2010.5 Citroen C4 PICASSO DAG change time
[x] Cancel search: change timePage 24 of 355
27
F A M I L I A R I S A T I O N
D R I V I N G
Stop & Start
Engine going into STOP mode The "ECO" warning lamp comes
on in the instrument panel and
the engine goes into stand-by:
- with the 6-speed electronic gear-
box system ; at speeds below
4 m p h ( 6 k m / h ) , p r e s s t h e b r a k e
pedal or put the gear lever into neu-
t r a l ( p o s i t i o n N) .
In certain circumstances the STOP
mode may not be available; the "ECO"
w a r n i n g l a m p fl a s h e s f o r a f e w s e c o n d s
then goes off.
150 The
"ECO" warning lamp goes
off and the engine restarts:
- with the gear lever in position A or M ,
release the brake pedal,
- or with the gear lever in position N and
the brake pedal released, change to
position A or M ,
- or select reverse gear.
In certain condition, START mode may
be invoked automatically; the "ECO"
w a r n i n g l a m p fl a s h e s t h e n g o e s o f f .
151 Deactivation/Reactivation
You can deactivate the system at any
time by pressing the
"ECO OFF" button;
the button's warning lamp comes on.
The system is reactivated automati-
cally every time you start the engine
with the key. Before refuelling or doing any-
thing under the bonnet, you
must switch off the ignition
with the key.
151
Going into engine START mode
Page 40 of 355
I
43
M O N I T O R I N G
Distance recorders
The total and trip distances are dis-
played for thirty seconds when the
ignition is switched off, when the
driver's door is opened and when
the vehicle is locked or unlocked.
Measures the total distance trav-
e l l e d b y t h e v e h i c l e s i n c e i t s fi r s t
registration.
Trip distance recorder
Lighting rheostat
P e r m i t s m a n u a l a d j u s t m e n t o f t h e
brightness of the instruments and
controls in relation to the exterior
brightness. Only operates when the
vehicle lighting is on, with the excep-
tion of the daytime running lamps.
Activation
Press the button to change the
brightness of the instruments
and controls.
When the lighting reaches the
minimum setting, release the
button, then press again to in-
crease it.
or
When the lighting reaches the
maximum setting, release the
button, then press again to re-
duce it.
When the lighting reaches the
level of brightness required, re-
lease the button.
Deactivation
When the vehicle lighting is off, or
i n d a y m o d e o n v e h i c l e s fi t t e d w i t h
daytime running lamps, pressing the
button does not have any effect.
Total distance recorder
Measures a distance travelled since
it was reset to zero by the driver.
With the ignition on, press and
hold this button until zeros ap-
pear.
Page 45 of 355
II
48
M U L T I F U N C T I O N S C R E E N S
Choice of language
You can change the screen dis-
p l a y l a n g u a g e ( D e u t s c h , E n g l i s h ,
E s p a n o l , F r a n ç a i s , I t a l i a n o ,
Nederlands, Portugues, Portugues-
B r a s i l , T ü r k ç e * ) .
* D e p e n d i n g o n d e s t i n a t i o n c o u n t r y .
This menu is used to activate/deac-
tivate the following functions:
- d e fi n e t h e v e h i c l e p a r a m e t e r s ,
- d i s p l a y c o n fi g u r a t i o n ,
- choice of language. D e fi n e t h e v e h i c l e p a r a m e t e r s
You can activate or deactivate the
following systems:
- rear wiper coupled with reverse
g e a r ( r e f e r t o t h e " V i s i b i l t y " s e c -
tion),
- automatic guide-me-home lighting,
- directional headlamps,
- a u t o m a t i c f u n c t i o n s ( a p p l i c a t i o n / r e l e a s e ) o f t h e e l e c t r i c p a r k i n g
b r a k e *
- s e l e c t i v e d o o r l o c k i n g ,
- d a y t i m e r u n n i n g l a m p s ( r e f e r t o t h e " V i s i b i l t y " s e c t i o n ) ,
D i s p l a y c o n fi g u r a t i o n
Y o u c a n m a k e t h e f o l l o w i n g a d j u s t -
ments:
- video brightness,
- date and time,
- choice of units.
Personalisation -
Configuration
Page 52 of 355
II
54
M U L T I F U N C T I O N S C R E E N S
A few definitions… Range
( m i l e s o r k m )
This value may vary following a
change in the style of driving or
t h e r e l i e f , r e s u l t i n g i n a s i g n i fi c a n t
change in the current fuel con-
sumption.
W h e n t h e r a n g e f a l l s b e l o w 2 0 m i l e s
( 3 0 k m ) , d a s h e s a r e d i s p l a y e d . A f t e r
fi l l i n g w i t h a t l e a s t 5 l i t r e s o f f u e l ,
the range is recalculated and is dis-
p l a y e d w h e n i t e x c e e d s 6 0 m i l e s
( 1 0 0 k m ) .
If dashes are displayed continu-
ously while driving in place of the
digits, contact a CITROËN dealer.
This indicates the distance which
can still be travelled with the fuel re-
m a i n i n g i n t h e t a n k i n r e l a t i o n t o t h e
average fuel consumption over the
l a s t f e w m i l e s ( k i l o m e t r e s ) t r a v e l l e d .
Current fuel consumption
( m p g o r l / 1 0 0 k m o r k m / l )
A v e r a g e f u e l
consumption
( m p g o r l / 1 0 0 k m o r k m / l )
This is the average fuel consump-
tion since the last trip computer zero
reset.
A v e r a g e s p e e d
( m p h o r k m / h )
This is the average speed calculat-
ed since the last trip computer zero
r e s e t ( i g n i t i o n o n ) . D i s t a n c e t r a v e l l e d
( m i l e s o r k m )
This indicates the distance travelled
since the last trip computer zero
reset.
