2009 PONTIAC VIBE light

Arming the System
To arm the system:
1. Close all the doors and the
liftgate.
2. Lock the doors and liftgate with
the key or Remote Keyless
Entry (RKE) transmitter.
The security light comes on solid.
The system automatically arms
after 30 seconds. The security
light ashes when the system
is armed.
No one should be in the vehicle
when the alarm system is armed
because unlocking the vehicle from
the inside activates the system.
To avoid setting off the alarm make
sure all passengers are out of
the vehicle and the windows are
closed before arming the system.
Disarming the System
To disarm the alarm do one of the
following:
Unlock the doors with the key.
Unlock the doors and liftgate with
the RKE transmitter.
Start the engine.
Testing the Alarm
To test the alarm:
1. Open all the windows.
2. Set the system as described
in the previous procedure.
The doors and liftgate should
be locked with the key or RKE
transmitter. Be sure to wait until
the security light starts ashing.
3. Unlock the driver door from the
inside. The system should
activate the alarm.
4. Stop the alarm as described in
the disarming procedure.
5. Repeat this operation for the
other doors. Also, check that
the system is activated when the
battery terminal is disconnected
and then reconnected.If the system does not work
properly, have it checked by your
dealer/retailer.
How the System Alarm is
Activated
The system activates the alarm if:
A locked door or the liftgate is
unlocked or opened without the
RKE transmitter.
A locked door is unlocked or
opened without the key.
The liftgate is unlocked or opened
with the key.
The battery is reconnected.
The side windows are tapped or
broken.
Do not leave the key or device that
disarms or deactivates the theft
deterrent system in the vehicle.
Keys, Doors and Windows 2-11
2009 - Pontiac Vibe Owner Manual

Instruments and
Controls
Instrument Panel
Overview
Instrument Panel
Overview...........................4-2
Hazard Warning Flashers. . . .4-3
Horn...................................4-3
Tilt Wheel...........................4-4
Turn Signal/Multifunction
Lever................................4-4
Cruise Control....................4-4
Turn and Lane-Change
Signals.............................4-7
Headlamp High/
Low-Beam Changer..........4-7
Flash-to-Pass......................4-7
Windshield Wipers..............4-7
Windshield Washer.............4-8
Rear Window Wiper/
Washer.............................4-8
Accessory Power
Outlet(s)............................4-9
Power Outlet 115 Volt
Alternating Current..........4-10
Ashtray(s).........................4-10
Warning Lights, Gages,
and Indicators
Warning Lights, Gages,
and Indicators.................4-11
Instrument Panel Cluster. . .4-12
Speedometer and
Odometer........................4-13
Trip Odometer(s)...............4-13
Tachometer.......................4-13
Safety Belt Reminders......4-14
Airbag Readiness Light.....4-14
Passenger Airbag Status
Indicator..........................4-15
Service Airbag Notication
System Message.............4-16
Charging System Light......4-16
Brake System Warning
Light................................4-17
Antilock Brake System
(ABS) Warning Light.......4-18
Speed Sensitive Power
Steering (SSPS)
Warning Light
..................4-18
Low Tire Pressure
Warning Light..................4-18
Traction Control System
(TCS) Warning Light.......4-19
StabiliTrak®Indicator
Light................................4-19
Engine Coolant
Temperature Gage..........4-19
Malfunction
Indicator Lamp................4-20
Security Light....................4-22
Oil Pressure Light.............4-22
Fog Lamp Light................4-23
Lights On Reminder..........4-23
Taillamp Indicator Light.....4-23
Cruise Control Light..........4-23
Low Washer Fluid
Warning Light..................4-23
Service All-Wheel Drive
Light................................4-24
Highbeam On Light...........4-24
Door Ajar Light.................4-24
Fuel Gage........................4-24
Low Fuel Warning Light. . . .4-25
OnStar®System
OnStar®System................4-25
Instruments and Controls 4-1
2009 - Pontiac Vibe Owner Manual

