2009 PONTIAC VIBE ignition

The main components of the
instrument panel are the following:
A.Outside Power Mirror(s) on
page 2-14.
B.Outlet Adjustment on page 7-3.
C.Turn Signal/Multifunction
Lever on page 4-4.
D.Instrument Panel Cluster on
page 4-12.
E.Windshield Wipers on page 4-7.
F. Passenger Airbag Status
Indicator.Passenger Sensing
System on page 1-28.
Security Light. SeeContent
Theft-Deterrent on page 2-10.
G.Hazard Warning Flashers on
page 4-3.
H.Audio System(s) on page 6-1.
I.Traction Control System (TCS)
on page 8-21.
J.Content Theft-Deterrent on
page 2-10.
K.Driver Storage Compartment
on page 3-3.
L.Hood Release on page 9-5.M.Audio Steering Wheel Controls
on page 6-13.
N.Tilt Wheel on page 4-4.
O.Horn on page 4-3.
P.Cruise Control on page 4-4
(If Equipped).
Q.Ignition Positions on page 8-2.
R. Tire Pressure Reset Button
(Out of View). SeeTire Pressure
Monitor Operation on page 9-50.
S.Power Outlet 115 Volt Alternating
Current on page 4-10On/Off
Button.
T. Cigarette Lighter (If Equipped)
or Accessory Power Outlet.
Ashtray(s) on page 4-10
orAccessory Power Outlet(s)
on page 4-9.
U. Shift Lever.Automatic
Transmission Operation
(Four Speed) on page 8-6or
Automatic Transmission
Operation (Five Speed)
on page 8-8orManual
Transmission Operation
on page 8-11.V.Power Outlet 115 Volt Alternating
Current on page 4-10.
W.Climate Control System on
page 7-1.
X.Hooks on page 3-3
.
Y.Glove Box on page 3-1.
Hazard Warning Flashers
|
(Hazard Warning Flasher):
Press this button located on
the instrument panel, to make the
front and rear turn signal lamps ash
on and off. This warns others that
you are having trouble.
Press
|again to turn the
ashers off.
Horn
Press near or on the horn symbols
on the steering wheel pad to
sound the horn.
Instruments and Controls 4-3
2009 - Pontiac Vibe Owner Manual

Increasing Speed While Using
Cruise Control
There are three ways to increase
the vehicle speed:
Use the accelerator pedal to get
to the higher speed. Move the
lever down to−SET. Release the
lever and the accelerator pedal.
Move the cruise lever up
to +RES. Hold it there until the
desired speed is reached,
and then release the lever.
To increase the vehicle speed in
very small amounts, move the
lever to +RES briey and then
release it. Each time this is done,
the vehicle goes about 1 mph
(1.6 km/h) faster.Reducing Speed While Using
Cruise Control
There are two ways to reduce the
vehicle speed while using cruise
control:
Push and hold the lever to−SET
until the desired lower speed is
reached, then release it.
To slow down in very small
amounts, push the lever
down briey. Each time this
is done, the vehicle will go about
1 mph (1.6 km/h) slower.
Passing Another Vehicle While
Using Cruise Control
Use the accelerator pedal to
increase the vehicle speed.
When you take your foot off the
pedal, the vehicle slows down to
the cruise control speed set earlier.
Using Cruise Control on Hills
The cruise control performance will
vary depending upon the vehicle
speed, load, and the steepness of
the hills.When going up steep hills, you might
have to step on the accelerator pedal
to maintain the vehicle speed.
When going downhill, you might
have to brake or shift to a lower gear
to keep the vehicle speed down.
Applying the brake or downshifting
to 2 SECOND or L LOW turns
off the cruise control.
Ending Cruise Control
There are several ways to turn off
the cruise control:
Step on the brake pedal or push
the clutch pedal, if the vehicle
has a manual transmission.
Press the ON-OFF button.
Pull the cruise control lever
toward you.
Erasing Speed Memory
The cruise control set speed memory
is erased when the cruise control or
the ignition is turned off.
4-6 Instruments and Controls
2009 - Pontiac Vibe Owner Manual

