88C-8
AIR BAG AND PRETENSIONERS
Passenger's frontal airbag: Removal - Refitting
88C
REMOVAL
I - REMOVAL PREPARATION OPERATION
a
aLock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(88C, Airbags and pretensioners).
aDisconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, page 80A-2) .II - OPERATION FOR REMOVAL OF PART
CONCERNED
aOpen the dashboard glovebox.
aUnclip the access flap (1) to the passenger's front
airbag connector.
aRemove:
-the nuts (2) of the tie rod between the bulkhead
and the dashboard cross member, Equipment required
Diagnostic tool
Tightening torquesm
passenger front airbag
nuts21 Nm
nuts of the tie rod side
on the bulkhead side8 Nm
IMPORTANT
Consult the safety and cleanliness advice and ope-
ration recommendations before carrying out any
repair (see 88C, Air bag and Pretensioners, Air-
bag and pretensioners: Precautions for the
repair, page 88C-1) .
IMPORTANT
To avoid any risk of triggering when working on
or near a pyrotechnic component (airbags or pre-
tensioners), lock the airbag computer using the
diagnostic tool.
When this function is activated, all the trigger
lines are inhibited and the airbag warning light on
the instrument panel lights up continuously (igni-
tion on).
IMPORTANT
Never handle the pyrotechnic systems (preten-
sioners or airbags) near to a source of heat or
naked flame - they may be triggered.
119519
K9K – D4F, and 780
127744