The main components of the
instrument panel are the following:
A.Outside Power Mirror(s) on
page 2-14.
B.Outlet Adjustment on page 7-3.
C.Turn Signal/Multifunction
Lever on page 4-4.
D.Instrument Panel Cluster on
page 4-12.
E.Windshield Wipers on page 4-7.
F. Passenger Airbag Status
Indicator.Passenger Sensing
System on page 1-28.
Security Light. SeeContent
Theft-Deterrent on page 2-10.
G.Hazard Warning Flashers on
page 4-3.
H.Audio System(s) on page 6-1.
I.Traction Control System (TCS)
on page 8-21.
J.Content Theft-Deterrent on
page 2-10.
K.Driver Storage Compartment
on page 3-3.
L.Hood Release on page 9-5.M.Audio Steering Wheel Controls
on page 6-13.
N.Tilt Wheel on page 4-4.
O.Horn on page 4-3.
P.Cruise Control on page 4-4
(If Equipped).
Q.Ignition Positions on page 8-2.
R. Tire Pressure Reset Button
(Out of View). SeeTire Pressure
Monitor Operation on page 9-50.
S.Power Outlet 115 Volt Alternating
Current on page 4-10On/Off
Button.
T. Cigarette Lighter (If Equipped)
or Accessory Power Outlet.
Ashtray(s) on page 4-10
orAccessory Power Outlet(s)
on page 4-9.
U. Shift Lever.Automatic
Transmission Operation
(Four Speed) on page 8-6or
Automatic Transmission
Operation (Five Speed)
on page 8-8orManual
Transmission Operation
on page 8-11.V.Power Outlet 115 Volt Alternating
Current on page 4-10.
W.Climate Control System on
page 7-1.
X.Hooks on page 3-3
.
Y.Glove Box on page 3-1.
Hazard Warning Flashers
|
(Hazard Warning Flasher):
Press this button located on
the instrument panel, to make the
front and rear turn signal lamps ash
on and off. This warns others that
you are having trouble.
Press
|again to turn the
ashers off.
Horn
Press near or on the horn symbols
on the steering wheel pad to
sound the horn.
Instruments and Controls 4-3
2009 - Pontiac Vibe Owner Manual

{CAUTION
Cruise control can be dangerous
where you cannot drive safely at
a steady speed. So, do not use
the cruise control on winding
roads or in heavy traffic.
Cruise control can be dangerous
on slippery roads. On such roads,
fast changes in tire traction can
cause excessive wheel slip, and
you could lose control. Do not use
cruise control on slippery roads.Setting Cruise Control{CAUTION
If you leave your cruise control on
when you are not using cruise,
you might hit a button and go into
cruise when you do not want to.
You could be startled and even
lose control. Keep the cruise
control switch off until you want to
use cruise control.
1. Press the ON-OFF button at the
end of the lever. The CRUISE
light on the instrument panel
cluster comes on. SeeCruise
Control Light on page 4-23.
2. Get to the desired speed.
3. Move the lever down to−SET
and release it.
4. Take your foot off the accelerator
pedal.If the cruise control indicator light
ashes, press the ON-OFF button
once to deactivate the system, and
then press the button back on.
If the cruise control speed cannot be
set or the cruise control cancels
immediately after being activated,
there may be a problem with the
cruise control system. See your
dealer/retailer.
Resuming a Set Speed
If the brakes are applied after the
cruise control is set, the cruise
control is turned off.
If the vehicle speed is 25 mph
(40 km/h) or greater, push the lever
up to +RES (Resume/Accelerate)
to return to the previously set speed.
Instruments and Controls 4-5
2009 - Pontiac Vibe Owner Manual

Turn and Lane-Change
Signals
An arrow on the instrument panel
cluster ashes in the direction of the
turn or lane change.
Move the lever all the way up or
down to signal a turn.
Raise or lower the lever until the
arrow starts to ash to signal a lane
change. Hold it there until the
lane change is completed.
The lever returns to its starting
position whenever it is released.
If after signaling a turn or a
lane change the arrow ashes
rapidly or does not come on,
a signal bulb may be burned out.
Have the bulbs replaced. If the bulb
is not burned out, check the fuse.
SeeFuses and Circuit Breakers
on page 9-36.
Headlamp High/
Low-Beam Changer
The headlamps must be on for this
feature to work.
Push the turn signal lever away
from you to turn the high beams on.
This instrument panel cluster light
3comes on while the high beam
headlamps are on.
Pull the lever towards you to return
to low beams.
Flash-to-Pass
This feature is used to signal to the
vehicle ahead that you want to pass.
With the lever in the low-beam
position, pull the lever toward you to
momentarily switch to high-beams.
If the headlamps are on when the
lever is released, the high-beams will
return to low-beam.
Windshield Wipers
The windshield wiper/washer lever
is located on the right side of
the steering column.
Move the lever to one of the
following positions:
z(Mist):Move the lever to mist,
for a single wiping cycle and then
release. The wipers stop after
one wipe.
((Off):Move the lever to this
position to turn the wipers off.
Instruments and Controls 4-7
2009 - Pontiac Vibe Owner Manual

