2010.5 Citroen C4 PICASSO DAG seat adjustment

14
F A M I L I A R I S A T I O N
Adjusting the steering wheel
The steering wheel can be adjusted for
height and reach.
Release the steering wheel by pulling
lever A towards you.
Adjust the position of the steering
wheel then lock it pushing the lever fully
back.

 76 It automatically and progressively chan-
ges between day use and night use.
This operates with the ignition switched
on.
From the driver’s seat, select the door
mirror by moving control 1 to the left or
right, then adjust the door mirror as re-
quired in four directions using control 2 .
Demisting-defrosting of the door mirrors
is linked to that of the rear screen.

 103
 75
For safety reasons, these adjust-
ments must not be carried out whilst
driving.
This additional mirror 1 allows you to
monitor the rear passengers. It can be
tilted to eliminate dazzle. Door mirror foldback
When the vehicle is parked, the door
mirrors can be folded back either man-
ually or automatically.
S I T T I N G C O M F O R T A B L Y
Automatic photochromatic rear
view mirror
Door mirror adjustment

 76
Child surveillance mirror

15
F A M I L I A R I S A T I O N
Front seats
Head restraint

Backrest angle

Seat height adjustment

Lumbar support

Forwards-backwards
adjustment

Armrest Electric adjustments
Manual adjustments

 67

Heated seat control (lo-
cated on the inside of the
front seats)

 66
1. Adjustment of seat height, angle
and forwards-backwards position

2. Adjustment of backrest angle and
lumbar support

3. Driver: storing driving positions
The seats can also be adjusted on a
temporary basis:
- on opening one of the front doors,
- after switching on the ignition.
S I T T I N G C O M F O R T A B L Y

21
F A M I L I A R I S A T I O N
SECOND ROW SEATS
The 3 second-row seats are indepen-
dent of each other and are all the same
width. They can all be adjusted to the
"comfort" position.
Placing a seat in the "comfort"
position
Returning the seat to its original position

 69 Longitudinal adjustment
Lift up control
A , located at the front of
the seat, and adjust the seat into the
desired position.
I N T E R I O R
"Comfort" position

 Pull on strap B .
The backrest reclines and the seat base
pivots slightly.

 Pull on strap B and guide the seat
forwards.

III
55
C O M F O R T
RECOMMENDED SETTINGS FOR VENTILATION, HEATING AND AIR CONDITIONING Air intake
Check that the exterior grille for the
air intake at the bottom of the wind-
screen, is clean and free of dead
leaves, snow, etc.
Air distribution

1. Windscreen demisting/defrosting
vents.

2. Front side windows demisting/
defrosting vents.

3. Adjustable air vents.

4. Adjustable central air vents.

5. Front passenger footwell air out-
lets.

6. Adjustable 2nd row side air
vents, with air fl ow and tempera-
ture adjustment.

7.
Rear passenger footwell air outlets.

8. Adjustable 3rd row side air vents.
The side air vents 8 apply only to the
7-seater versions.

III
56
C O M F O R T
Air conditioning
To ensure that your system operates
correctly, it is recommended that you
have it checked regularly.
Water arising from condensation
in the air conditioning drains away
through a hole provided for this pur-
pose. A pool of water may thus form
under the vehicle when stationary.
To preserve the sealing of the air
conditioning compressor, operate
the air conditioning at least once a
month.
Regardless of the season, the air
conditioning is useful, since it re-
moves humidity and condensation.
To be effective, the air conditioning
should only be used with the win-
dows closed.
If after a lengthy stop in bright sun-
light the interior temperature is
excessive, air the passenger com-
partment by opening the windows
for a few moments, then close them
again.
The air conditioning operates by
using power from the engine. This
results in a slight increase in fuel
consumption.
Dust filter/Odour filter (active
carbon)
There is a fi lter for excluding odours
and dust.
This fi lter has to be changed in
accordance with the vehicle's ser-
vicing schedule (see "Maintenance
and Warranty Guide").
Air circulation
Air vents on the fl oor underneath the
front seats provide enhanced heat-
ing for the rear seat positions; take
care not to obstruct them.
Air vents
The air vents to the face have grilles
and thumbwheels to adjust the air
fl ow and direction (up-down, right-
left).
The automatic regulation of the air
conditioning in the passenger com-
partment uses a number of sensors
(sunshine sensor, ambient tempera-
ture sensor...) that relieve you of the
need to make frequent adjustments
to the displayed temperature.
Take care not to obstruct the sun-
shine sensor, located on the dash-
board behind the instrument panel.
Sensors

III
66
C O M F O R T
FRONT SEATS
MANUAL ADJUSTMENTS
1. Forwards-backwards adjustment
Raise the control bar, then slide the
seat to the position desired. 2. Lumbar support
Rotate the control until you attain
the position desired. 3. Seat height adjustment
Raise or lower the the control the
number of times necessary to obtain
the position desired.
4. Backrest angle
Operate the control and adjust the
angle of the backrest.
It is possible to incline the back-
rest 45° rearwards by tilting it until it
locks; to unlock it, lift the control.
5. Armrest
To adjust the position of the armrest,
pull it up and then fully down, and
then raise it to the desired position.
6. Head restraint
To raise it, pull it upwards. To lower
it, press on the control as well as on
the head restraint.
The adjustment is correct when the
top of the head restraint is level with
the top of the head.
It can also be adjusted for tilt (de-
pending on version).
To remove it, press on the unlocking
button and pull it upwards.
To adjust the head restraint for-
wards/backwards, move the base of
the head restraint to obtain the posi-
tion desired.
Never drive without the head
restraints fi tted. They must be in
place and adjusted correctly.

III
67
C O M F O R T
1. Adjustment of the seat height and angle,
forwards-backwards 2. Adjustment of backrest
angle and lumbar support
The seats can also be adjusted elec-
trically for a short period:
- on opening one of the front doors,
- after switching off the ignition. Heated seats control
ELECTRIC ADJUSTMENTS
Raise or lower the front of
control to raise or lower the
front of the seat base (on
driver’s seat).
Raise or lower the rear of
control to raise or lower the
seat.
Action control forwards or
backwards to slide the seat
forwards/backwards. Push the top of control
forwards or backwards to
adjust the backrest angle.
Raise or lower control to
increase or decrease the
lumbar support.
With the engine running, the front
seats can be heated individually.

 Use the corresponding adjust-
ment wheel, placed on the inner
side of each front seat, to switch
on and select the level of heating
required:
0 : Off.
1 : Low.
2 : Medium.
3 : High.

III
68
C O M F O R T
Storing driving positions
System which memorises the elec-
trical settings of the driver's seat and
door mirrors. It enables you to store
up to two positions using the buttons
on the side of the driver's seat. Storing a position
Using buttons M/1/2

 Switch on the ignition.

 Adjust your seat and the door
mirrors.

 Press button M , then press but-
ton 1 or 2 within four seconds.
An audible signal is heard indi- cating that the position has been
stored.
Storing a new position cancels the
previous position. Recalling a stored position
Ignition on or engine running

 Briefl y press button 1 or 2 to re-
call the corresponding position.
An audible signal is heard indicating
the end of the adjustment.
When the ignition is on, after a few
consecutive position recalls, the
function will be deactivated until the
engine is started, to prevent dis-
charging of the battery.
Vehicle moving

 Press and hold button 1 or 2
until the audible signal is heard
indicating the end of the adjust-
ment.
Do not try to store a driving position
while driving.