36B-39
MR-413-X44-36B000$804.mif
V2
POWER – ASSISTED STEERING
Fault finding – Interpretation of parameters36B
EPAS
Vdiag No.: 04
PR121
STEERING WHEEL ANGLE
NOTESNone.
This parameter indicates the position of the steering wheel in relation to zero.
The steering wheel angle programming is performed automatically by the power-assisted steering computer
every time the vehicle is driven.
This parameter is positive to the right and negative to the left.
If the parameter does not correspond to the values indicated in the Conformity check, consult the interpretation
of fault DF038 Angle sensor.
AFTER REPAIRPerform a test using the diagnostic tool.
DAE_V04_PR121
36B-49
MR-413-X44-36B000$938.mif
V2
POWER – ASSISTED STEERING
Fault finding – Fault finding Chart
EPAS
Vdiag No.: 04 - 08
36B
ALP 7 PERMANENT ASSISTANCE
NOTESOnly consult this customer complaint after a complete check with the
diagnostic tool.
Check the conformity of the computer and the steering column (45 or 60 A) in relation to the table below:
Left-hand drive Right-hand drive
Torque sensor wiring harness blue black
Motor wiring 45 A green black
Motor wiring 60 A blue grey
45 A 60 A
ECU label yellow white
In the event of non-conformity, consult RENAULT NET to repair the vehicle according to the technical vehicle
definition.
Check that the configuration reading LC002 Strategy number corresponds to the vehicle equipment.
Configure the computer correctly using the diagnostic tool, if necessary (see Configuration).
Check the pressure and condition of the tyres, the condition of the joints and the front axle geometry.
If the fault is still present, contact Techline.
AFTER REPAIRPerform a test using the diagnostic tool.
DAE_V04_ALP7/ DAE_V08_ALP7