{CAUTION
In freezing weather, do not use
your washer until the windshield
is warmed. Otherwise the
washer uid can form ice on the
windshield, blocking your vision.
Accessory Power
Outlet(s)
Accessory power outlets can be
used to plug in auxiliary electrical
equipment.
The vehicle has an accessory
power outlet on the center oor
console below the shift lever.
To use the outlet, the ignition
must be in ON/RUN or
ACC/ACCESSORY. Pull down the
small cover to access the outlet.Notice:Leaving electrical
equipment on for extended
periods will drain the battery.
Always turn off electrical
equipment when not in use and
do not plug in equipment that
exceeds the maximum amperage
rating.
This circuit is protected by a fuse
and has a maximum current level.
Do not use equipment exceeding
the maximum amperage rating.
Certain power accessory plugs may
not be compatible to the power
accessory outlet and could result
in a blown vehicle or adapter
fuse. See your dealer/retailer for
additional information on the power
accessory plugs.Notice:Adding any electrical
equipment to the vehicle can
damage it or keep other
components from working as
they should. The repairs would
not be covered by the vehicle
warranty. Do not use equipment
exceeding maximum amperage
rating of 20 amperes. Check
with your dealer/retailer before
adding electrical equipment.
When adding electrical equipment,
be sure to follow the proper
installation instructions included
with the equipment.
Notice:Improper use of the
power outlet can cause damage
not covered by the warranty.
Do not hang any type of
accessory or accessory bracket
from the plug because the
power outlets are designed for
accessory power plugs only.
Instruments and Controls 4-9
2009 - Pontiac Vibe Owner Manual

Power Outlet 115 Volt
Alternating Current
Electrical equipment with a
maximum limit of 115 VAC can be
plugged into this power outlet. If the
equipment used requires more than
the limit, a protection circuit will
cut the power supply. The power
automatically restarts when
equipment that operates within
the limit is plugged in.
The power outlet is located below
the shift lever.
Before using the outlet, turn on
the ignition and press the button
located on the instrument panel
below the climate control system.An indicator light in the button
comes on. After using the outlet,
press the button again to turn it off.
The power outlet is not designed for
the following electrical equipment
and they may not work properly:
Equipment with high initial peak
wattage: cathode-ray tube type
televisions, compressor-driven
refrigerators, or electric
power tools.
Other equipment requiring an
extremely stable power supply:
microcomputer-controlled
electric blankets, touch sensor
lamps, etc.
Ashtray(s)
For vehicles with a removable
ashtray, it is located in the front
cupholder in the center console
storage area.
Notice:If papers, pins, or other
ammable items are put in
the ashtray, hot cigarettes or
other smoking materials could
ignite them and possibly damage
the vehicle. Never put ammable
items in the ashtray.
For vehicles with a lighter, push
the lighter down and it will pop up
when it is ready to be used.
The ignition switch must be in the
ACC/ACCESSORY or ON/RUN
position to use the lighter.
4-10 Instruments and Controls
2009 - Pontiac Vibe Owner Manual

If, after several seconds, all status
indicator lights remain on, there
may be a problem with the lights or
the passenger sensing system.
See your dealer/retailer for service.
{CAUTION
If the airbag readiness light in the
instrument panel cluster ever
comes on and stays on, it means
that something may be wrong with
the airbag system. If this ever
happens, have the vehicle
serviced promptly, because an
adult-size person sitting in the
right front passenger’s seat may
not have the protection of the
airbag(s). SeeAirbag Readiness
Light on page 4-14for more on
this, including important safety
information.
Service Airbag
Notication System
Message
If the Service Airbag Notication
System message appears on the
radio display, the vehicle may not
be able to provide the Automatic
Notication of Airbag Deployment
feature. SeeOnStar
®System on
page 4-25for information on this
feature. See your dealer/retailer for
service.
Charging System Light
The charging system light comes on
briey when the ignition is turned
on, but the engine is not running,
as a check to show the light is
working. It should go out when the
engine is started.
If the light stays on, or comes on
while driving, there could be a
problem with the electrical charging
system. Have it checked by your
dealer/retailer. Driving while this light
is on could drain the battery.
If a short distance must be driven
with the light on, be sure to turn off
all accessories, such as the
radio and air conditioner.
4-16 Instruments and Controls
2009 - Pontiac Vibe Owner Manual

