2010.5 Citroen C4 PICASSO DAG bonnet
[x] Cancel search: bonnetPage 3 of 355
6
F A M I L I A R I S A T I O N
A. Central locking
B. Unlocking
C. Guide-me-home lighting
D. Key release/storage
Press control A , located on the switch
panel to the left of the dashboard. The
f u e l fl a p a u t o m a t i c a l l y o p e n s u p f u l l y .
Insert the pump nozzle so as to push in
t h e m e t a l fl a p B .
P u s h t h e f u e l fi l l e r fl a p t o c l o s e i t .
After switching off the ignition, con-
trol A is only active for a few minutes.
If necessary, switch on the ignition
again to reactivate it.
Bonnet stay: Unclip the stay and insert
it into the notch.
77 Bonnet opening/closing
To release the bonnet, pull the lever
located under the dashboard towards
you. Then operate the safety catch at
the front of the bonnet,
171
91
Selective opening
Using the multifunction screen, you can
choose from the following options for
opening your vehicle with the remote
control:
- either all of the doors and the tail-
gate,
- o r t h e d r i v e r ’ s d o o r w i t h a fi r s t p r e s s , then all of the other doors with a
second press.
To close: move the stay back to
its initial position, lower the bon-
net, then allow it to slam shut at
the end of its travel.
O P E N I N G
Remote control key Fuel tank
Capacity: approximately 60 litres.
Page 8 of 355
11
F A M I L I A R I S A T I O N
8. Controls:
- Trip mileage recorder reset button
- Lighting rheostat
9. W a r n i n g l a m p s d i s p l a y ( w i t h t h e
MyWay or NaviDrive multifunction
s c r e e n )
10. Electric parking brake
11. Instrument panel
12. Hazard warning lamps
13. Switch panels:
- Emergency or assistance
- Lane departure warning system
14. ESP deactivation button
15. Steering lock - Ignition switch
16. Multifunction screen steering
mounted controls
17. Horn
1. Controls:
- Lighting
- Direction indicators
- Front and rear foglamps
2. Paddles for automatic gearbox or
6-speed electronic gearbox system
3. Cruise control and speed limiter
steering mounted controls
4. Direction indicator warning lamps
5. Audio and telematics system
steering mounted controls
6. Selector for automatic gearbox or
6-speed electronic gearbox system
7. Controls:
- Windscreen wipe
- Screenwash
- Rear screen wipe
- Trip computer
I N S T R U M E N T S A N D C O N T R O L S
18. Optional function controls
( o n s t e e r i n g w h e e l )
19. Fusebox access cover
20. Controls:
- F u e l fi l l e r fl a p
- Front and rear parking sensors
- Stop & Start
- Volumetric alarm deactivation
- H e a d l a m p a d j u s t m e n t
21. Bonnet release
22. Mirror controls
Page 24 of 355
27
F A M I L I A R I S A T I O N
D R I V I N G
Stop & Start
Engine going into STOP mode The "ECO" warning lamp comes
on in the instrument panel and
the engine goes into stand-by:
- with the 6-speed electronic gear-
box system ; at speeds below
4 m p h ( 6 k m / h ) , p r e s s t h e b r a k e
pedal or put the gear lever into neu-
t r a l ( p o s i t i o n N) .
In certain circumstances the STOP
mode may not be available; the "ECO"
w a r n i n g l a m p fl a s h e s f o r a f e w s e c o n d s
then goes off.
150 The
"ECO" warning lamp goes
off and the engine restarts:
- with the gear lever in position A or M ,
release the brake pedal,
- or with the gear lever in position N and
the brake pedal released, change to
position A or M ,
- or select reverse gear.
In certain condition, START mode may
be invoked automatically; the "ECO"
w a r n i n g l a m p fl a s h e s t h e n g o e s o f f .
151 Deactivation/Reactivation
You can deactivate the system at any
time by pressing the
"ECO OFF" button;
the button's warning lamp comes on.
The system is reactivated automati-
cally every time you start the engine
with the key. Before refuelling or doing any-
thing under the bonnet, you
must switch off the ignition
with the key.
151
Going into engine START mode
Page 32 of 355
I
36M O N I T O R I N G
Warning lamps
When the engine is running or the vehicle is being driven,
the switching on of one of the following warning lamps indicates
a fault which requires action on the part of the driver.
Any fault resulting in the switching on of a warning lamp must be investigated further by reading the associated message
on the multifunction screen.
If you encounter any problems, do not hesitate to contact a CITROËN dealer.
Warning lamp is on Cause Action/Observations
STOP fi x e d , a s s o c i a t e d
with another
warning lamp. It is associated with a
punctured tyre or the engine
coolant temperature. Stop as soon as it is safe to do so.
Park, switch off the ignition and call a
CITROËN dealer.
Service temporarily.
A minor fault has occurred
f o r w h i c h t h e r e i s n o s p e c i fi c
warning lamp. Identify the fault by reading the message
shown on the screen, such as, for
example:
- the closing of the doors, boot, rear
screen or bonnet,
- the remote control battery,
- the tyre pressures,
- s a t u r a t i o n o f t h e p a r t i c l e e m i s s i o n fi l t e r (Diesel).
For any other faults, contact a CITROËN
dealer.
fi x e d . A m a j o r f a u l t h a s o c c u r r e d
f o r w h i c h t h e r e i s n o s p e c i fi c
warning lamp. Identify the fault by reading the message
shown on the screen and contact a
CITROËN dealer.
Page 88 of 355
IV
83
A C C E S S
ALARM
System which protects and provides
a deterrent against theft and break-
ins. It provides the following types of
monitoring.
- Exterior perimeter
The system checks for opening of
the vehicle.
