Fuses and light bulbs
198
Main beam light and low beam lightChange light bulb for main beam light and low beam light – Switch the ignition and all lights off. – Open the bonnet. – Remove the cover of the headlight.– Hold the sprung wire clamp and disconnect the plug . – Unhook the sprung wire clamp by
pressing in direction of the light
bulb and fold it in direction of arrow.
– Remove the light bulb and insert the new light bulb in such a way
that the fixing lugs of the light bulb socket fit into the recesses at the reflector.
– Fold the sprung wire clamp over the
lamp holder and press it until it
locks into the holder.
–Plug in plug. – Insert the cover of the headlight.
Note
Get the headlight setting checked by a specialist garage after replacing the light bulb.Fog lights*Change light bulbs for fog lights – Switch the ignition and all lights off. – Open the bonnet.– Turn the plastic cover of the head
light towards the middle of the
vehicle and remove it.
– Disconnect the plug connector . – Unhook the sprung wire clamp out of the slots of the lamp housing
and fold it down.
– Remove the halogen lamp with cable. Insert the new halogen lamp in
such a way that the fixing lugs on
the reflector lie in the corresponding
recesses in the light socket.
Fig. 182 Change light bulbs for main beam lights and low beam lights
AB
AA
AB
A1
Fig. 183 Change light bulbs for fog lights
ABAA
s2g8.b.book Page 198 Tuesday, April 7, 2009 8:53 AM
Fuses and light bulbs
199
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
– Close the sprung wire clamp over the light socket. Press together the
sprung wire clamp and lock together again.
–Plug in plug. – Insert the plastic cover.
Note
Get the headlight setting checked by a specialist garage after replacing the light bulb.Turn signal light at the frontChanging light bulb for turn signal light (at the front) – Switch the ignition and all lights off. – Open the bonnet.– Unscrew the screw . – Push the lamp out in direction of arrow
⇒
fig. 184
.
– Turn the holder with the light bu
lb to the left and pull it out.
– Press the defective light bulb into the socket, turn to the left and
remove.
– Press a new light bulb into the socket and turn the light bulb to the
right as far as the stop.
– Insert the holder with the light bulb
into the housing of the turn signal
light and turn it to the right up to the stop.
– Push the housing of the turn signal light back in such a way that the
guide lugs lock into the circlips of the main headlight.
– Screw in the screw .Light unit (Octavia)Changing light bulbs in the lamp holder – Switch the ignition and all lights off. – Open the boot lid. – Raise the floor covering.– Press off the catches in the direction of arrow
⇒
fig. 185
and take out
the lamp holder.
Fig. 184 Removing the light bulb for the turn signal light
A1
A1
Fig. 185 Luggage compart-ment: Light bulb holder
s2g8.b.book Page 199 Tuesday, April 7, 2009 8:53 AM
