicle to
be improved on acceleration.
If there is a variation between the
t r a j e c t o r y f o l l o w e d b y t h e v e h i c l e a n d
that required by the driver, the ESP
system automatically acts on the
brake of one or more wheels and on
the engine to put the vehicle back on
course, within the limits of the laws
of physics.
Page 64 of 97
6
60
SAFETY
SEAT BELTS Pretensioning front seat
belts with force limiter
Safety in the event of front
impacts has been improved
by means of the introduction of
pre
tensioning seat belts with force
limiter for the front seats. Depending
on the force of the impact, the
pretensioning system instantly
tightens the seat belts and pulls them
against the body of the occupants.
The pretensioning seat belts are
active when the ignition is on.
The force limiter reduces the pressure
of the seat belt on the chest of the
occupant, increasing their protection.
3-door
5-door
Rear seat belts
The rear seats are equipped with two
three-point inertia reel seat belts.
You can store the seat belt buckles in
the housing
A .
Fastening/Unfastening the seat
belts
Pull the strap, then insert the buckle
into the stalk.
Check that the seat belt is fastened
correctly by pulling the strap.
To unfasten the seat belts, press the
button on the stalk.