The alarm is triggered if anyone tries
to open a door, the boot, the bonnet...
- Interior volumetric
The system checks for any variation
in the volume in the passenger com-
partment.
The alarm is triggered if anyone
breaks a window, enters the pas-
senger compartment or moves in-
side the vehicle.
Self-protection function
The system checks for the putting
out of service of its components.
The alarm is triggered if the battery,
the central control or the wires of
the siren are put out of service or
damaged. Locking the vehicle with full
alarm system
Activation
Switch off the ignition and get out
of the vehicle.
Press the locking button on the
remote control. Deactivation
Press the unlocking button on
the remote control.
The alarm system is deactivated:
the indicator lamp on the button
switches off.
If an opening (door, boot...) is not
closed fully, the vehicle is not locked
but the exterior perimeter monitor-
ing will be activated after a delay of
45 seconds at the same time as the
interior volumetric monitoring.
The monitoring system is active: the
i n d i c a t o r l a m p o n t h e b u t t o n fl a s h e s
once per second.
After the locking button on the re-
mote control is pressed, the exterior
perimeter monitoring is activated
after a delay of 5 seconds and the
interior volumetric monitoring after a
delay of 45 seconds.
For all work on the alarm system,
contact a CITROËN dealer.
Page 178 of 355
IX
152
D R I V I N G
In the event of a malfunction with
the system, the "ECO OFF" switch
w a r n i n g l a m p fl a s h e s t h e n c o m e s
on continuously.
Have it checked by a CITROËN
dealer.
In the event of a fault in STOP mode,
the vehicle may stall. It is then nec-
essary to switch off the ignition and
start the engine again using the key. Maintenance
Operating fault
Before working under the
bonnet, deactivate the Stop
& Start system to avoid any
r i s k o f i n j u r y r e s u l t i n g f r o m a u t o -
matic operation of START mode.
This system requires a battery with
a s p e c i a l s p e c i fi c a t i o n a n d t e c h n o l o g y
(reference numbers available from
C I T R O Ë N d e a l e r s ) .
Fitting a battery not listed by
CITROËN introduces the risk of
malfunction of the system.
The Stop & Start system makes use of advanced technology.
Specialist knowledge is needed
for any work on the system, which can
only be assured by CITROËN dealers.
Page 196 of 355
XX
171
C H E C K S
BONNET
Opening
At the front of the bonnet, push
the exterior safety catch B to the
left and raise the bonnet.
Unclip the stay C from its housing.
Fix the stay in the notch to hold
the bonnet open. Closing
Take the stay out of the support
notch.
Clip the stay in its housing.
Lower the bonnet then slam it
closed at the end of its travel.
Pull on the bonnet to check that
it is fully closed.
The location of the interior release
lever prevents opening of the bon-
net while the left hand door is
closed.
This operation must only be carried
out when the vehicle is stationary.
Avoid opening the bonnet in strong
winds.
When the engine is hot, take care
when handling the exterior safety
catch and the bonnet stay (risk of
burns).
Open the left hand front door.
Pull the interior release lever A ,
located at the bottom of the door
frame. Before doing anything un-
der the bonnet, switch off
the Stop & Start system
to avoid any risk of injury result-
ing from an automatic change to
START mode.
Page 201 of 355
X
176
C H E C K S
CHECKING LEVELS
Check all of these levels regularly
and top them up if necessary, unless
otherwise indicated.
I f a l e v e l d r o p s s i g n i fi c a n t l y , h a v e t h e
corresponding system checked by a
CITROËN dealer.
Oil level
Engine oil change
Refer to the Maintenance and
Warranty Guide for details of the in-
terval for this operation. O i l s p e c i fi c a t i o n
The oil must correspond to your en-
gine and conform to the manufactur-
er's recommendations.
Brake fluid level
C h a n g i n g t h e fl u i d
Refer to the Maintenance and
Warranty Guide for details of the in-
terval for this operation.
F l u i d s p e c i fi c a t i o n
T h e b r a k e fl u i d m u s t c o n f o r m t o t h e
manufacturer's recommendations
a n d f u l fi l t h e D O T 4 s t a n d a r d s .
Coolant level
Changing the coolant
The coolant does not have to be
changed.
F l u i d s p e c i fi c a t i o n
The coolant must conform to the
manufacturer's recommendations.
The reading will only be
correct if the vehicle is on
level ground and the engine
has been off for more than
1 5 m i n u t e s .
The check is carried out either when
the ignition is switched on using the
oil level indicator on the instrument
panel, or using the dipstick. T h e b r a k e fl u i d l e v e l s h o u l d
be close to the "MAX" mark.
If it is not, check the brake
pad wear.
The coolant level should be
close to the "MAX" mark but
should never exceed it.
When the engine is warm,
the temperature of the coolant is
regulated by the fan. This can oper-
ate with the ignition off.
O n v e h i c l e s w h i c h a r e fi t t e d w i t h
a p a r t i c l e e m i s s i o n fi l t e r , t h e f a n
may operate after the vehicle has
b e e n s w i t c h e d o f f , e v e n i f t h e e n -
gine is cold.
In addition, as the cooling system is
pressurised, wait at least one hour
after switching off the engine before
carrying out any work.
To avoid any risk of scalding, un-
screw the cap by two turns to al-
low the pressure to drop. When the
pressure has dropped, remove the
cap and top up the level.
In order to maintain the re-
liability of the engine and
emission control system,
the use of additives in the engine
oil is prohibited. When working under the
bonnet, take care, as cer-
tain areas of the engine
may be extremely hot (risk
of burns).
Power steering fluid level T h e p o w e r s t e e r i n g fl u i d
level should be close to the
"MAX" mark. Unscrew the
cap, with the engine cold, to
check the level.