2010.5 Citroen C3 PICASSO DAG Owner's Manual

!
79
FITTINGS
To avoid any risk of jamming of the
pedals:
- only use mats which are suited to the fi xings already present in
the vehicle; these fi xings must
be used,
- never fi t one mat on top of another.
The use of mats not approved
by CITROËN may interfere with
access to the pedals and hinder
the operation of the cruise control/
speed limiter.
MATS
Removable carpet protection. Refitting
To refi t the mat on the driver's side:

 position the mat correctly,

 refi t the fi xings by pressing,

 check that the mat is secured cor-
rectly.
Fitting
When fi tting the mat for the fi rst time,
on the driver's side use only the fi xings
provided in the wallet attached.
The other mats are simply placed on
the carpet.
Removal
To remove the mat on the driver's side:

 move the seat as far back as
possible,

 unclip the fi xings,

 remove the mat.
TICKET HOLDER
It is located at the top of the dashboard
central panel.
It can be used to hold toll or parking
tickets.

FITTINGS
REAR INTERIOR FITTINGS
They are located on the back of the
front seats.
Two boxes are available, located under
the rear passenger footwells.
To open them, lift the lid using the cut-out. There is a cup holder located at the rear
of the centre console.
Storage boxes Seat pockets Cup holder

!
81
FITTINGS
Lift the catch to release the table and
unfold it.
Aircraft style tables
Reading lamps are built into the back of
the front seats, behind the tables. With
the ignition on, they light up the top of
the table without inconveniencing other
passengers.
They are only accessible if the table is
unfolded.

 Press the button to switch the lamp
on or off.
Individual reading lamps
Do not place hard or heavy objects
on the table. They could become
dangerous projectiles in the event
of sharp braking or impact.
As a safety precaution, if too much
pressure is exerted the table will
fold downwards. Side blinds
Blinds are available for the side
windows.
Pull the side blind longways by the tab
to use it.
Always guide the blind slowly using the
tab.

82
FITTINGS Opening

 Lower the storage shelf.

 Press the fl ap opening control.

 Lower the fl ap.

 Check that the adjustable boot fl oor
is in the high position.

 Lower the fl ap in the bench seat by
pulling at the top.

 Load the objects from inside the
boot.
Ski flap
Device for storing and transporting long
objects.
When unfolded, this provides a storage
area split into 2 sections, completing
the storage spaces available at the rear
of the vehicle.
Storage tray

!
81
FITTINGS
Lift the catch to release the table and
unfold it.
Aircraft style tables
Reading lamps are built into the back of
the front seats, behind the tables. With
the ignition on, they light up the top of
the table without inconveniencing other
passengers.
They are only accessible if the table is
unfolded.

 Press the button to switch the lamp
on or off.
Individual reading lamps
Do not place hard or heavy objects
on the table. They could become
dangerous projectiles in the event
of sharp braking or impact.
As a safety precaution, if too much
pressure is exerted the table will
fold downwards. Side blinds
Blinds are available for the side
windows.
Pull the side blind longways by the tab
to use it.
Always guide the blind slowly using the
tab.

82
FITTINGS Opening

 Lower the storage shelf.

 Press the fl ap opening control.

 Lower the fl ap.

 Check that the adjustable boot fl oor
is in the high position.

 Lower the fl ap in the bench seat by
pulling at the top.

 Load the objects from inside the
boot.
Ski flap
Device for storing and transporting long
objects.
When unfolded, this provides a storage
area split into 2 sections, completing
the storage spaces available at the rear
of the vehicle.
Storage tray

83
FITTINGS
Boot fittings

1. Storage net on right-hand boot trim.

2. Open storage compartments.

3. Torch.

4. Removable boot fl oor.

5. Carrier bag hook

6. Securing rings.

7. Storage area under boot carpet

8. Rear parcel shelf.

i
84
FITTINGS
2-position adjustable boot
The two-position adjustable boot fl oor
allows you to:
- maximise the volume of the boot,
- partition the boot (stowing the rear shelf...),
- obtain a fl at fl oor from the boot open- ing to the front seats, when the rear
bench seat is in the folded and fully
back position. Placing the adjustable boot fl oor in
the low position

 Lift the adjustable boot fl oor by pull-
ing on the strap.

 Move the adjustable boot fl oor rear-
wards and then down, following the
guides on the sides. Placing the adjustable boot fl oor in
the high position

 Lift the adjustable boot fl oor by pull-
ing the strap.

 Move the adjustable boot fl oor rear-
wards then up to its high position.
In the high position, the adjustable boot
fl oor allows stowing of the rear parcel
shelf and fragile objects.
The adjustable boot fl oor is fi tted with
four stowing rings to secure your loads
using the net available as an accessory.
Ensure that your boot is empty be-
fore handling the adjustable boot
fl oor.