Distance remaining to
destination
( m i l e s o r k m )
This is the distance remaining to be
t r a v e l l e d t o t h e fi n a l d e s t i n a t i o n . I t
is either calculated instantly by the
navigation system, if guidance is ac-
tivated, or entered by the user.
If the distance is not entered, dashes
are displayed in place of the digits.
This function is only displayed from
2 0 m p h ( 3 0 k m / h ) .
This is the average fuel consump-
tion during the last few seconds.
I f y o u r v e h i c l e i s fi t t e d w i t h S t o p &
Start, a time counter calculates the
time spent in STOP mode during a
journey.
It resets to zero every time the igni-
t i o n i s s w i t c h e d o n w i t h t h e k e y . Stop & Start time counter
( m i n u t e s / s e c o n d s o r h o u r s /
minutes)
Page 65 of 355
III
65
C O M F O R T
The recharge for the air freshener
consists of a cartridge B and its
sealed container C .
R e m o v e t h e p r o t e c t i v e fi l m D .
Place the head of the cartridge B
on the button A of the air fresh-
ener.
Rotate it a quarter turn to lock
it on the button and remove the
container.
Insert the air freshener into its
housing.
You can change cartridges at any
time, keeping the used cartridges in
their original containers. The air freshener button
A is inde-
pendent of the cartridge. Cartridges
are supplied without the air freshen-
er button A .
The button of the air freshener A
c a n o n l y b e fi t t e d t o t h e c e n t r e o f
the dashboard with a cartridge at-
tached.
Therefore always keep the air fresh-
ener button A and one cartridge.
Recharges are available, depending
on country, either on the Internet site
or from a CITROËN dealer.
Locations are provided in the glove
box for storing cartridges and con-
tainers.
Replacing a cartridge Air freshener button
For safety, use only cartridges that
are provided for this purpose.
Retain the containers for storing
used cartridges.
Do not attempt to take cartridges
apart.
Never recharge the cartridges
with fragrances not supplied by
CITROËN.
Keep them out of reach of children
and animals.
Avoid all contact with the skin and
with the eyes.
In the event of ingestion, consult a
doctor and show them the product
packaging or label.
Do not install or remove a cartridge
while you are driving.
Page 174 of 355
IX
148
D R I V I N G
Operation in manual mode
Move the selector lever
to position M .
Steering mounted paddle controls
The steering mounted paddles are
used for the six forward gears. Changing gear
Pull the " + " paddle to change up
a gear.
Pull the " - " paddle to change
down a gear.
By pulling either of the "
+ " or " - " pad-
dles, you can exercise temporary
control over the gearbox.
The request to change gear will be
taken into account. You will still be
in automatic mode. The warning
lamp A remains on in the instrument
panel.
This function enables you to antici-
pate certain situations such as the
approach of a bend or the need to
overtake another vehicle.
Cancellation of automatic mode
The change from position A (driv-
i n g i n a u t o m a t i c m o d e ) t o p o s i t i o n M
( d r i v i n g i n m a n u a l m o d e ) o r v i c e
versa can be made at any time. The
warning lamp A goes off in the in-
strument panel.
Temporary manual operation
when in automatic mode
Page 181 of 355
IX
155
D R I V I N G
Automatic operation
Move the selector lever
to position D . The gearbox is then operating in
auto-adaptive mode, without requir-
ing any intervention on your part.
For certain manoeuvres (for exam-
p l e o v e r t a k i n g ) , y o u c a n o b t a i n m a x -
imum acceleration by pressing the
accelerator pedal down hard, which
then produces an automatic change
down to a lower gear.
When braking, the gearbox may
change down automatically in order
to provide effective engine braking.
If you lift your foot off the accelerator
abruptly, the gearbox will not change up.
Temporary manual operation
when in automatic mode
The gearbox constantly selects the
gear that is best suited to the follow-
ing conditions:
- driving style,
- r o a d p r o fi l e ,
- vehicle load. At any time, operating the "
+ " or " - "
paddle allows you to exercise tem-
porary control over the gearbox. The
request to change gear will be taken
into account. You will still be in auto-
matic mode. The indicator D remains
on in the instrument panel.
This function enables you to antici-
pate certain situations such as the
approach of a bend or the need to
overtake another vehicle.
Page 182 of 355
IX
156
D R I V I N G
Manual operation
Position of the selector lever for
manual gear changing.
Move the selector lever
to position M .
Pull the " + " paddle to change up
a gear.
Pull the " - " paddle to change
down a gear.
- If the vehicle stops or reduces speed (for example when ap-
p r o a c h i n g a s t o p s i g n ) , t h e g e a r -
box changes down automatically
t o fi r s t g e a r .
- In sequential mode, it is not nec- essary to release the accelerator
during gear changes.
- A request to change gear is ac- cepted only if the engine speed
permits it. - For safety reasons, depending
on the engine speed, a change
up or down may be performed
automatically.
- It is possible at any time to move from position D (driving in auto-
m a t i c m o d e ) t o p o s i t i o n M (driv-
i n g i n s e q u e n t i a l m o d e ) o r v i c e
versa.
Flashing of the indicator for
the position requested sig-
nals that this position is not
yet obtained.
I f t h e i n d i c a t o r i s o n fi x e d , t h e p o s i -
t i o n i s c o n fi r m e d .
Display of a dash in the rev counter
indicates a malfunction. Consult a
CITROËN dealer.
Lighting of the service warning
lamp accompanied by a message
and an audible signal indicates an
operating fault. In this case:
- a marked snatching may be felt when selecting R for reverse
gear,
- the gearbox is locked in one gear,
-
do not exceed a speed of 60 mph
( a p p r o x i m a t e l y 1 0 0 k m / h ) .
Consult a CITROËN dealer.