82D-19
MR-413-X44-82D000$500_eng.mif
V1
ACCESS/SAFETY
Fault finding - Function82D
3. Starting
The UCH controls the command and supply part of the start-up function while the start-up-charging process is
controlled by the UCH. For this function to operate normally, the protection function must have been successfully
completed.
To enable the starting command the UCH needs information about the following statuses and parameters:
–ET142 Engine operating phase
–ET239 Ignition switch position
–PR025 "Engine speed"
*Powerlatch: Time required for injection computer supply after + 12 V APC cut-off to the ignition switch.
Extended memory key:
In this case, the UCH sends data to the key at specific times to provide the key with up-to-date application data when
the + after ignition feed is cut off.
The following information can be retrieved on the multiplex line:
–The vehicle identification number.
–If entered by customer services: the customer's contact details.
–The total vehicle mileage.
–The fuel level.
–The mileage before oil service.
The UCH sends this information to the key under the following conditions:
–Every time the vehicle is started.
–Every time the vehicle speed drops below 3 mph (5 km/h) and if 1 mile (2 km) have been travelled since the last
record. IMPORTANT
When the vehicle battery has a low charge, the drop in voltage caused by operating the starter could reactivate
the immobiliser. If the voltage is too low, the engine cannot be started, even by pushing the vehicle.
Note:
If several, i.e. three or four, attempts have been made using a key not allocated to the vehicle, the injection
computer locks. Insert a key allocated to the vehicle for 20 seconds in + after ignition feed, then switch off the
ignition and wait for the end of "powerlatch*" (20 minutes) to allow the injection computer to unlock.
