2010.5 Citroen C3 low oil pressure
[x] Cancel search: low oil pressurePage 25 of 240
1
MONITORING
Maximum
coolant
temperature fi x e d r e d .
The temperature of the
cooling system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before
topping up the level, if necessary.
If the problem persists, contact a CITROËN
d e a l e r o r q u a l i fi e d w o r k s h o p .
Engine oil
pressure fi x e d . There is a fault with the
engine lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a
C I T R O Ë N d e a l e r o r a q u a l i fi e d w o r k s h o p .
Battery
charge fi x e d . The battery charging circuit
has a fault (dirty or loose
terminals, slack or cut
alternator belt, ...). The warning lamp should go off when the engine
is started.
If it does not go off, contact a CITROËN dealer or
a q u a l i fi e d w o r k s h o p .
Low fuel
level fi x e d . W h e n i t fi r s t c o m e s o n t h e r e
remains
approximately
5 litres of
fuel in the tank. You must refuel as soon as possible to avoid
running out of fuel.
This warning lamp will come on every time the
i g n i t i o n i s s w i t c h e d o n , u n t i l a s u f fi c i e n t a d d i t i o n
of fuel is made.
Fuel tank capacity: approximately 50 litres
(petrol) or 48 litres (Diesel).
Never continue to drive until you run out of fuel
as this could damage the emission control and
injection systems.
Warning lamp is on Cause Action/Observations
Page 140 of 240
1 0
CHECKS
CHECKING LEVELS
Check all of these levels regularly and
top them up if necessary, unless other-
wise indicated.
I f a l e v e l d r o p s s i g n i fi c a n t l y , h a v e t h e
corresponding system checked by a
C I T R O Ë N d e a l e r o r a q u a l i fi e d w o r k -
shop.
Oil level The reading will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 30 minutes.
The check is carried out either when the
ignition is switched on using the oil level
indicator in the instrument panel, or us-
ing the dipstick.
Engine oil change
Refer to the Maintenance and Warranty
Guide for details of the interval for this
operation.
In order to maintain the reliability of the
engine and emission control system,
the use of additives in the engine oil is
prohibited.
Oil grade
The oil must be suitable for your engine
and conform to the manufacturer's rec-
ommendations. Brake fluid level
T h e b r a k e fl u i d l e v e l s h o u l d b e
close to the "MAX" mark. If it is
not, check the brake pad wear.
C h a n g i n g t h e fl u i d
Refer to the Maintenance and Warranty
Guide for details of the interval for this
operation.
F l u i d s p e c i fi c a t i o n
T h e b r a k e fl u i d m u s t c o n f o r m t o t h e
manufacturer's recommendations and
meet the DOT4 standard.
Coolant level The coolant level should be
close to the "MAX" mark but
should never exceed it.
When the engine is warm, the
temperature of the coolant is regulated
by the fan. This can operate with the ig-
nition off.
O n v e h i c l e s w h i c h a r e fi t t e d w i t h a p a r -
t i c l e e m i s s i o n fi l t e r , t h e f a n m a y o p e r -
ate after the vehicle has been switched
o f f , e v e n i f t h e e n g i n e i s c o l d .
In addition, as the cooling system is
pressurised, wait at least one hour after
switching off the engine before carrying
out any work. To avoid any risk of scalding, unscrew
the cap by two turns to allow the pres-
sure to drop. When the pressure has
dropped, remove the cap and top up
the level.
Changing the coolant
The coolant does not have to be
changed.
F l u i d s p e c i fi c a t i o n
The coolant must conform to the manu-
facturer's recommendations.
Screenwash fluid level
Top up the level when neces-
sary.
F l u i d s p e c i fi c a t i o n
For optimum cleaning and to avoid
f r e e z i n g , t h i s fl u i d m u s t n o t b e t o p p e d
up or replaced with water.
Take care when carrying out
checks under the bonnet as
some parts of the engine can be
v e r y h o t ( r i s k o f b u r n s ) .
Page 143 of 240
1 0
CHECKS
Manual gearbox The gearbox does not re-
quire any maintenance (no oil
c h a n g e ) .
Refer to the Maintenance and
Warranty Guide for the details
of the level checking interval
for this component.
Automatic gearbox
The gearbox does not require any m a i n t e n a n c e ( n o o i l c h a n g e ) .
Refer to the Maintenance and
Warranty Guide for details of the
level checking interval for this
component.
Brake pads Brake wear depends on the
style of driving, particularly in
the case of vehicles used in
town, over short distances. It
may be necessary to have the
condition of the brakes checked, even
between vehicle services.
Unless there is a leak in the system, a
d r o p i n t h e b r a k e fl u i d l e v e l i n d i c a t e s
that the brake pads are worn. Brake disc wear
For information on checking
brake disc wear, contact a
CITROËN dealer or a quali-
fi e d w o r k s h o p .
Manual parking brake
If a loss of effectiveness of this system is noticed, the parking
brake must be checked, even
between two services.
Checking this system must be done by
a C I T R O Ë N d e a l e r o r a q u a l i fi e d w o r k -
shop.
Only use products recommende d
by CITROËN or products of equiv-
a l e n t q u a l i t y a n d s p e c i fi c a t i o n .
In order to optimise the opera-
tion of units as important as the
braking system, CITROËN se-
l e c t s a n d o f f e r s v e r y s p e c i fi c
products.
To avoid damaging the electrical
units, the use of a high pressure
washer in the engine compart-
ment is strictly prohibited .
Particle emission filter (Diesel)
According to your version of instrument
panel, the start of saturation of the par-
t i c l e e m i s s i o n s fi l t e r i s i n d i c a t e d b y :
Following prolonged operation of the vehicle at very low speed or
at idle, you may, in exceptional
circumstances, notice the emis-
sion of water vapour at the ex-
haust on acceleration. This does
not affect the behaviour of the
vehicle or the environment.
-
fi x e d i l l u m i n a t i o n o f t h e p a r -
t i c l e e m i s s i o n s fi l t e r w a r n i n g
lamp, accompanied by an
audible signal and a message
that there is a risk of blockage
o f t h e p a r t i c l e e m i s s i o n s fi l t e r ,
or
- temporary illumination of the service warning lamp,
accompanied by an audible
signal and a message that
there is a risk of blockage of
t h e p a r t i c l e e m i s s i o n s fi l t e r .
A s s o o n a s t h e t r a f fi c c o n d i t i o n s p e r -
m i t , r e g e n e r a t e t h e fi l t e r b y d r i v i n g a t a
s p e e d o f a t l e a s t 4 0 m p h ( 6 0 k m / h ) u n t i l
the warning lamp goes off.
If the warning lamp stays on, refer to the
"Additive level" section. SensoDrive gearbox The gearbox does not require any m a i n t e n a n c e ( n o o i l c h a n g e ) .
Refer to the Maintenance and
Warranty Guide for details of
the checking interval for this
component.