Brake System Warning
Light
The vehicle’s hydraulic brake
system is divided into two parts.
If one part is not working, the other
part can still work and stop the
vehicle. For good braking both parts
need to be working well.
If the warning light comes on, there
is a brake problem. Have the brake
system inspected right away.
If the vehicle has anti-lock brakes,
this light should come on when
the key is turned to START.If it does not come on, have it
xed so it will be ready to warn if
there is a problem.
When the ignition is on, the brake
system warning light also comes
on when the parking brake is
set. The light will stay on if the
parking brake does not fully release.
If it stays on after the parking
brake is fully released, it means
there is a brake problem.
{CAUTION
The brake system might not be
working properly if the brake
system warning light is on.
Driving with the brake system
warning light on can lead to a
crash. If the light is still on after the
vehicle has been pulled off the
road and carefully stopped, have
the vehicle towed for service.
See Antilock Brake System (ABS)
Warning Light later in this section
andTowing Your Vehicle on
page 9-75.
United States
Canada
Instruments and Controls 4-17
2009 - Pontiac Vibe Owner Manual

Antilock Brake System
(ABS) Warning Light
The ABS warning light comes on
briey when the ignition key is
turned to ON/RUN. This is normal.
If the light does not come on then,
have it xed so it will be ready
to warn you if there is a problem.
If the light stays on, turn the ignition
to LOCK/OFF. If the light comes
on while driving, stop as soon
as possible and turn the ignition off.
Then start the engine again to
reset the system. If the light
still stays on, or comes on again
while driving, the vehicle needs
service. If the regular brake system
warning light is not on, there are
still brakes, but no antilock brakes.If the regular brake system
warning light is also on, there are
no antilock brakes and there is
a problem with the regular brakes.
SeeBrake System Warning Light
on page 4-17.
Speed Sensitive Power
Steering (SSPS)
Warning Light
Vehicles with this feature, have a
warning light that comes on briey
when the ignition is turned to
ON/RUN as a check to show it is
working.
If the warning light does not come
on, have it xed so it will be able to
warn if there is a problem.If the warning light stays on, or
comes on while driving, the Speed
Sensitive Power Steering may
not be working. See your
dealer/retailer for service.
Low Tire Pressure
Warning Light
This light should come on briey as
the engine is started.
If there is a tire with low tire
pressure, the light will stay on or
come back on.
SeeTire Pressure Monitor System
on page 9-48for more information. United States
Canada
4-18 Instruments and Controls
2009 - Pontiac Vibe Owner Manual

Traction Control System
(TCS) Warning Light
This warning light comes on briey
when the ignition is turned to
ON/RUN.
It also comes on when the Traction
Control System is turned off by
pressing the TRAC OFF button.
SeeTraction Control System (TCS)
on page 8-21for more information.
If it stays on or comes on while
driving, there is a problem with the
Traction Control System (TCS),
contact your dealer/retailer.
StabiliTrak®Indicator
Light
This light warns that there is a
problem with the Traction Control
System (TCS) or the Vehicle
Stability Control (VSC) system.
The light comes on when the ignition
is turned to ON/RUN.
If the light comes on while driving,
the system is not working.
The TCS light comes on when the
VSC system warning light comes on,
even if the TRAC OFF button is
not pressed.
SeeStabiliTrak
®System on
page 8-22for more information on
Vehicle Stability Control System.SeeTraction Control System (TCS)
on page 8-21for more information.
Contact your dealer/retailer, if
the light does not come on or if it
stays on.
Engine Coolant
Temperature Gage
This gage shows the engine coolant
temperature. If the gage pointer
moves into the red area, the engine
is too hot. Pull off the road, stop
the vehicle, and turn off the engine
as soon as possible. SeeEngine
Overheating on page 9-22.
United StatesCanada
Instruments and Controls 4-19
2009 - Pontiac Vibe Owner Manual