2010.5 Citroen C ZERO Vin

8
Practical information
95
)Slacken the bolts using the wheelbrace.)Place the jack in contact with one of the
two front A or rear B
locations provided
on the underbody, whichever is closest to
the wheel to be changed.
Removing the wheel
) Using the handle, extend the jack until its base plate is in contact with the ground.
Ensure that the centreline of the jack base
plate is directly below the location A or Bused.)
Raise the vehicle until there is sufficientspace between the wheel and the ground.
)
Remove the bolts and store them in a clean place. )
Remove the wheel.

i !
!
Practical information
110





Towing the vehicle
Procedure for having your vehicle towed using fixed mechanical equipment.


To w i ng your vehicle

The towing eye is welded to the body below
the front bumper.) Install the towing bar. )
Start your vehicle ("Ready" lamp on).)
Put the drive selector in position N . )
Release the parking brake.)
Switch on the hazard warning lamps onyour vehicle.)
Have your vehicle towed for no more than 20 miles (30 km) without exceeding a speed of 20 mph (30 km/h)
.


When towing the vehicle with the four wheels on the ground, always use a towing bar.
When towing with only two wheels onthe ground, use professional lifting equipment.


Failure to follow these instructions may cause damage to braking components and the electric motor.









Changing
a wiper blade
Removing a front or rear
wiper blade
)Raise the corresponding wiper arm.)Remove the wiper blade, sliding it towards
the outside.
Fitting a front or rear wiper
blade
)Put the new wiper blade in place and
secure it. )Fold down the wiper arm carefully.



To w i ng another vehicle

Your vehicle cannot be used in any circumstances to tow another vehicle.

!
i
Checks
118
The coolant level should be between
the MIN "L" and MA X "F" marks.
Coolant level
Avoid prolonged contact of used fluids with the skin.
Most of these fluids are harmful tohealth and some are very corrosive.

Do not discard used fluids into sewers or onto the ground.
Take used fluids to a CITROËN dealer or a qualified workshop (France) or toan authorised waste disposal site.
Used products

Rear compartment


Changing the coolant

The coolant does not have to be changed.


Coolant specifi cation

The coolant must conform to the
manufacturer's recommendations.
As the coolin
g system is pressurised, wait at least one hour after switching off the motor and/
or the end of the charge cycle before carryingout any work.
To a v o i d a ny risk of scalding, unscrew the cap by two turns to allow the pressure to drop.
When the pressure has dropped, remove the cap and top up the level.
Ancillaries battery
electrolyte level
Remove the battery protective cover to check
this level
(see § "ancillaries battery").The electrolyte level should be between theMIN "LOWER LEVEL" and MA X "UPPER LEVEL".
If necessary, top up using distilled water byremoving the individual battery caps.

Check the electrolyte level at least onceper month.

9
i
Checks
119










Checks
Unless other wise indicated, check these components in accordance with the ser vicing booklet.
Other wise, have them checked by a CITROËN dealer or a qualified workshop.


Passenger compartment filter

Refer to the ser vicing booklet for
details of the replacement inter vals
f
or this filter.
Depending on the environment (e.g. dusty atmosphere) and the use of the
vehicle (e.g. city driving), replace it twice as often if necessar y.y A dirty passenger compartment filter may have
an adverse effect on the performance of the air conditioning system and generate undesirableodours.
Brake wear depends on the style
o
f driving, par ticularly in the case
of vehicles used in town, over shor t
distances. It ma
y be necessary tohave the condition of the brakes checked, evenbetween vehicle services.
Unless there is a leak in the circuit, a drop in
the brake fluid level indicates that the brake
pads are worn.
Brake pads
Only use products recommended by CITROËN or products of equivalent quality and specifications. In order to optimise the operationof units as impor tant as the braking system, CITROËN selects and offers very specific products.
Parking brake

If a loss of effectiveness of thissystem is noticed, the parking brakemust be checked, even between two services.
This system must be checked by a CITROËN
dealer or a qualified workshop.
Brake disc/drum wear
For information on checking the
brake disc or drum wear, contact
a CITROËN dealer or a qualified
workshop.

Technical data
120
MODEL:MOTOR AND MAIN BATTERY
Model type code:1 N ZK Z Z
Electric motorY4F1
Technology Synchronous with neodymium permanent magnets
Max. power: EU standard
(kW)

49

Max. power speed
(rpm)

2 500 to 8 000

Max. torque: EU standard (Nm)
18 0

Max. torque speed (rpm)

0 to 2 500
Main batteryLithium-Ion
Ener
gy capacity (kWh)

16
Normal charge

Volt age (V)
220

Charging time (*)(**):


- 16 A

- 13 A

- 1
0 A
6 hours
7 hours
9 hours
Fast char
ge
Volt age (V) 330


Charging time (80 % charge) ** 30 minutes

*
Dependin
g on the power supply in the country.
**
Time measured for ambient temperatures between 20 and 25 °C. Range varies according to the exterior climatic conditions, the driver's style o
f driving, the use of electrical equipment, the frequency of normal or fast charges and ageing of the main battery.

10
i
i
Technical data
123














Identifi cation markings
Various visible markings for the identification of your vehicle.
A. Ser vice - Replacement Par ts
identification plate.
This plate is riveted to the underside ofthe bonnet.
Tyre pressures must be checkedwhen the tyres are cold, at least oncea month.

Low tyre pressures increase the
electrical power consumption of your vehicle, which reduces its range. B. Tyre identification label
.This label is affixed to the driver's centre pillar.
It bears the
following information:
- the tyre pressures (in bars),
- the tyre specification,
- the type of tyre.C. Manufacturer's
plate This plate is riveted to the left hand centre pillar.
D. Vehicle identification number (VIN).
This number is is engraved on the inner wheel
arch, inside the boot, right hand side.
For information on fitting snow chains, contact a CITROËN dealer or aqualified workshop.
It bears in par ticular the
following information:


- the vehicle model,

- the paint code,

- the type, variant, version.

1
2
02
1
131
RADIO

Radio text is information transmitted by the radio station related to
the current programme or song.

With the radio displayed on the screen, press MENUthen select "Radio".


Select or deselect "TXT"to activate or deactivate the display of Radio Text.



DISPLAY RADIO TEXT






RECEIVING TA MESSAGES


The TA (Traffi c Announcement) function gives priority to TA alert messages. To operate, this function needs good reception of a
radio station transmitting this type of message. When a traffi c
report is transmitted, the current audio source (Radio, CD,USB, ...) is interrupted automatically to play the TA message.
Normal playback of the audio source resumes at the end of
the transmission of the message.

Pr
ess MENU, select "Radio", then select or deselect "TA"
to activate or deactivate the reception of traffi cmessages.

1
2
1
2
3
04
142
USING THE TELEPHONE
Press MENU , select "Telephone".

Select Call
then "Directory".

An incoming call is announced by a ring and a superimposed display
in the multifunction screen.
Select the desired number and confi rm.
"OK"
to start the call.
Press SRC/TEL
or select "YES"
to
accept the call,
or
select "NO"
to reject the call.


MAKING A CALL -
FROM THE DIRECTORY
RECEIVING A CALL

A long press on ESC
or on SRC/TEL
also rejects an incoming call.