Fuses and light bulbs
242
– Unscrew the securing screw with the aid of the Torx wrench and press the three
catches in direction of arrow
⇒page 241, fig. 204
.
– Remove the plastic lamp holder.– Replace the defective light bulb. – In order to replace a bulb for the brake light, reversing light, rear fog or turn signal
light, turn the fixture of the bulb to the left up to the stop and take the bulb out of the housing or pull the bulb for the parking light out of the fixture
⇒page 241,
fig. 204
.
– Change the bulb, install again the fixture with
the bulb in the housing and turn it to
the right up to the stop or insert it.
– Insert the plastic lamp holder into the
illumination unit until the interlocks are
heard to engage and screw in the securing screw with the aid of the Torx wrench ⇒ page 241, fig. 204
.
– Reconnect the plug connector and insert
the bulb in the original position.
– Screw on the light
⇒page 241, fig. 203
on the left.
Fitting position of the light bulbs in the rear light unit
⇒page 241, fig. 204
- Brake lights - Reversing lights - Rear fog light - Turn signal lights - parking lights
Licence plate light– Unscrew the glass
cover of the light
⇒fig. 205
.
– Take the faulty bulb out of the holder and insert a new one.– Replace the the glass cover of the light and press it down to the stop - ensure that
the glass cover is correctly installed.
– Screw the glass cover tight.
AA
A1A2A3A4A5
Fig. 205 Licence plate light
sgg.6.book Page 242 Thursday, September 24, 2009 2:32 PM