Power Outlet 115 Volt
Alternating Current
Electrical equipment with a
maximum limit of 115 VAC can be
plugged into this power outlet. If the
equipment used requires more than
the limit, a protection circuit will
cut the power supply. The power
automatically restarts when
equipment that operates within
the limit is plugged in.
The power outlet is located below
the shift lever.
Before using the outlet, turn on
the ignition and press the button
located on the instrument panel
below the climate control system.An indicator light in the button
comes on. After using the outlet,
press the button again to turn it off.
The power outlet is not designed for
the following electrical equipment
and they may not work properly:
Equipment with high initial peak
wattage: cathode-ray tube type
televisions, compressor-driven
refrigerators, or electric
power tools.
Other equipment requiring an
extremely stable power supply:
microcomputer-controlled
electric blankets, touch sensor
lamps, etc.
Ashtray(s)
For vehicles with a removable
ashtray, it is located in the front
cupholder in the center console
storage area.
Notice:If papers, pins, or other
ammable items are put in
the ashtray, hot cigarettes or
other smoking materials could
ignite them and possibly damage
the vehicle. Never put ammable
items in the ashtray.
For vehicles with a lighter, push
the lighter down and it will pop up
when it is ready to be used.
The ignition switch must be in the
ACC/ACCESSORY or ON/RUN
position to use the lighter.
4-10 Instruments and Controls
2009 - Pontiac Vibe Owner Manual

Notice:Holding a cigarette
lighter in while it is heating does
not let the lighter back away from
the heating element when it is hot.
Damage from overheating can
occur to the lighter or heating
element, or a fuse could be blown.
Do not hold a cigarette lighter in
while it is heating.
It is not recommended to use the
cigarette lighter to plug in auxiliary
electrical equipment. Use the
accessory power outlet for phones
and other electrical equipment.
SeeAccessory Power Outlet(s)
on page 4-9orPower Outlet
115 Volt Alternating Current
on page 4-10.Warning Lights,
Gages, and Indicators
Warning lights and gages can
signal that something is wrong
before it becomes serious enough
to cause an expensive repair or
replacement. Paying attention to the
warning lights and gages could
prevent injury.
Warning lights come on when there
may be or is a problem with one
of the vehicle’s functions. Some
warning lights come on briey when
the engine is started to indicate
they are working.Gages can indicate when there may
be or is a problem with one of the
vehicle’s functions. Often gages and
warning lights work together to
indicate a problem with the vehicle.
When one of the warning lights
comes on and stays on while
driving, or when one of the gages
shows there may be a problem,
check the section that explains what
to do. Follow this manual’s advice.
Waiting to do repairs can be
costly and even dangerous.
Instruments and Controls 4-11
2009 - Pontiac Vibe Owner Manual

Safety Belt Reminders
When the engine is started, a chime
will sound for several seconds to
remind people to fasten their safety
belts, unless the driver safety
belt is already buckled.
The safety belt light will also ash
until the driver belt is buckled. If the
driver belt is already buckled, neither
the chime nor the light comes on.
The vehicle also has a safety belt
reminder light for the right front
passenger position next to the
passenger airbag status indicator.
SeePassenger Airbag Status
Indicator on page 4-15.This light is located on the center of
the instrument panel, next to the
audio system.
When the key is turned to ON/RUN
or START, this light comes on
as a reminder for the right front
passenger to fasten their safety belt.
This light ashes until the right
front passenger safety belt is
buckled. The passenger safety belt
reminder light will not come on if
the right front passenger belt
is already buckled or if a sensor
does not detect the weight of
a passenger in that seat.
If something is placed on the right
front passenger seat, the sensors
in the seat may detect that
object and cause the right front
passenger safety belt reminder
light to come on. If this happens,
remove the object.
Airbag Readiness Light
There is an airbag readiness light
on the instrument panel cluster,
which shows the airbag symbol.
The system checks the airbag’s
electrical system for malfunctions.
The light stays on if there is an
electrical problem. The system
monitors the airbag sensor
assembly, front airbag sensors,
seat-mounted side impact and
roof-mounted airbag sensors, driver
seat position sensor, driver seat
belt buckle switch, right front
occupant sensing system and
indicator light, front passenger
seat belt buckle switch, seat belt
pretensioner assemblies, inators,
interconnecting wiring and power
sources. For more information
on the airbag system, seeAirbag
System on page 1-21.
4-14 Instruments and Controls
2009 - Pontiac Vibe Owner Manual